本文详细论述了基于交流测功机的发动机测控系统的硬件建立与软件设计。
This article in detail discussed the hardware establishment and the software design of the engine controlled and tested system based on the AC dynamometer.
通过陆上整机试验检测控制系统硬件和软件的功能。
The hardware and software functions of control system are tested by the on-land-experiment of whole apparatus.
试验结果表明．试验方法先进可靠．测控系统硬件结构合理．抗干扰能力强；软件设计新颖．功能完备。
The test results show that the hardware of the system has reasonable structure, great capability to resist disturbance, in addition, its software has the new design and full function.
测控系统的硬件采用开放式结构的模块化、标准化机器人控制器，分布式计算机测控系统结构；
The hardware structure of this system adopts modularized standardization robot controller with opening style. It adopts distributing computer measure and control system structure.
由此可以看到虚拟仪器是计算机硬件资源、仪器与测控系统硬件资源和测试软件资源三者的有效结合。
It has virtual faceplate, virtual instrument is an available unites of computer hardware resource, instrument and measure system hardware resource and testing software resource.
低频电磁场电流测控系统包括电流测试和输出控制两个部分，由软件和硬件相互配合组成一个完整的计算机控制系统。
The current measurement and control system in a Low-frequency Magnetic Field is a comprehensive system of hardware and software, including two parts: current measurement and computer control.
本文介绍了一种面向虚拟仪器的分布式网络测控系统。在文中针对该系统总体方案、软硬件组成及系统的功能做了详细的说明。
This paper introduced a distributed measurement and control network system based on virtual instrument. The principle, software and hardware functions of this system are described in detail.
给出了该远程测控系统的硬件原理图及软件主程序流程图。
The hardware principle and software flowchart of the remote measuring and control system are offered.
其中重点阐述了测控系统的设计思想、硬件工作原理及软件框图。
Especially, more attention is paid to design philosophy, operation principle, hardware block diagrams and software flow charts.
介绍了造纸配浆工段的工艺流程、测控系统、以可编程逻辑控制器（PLC）为控制单元的系统结构和硬件设计，同时详细阐述了实现连续配浆的控制算法。
The paper introduces the process of continuous furnish preparation, its measuring and controlling systems, the structure and hardware design of the whole system where the PLC is used as control unit.
本文讨论嵌入式网络测控平台的实现，完成系统的构成以及硬件和软件设计。
This paper discusses the realization of the embedded network platform of measurement and control, the design of finish - systematic composition, hardware and software design.
介绍了热动力环境模拟试验设备的设计，并分析了测控系统硬件、软件结构。
The design of the thermodynamic environment simulation test equipment is introduced and the software and hardware structures of measurement and control system are analyzed.
本文主要介绍了一个多路信号测控系统的硬件结构。
This article mainly introduces the hardware architecture of a multiplex signals tracking system.
分析了ARM微处理器在嵌入式远程测控系统网关中的应用，重点阐述了网关软、硬件的设计方法。
This paper analyzes the application of ARM microprocessor in a gateway of embedded remote measurement and control system, elaborates on the design method about software and hardware of this gateway.
测控系统以工控机作为硬件基础，分为模拟量输入通道和数字量输出通道两部分。
The hardware components of the measurement and control system based on industrial personal computer consist of the analog input channel and the digital output channel.
虚拟仪器是计算机和仪器技术深层次结合的产物，它将计算机硬件资源、仪器与测控系统硬件资源和虚拟仪器软件资源有效结合起来。
The virtual instrument results from technique of electronic measurement and computer. It combined computer hardware, measurement and its hardware, and software of virtual instrument.
本文介绍了一种基于CAN总线的测控系统智能传感器的硬件设计方案。
This article introduces a kind of intelligent sensor node in measuring and controlling system based on CAN bus.
文章重点介绍了基于EPA标准的蓝牙数据采集器的硬件设计与实现、基于EPA标准的蓝牙测控试验系统的组成结构。
The paper mostly introduces the hardware design and realization of bluetooth data collector and structure of bluetooth measure system based on EPA standard.
介绍了具有无线功能的温度湿度测控系统的工作原理、硬件结构设计、试验结果。
The operation principle, the design of hardware structure and the experiment results of a temperature and humidity wireless monitoring system are introduced.
通过对多种干扰耦合方式的分析，提出了相应的干扰抑制方法，讨论了微机测控系统中硬件抗干扰技术措施及软件抗干扰的几种方法。
This article introduces several anti-interference methods based on the analysis to various interferences, and discusses the software and hardware anti-interference technique in the MPU system.
叙述了泄漏测试机测控系统的硬件和软件的实现方法。
It states the ways in which the hardware and the software of the system can be obtained.
介绍了灰色预测控制系统软、硬件的设计；
Then, the design of hardware and software systems of GPC is introduced.
论述了大型变压器油色谱在线监测控制系统的工作原理及硬件、软件的总体设计思想。
This paper introduces the principle and design ideas of hardware and software of the on - line chromatograph monitoring system for transformer oil.
文中介绍了一种具有通用性的基于CAN总线的智能测控单元的设计方法，阐述了系统各部分的硬件结构及相应的芯片功能。
This paper presents an all-purpose design for an intelligent measurement and control unit based on a CAN bus, and describes its hardware structure and chip functions.
本文以内藏液晶显示控制器（T6963C）的液晶显示模块为例，介绍了其在DSP测控系统中与DSP芯片（TMS320C542）的软件和硬件接口形式。
The article takes the LCD module of T6963C controler with built-in LCD for example, presenting its software and hardware interface with DSP(TMS320C542) in DSP application.
结合微型飞行器的特点，测控系统的硬件和软件需要相互配合实现了测控信号到数据的转化、发送和接收。
With the characteristic of the MAV's measure and control system, the hardware and software should operate in coordination to realize the data generation, transmission and receive.
讨论了金刚石压机温度与压力测控系统硬件系统的设计。
Then we argues the hardware design of the embedded control system in Press Producing Artificial Diamond.
阐述了大气数据自动测控系统的硬件和软件设计方法，介绍了该系统的硬件和软件结构及关键技术，分析了系统的特点和功能的实现。
The design method of hardware and software of automatic test system for air data was introduced in this paper and the structure of hardware and software and key technique was also given.
介绍了运用PLC直接控制步进电机系统的软硬件组成，阐述了PLC直接控制步进电机技术在发动机台架试验测控系统中的应用。
This paper introduced the hardware and software constitution of the step-motor direct control system with PLC, and expounded the application in the engine control system in bench test.
介绍了吸附式制冷机组性能测试系统的工作原理、测控系统的硬件与软件结构及主要功能模块的特点。
The working principle of a testing and control system on an adsorption refrigeration unit, structures of hardware and software, and performance of the main model are present.
应用推荐