通过无线节点检测注入信号。
对传统的注入信号检测配电网电容电流的方法进行了改进。
Traditional methods for measuring the capacitive current by injecting signals are improved.
交流注入信号频率本文选择60 Hz，相对与S信号注入法，称为低频交流注入法。
Compared with the injected s signal technique, this method is called low frequency AC signal injection method.
在介绍中性点脉宽注入法原理的基础上，讨论了中性点注入信号和中性点接入电阻的选取方法；
After presenting the principle of neutral point pulse width injection methods, the choosing methods of neutral point injected signal and the neutral point connecting resistance are discussed;
针对介质损耗测量在准确度和抗干扰等方面的不足，提出了一种基于注入信号法的介损测量新方法。
Traditional methods for the measurement of dielectric loss are difficult to meet the requirement of accuracy and anti-interference.
注入信号法是一种效果较好的选线方法，其原理广泛应用于小电流接地系统单相接地故障的自动选线。
The signal injection method is widely used for automatic selecting fault line in indirectly earthed power system, which has great effect in the system of single-phase ground fault.
用含有背散射和饱和效应的双模激光场的理论模型讨论了背散射和外加注入信号对环形激光场的统计性质的影响。
The influence of backscattering and injected signal on the statistical properties of ring lasers is discussed by a full saturation laser theory.
本文列举了适用于谐振接地系统的各类新兴方法。如残流增量法、注入信号寻迹法、行波法、暂态法以及综合选线法。
This paper shows some new methods just like residual flow increment, signal tracking, traveling wave, transient state and complex selection.
研究进一步预示：当激光器气压增大至10倍大气压时，对于同样调谐范围所需的注入信号强度仅比在谱线中心处高出10%左右。
Further study indicates that, when gas pressure is up to 106 Pa, for the same tuning range, the injection intensity is only about 10% higher than the intensity at frequency center.
研究发现，较大的激光器注入电流可以有效地抑制频率啁啾，较高的注入信号光功率则可以在保证高转换信号消光比的同时抑制频率啁啾。
The results show that higher injected current can restrain the frequency chirp effectively, and higher input optical power can also do that, meanwhile, good extinction ratio is ensured.
一个连续性测试器给电缆导线注入交流信号，从而找到电路故障。
A continuity tester injects an AC signal into the conductors of a cable to find circuit faults.
为了获得振幅均衡的有理数谐波锁模脉冲，必须在原有的实验装置中添加一个掺铒光纤放大器(EDFA)以提高注入调制光信号功率。
For obtaining a pulse series with a small amplitude ripple, an Erbium-doped Fiber Amplifier (EDFA) must be added into the primary experiment setup to enhance injection-modulation signal power.
该系统由信号注入装置、无线节点、开关站无线处理单元和智能故障信息处理系统构成。
It is composed of a signal injection device, wireless nodes, a wireless process unit at the switch station and an intelligent fault detection system.
对目前配网采用信号注入法检测单相接地故障的原理进行比较分析。
The principles of using signal injection method to detect single-phase earth fault of distribution network at present are compared and analyzed.
本文在对系统进行适当简化的前提下，采用“扰动信号反馈注入法”建立了系统的小扰动端口特性，为系统的静态稳定性分析奠定了基础。
In this paper, the small signal port characteristics is established by the "perturbation signal feedback injection method", which lays a foundation of the system stability analysis.
本文介绍了一种基于脉动高频电压信号注入法实现面装式永磁同步电机无传感器控制的方法。
A method to implement sensorless control of Surface Mounted PMSM based on fluctuating high frequency voltage signal injection was introduced.
离线校正的方法是现阶段单脉冲雷达系统进行和差通道幅相校正采用的主要方法，它通过注入测试信号的方法来得到对误差接收通道幅相特性的估计。
The former one is now widely used in the monopulse system to calibrate the amplitude and phase imbalances between the sum and difference channels by injecting test signals.
介绍一种降低频率的S注入法信号发生装置。
Based on an s injection method of reducing work frequency, a novel signal generator is developed.
分析了低频信号注入法，并且针对其缺陷提出了基于小波变换的检测方案。
The paper analyzes the method of low frequency signal injection, which is usually used to detect DC system grounding fault, and advances the method based on wavelet transforms.
最后，探讨了旋转、脉动高频电压信号注入法下定子电阻对转子位置估算影响的问题。
Finally, the stator resistance effect of rotor position estimation in high frequency voltage signal injection is investigated.
采样保持电路设计采用了电容下极板采样技术，不仅有效地避免了电荷注入效应引起的采样信号失真，而且消除了时钟馈通效应的不良影响。
The sample and hold circuit is employed by the bottom plate sampling technique, which could not only cancel the charge injection error but also eliminate the effect of clock feed-through.
针对四元红外导引头半实物仿真任务的需要，提出基于“直接信号注入”的动态红外场景生成技术。
To satisfy the need of hardware-in-the-loop simulation of four-element infrared seeker, a method of dynamic infrared scene generation based on "direct signal injection" was proposed.
最后，利用DSP相关软件，对转子初始位置估算方法进行模拟仿真，验证了高频电压信号注入法理论的正确性。
Finally, the paper simulated to the rotor initial point estimate method using DSP related tool and confirmed the accuracy of high frequency voltage signal method.
本文分析了用脉冲法注入示踪剂时示踪剂的分布、时间与应答信号的测量，以及模型参数的回归等方面的种种误差。
The error in experimental determination of RTD derived from tracer pulse injection, digit time and response measurement, and flow model parameter estimation are discussed.
研究了转子位移无传感器检测的两种方法，即小信号注入测试法和差动变压器测试法。
Two methods, which are called as a small test-signal injection and the differential transformer, are studied in order to detect the rotor displacement without sensor.
采用含电机电压模型和电机电感模型的观测器，在低速时注入测试信号，可以得到位置和速度信号。
Position and speed are obtained by an observer using a voltage and an inductance motor model together with test signal injection at low speed.
本文利用半导体激光器良好的调制特性，对其注入电流进行调制，使激光器输出光强随调制信号变化。
Due to the excellent modulation characteristics of laser diode (LD), the infused current of the LD is modulated to make the intensity of the laser beam change with the modulation signal.
研究采用高频注入法的无传感器直接转矩控制系统，通过注入特定的高频信号来追踪电机转子的空间凸极效应，以此得到转子位置和速度值。
In the sensorless control system, a specified high frequency signal is injected in to trace the magnetic anisotropy of the motor, by which we can get the value of rotor speed and position.
论述了采用注入变频信号测量电容电流的原理。
The principle of capacitance current measurement based on the injecting signal is discussed.
论述了采用注入变频信号测量电容电流的原理。
The principle of capacitance current measurement based on the injecting signal is discussed.
应用推荐