对汽化温度、检测温度、气体流速等进行了探讨。
Some conditions, such as vaporization temperature, detection temperature and gas flow rate, etc. were also discussed.
板坯表面增湿处理，能使其中心层到达水分汽化温度的时间最多缩短约一半。
Humidifying treatment in mat surface could shorten a half time when the temperature of core layer reached to water vaporizing temperature at most.
实际上，汽化热与温度有关。
增大剂油比，提高反应温度可以改善原料油的雾化、汽化效果，对改善裂化产物的产品分布有利。
The product distribution could be improved by using higher reaction temperature to improve atomization and gasification of feedstock.
环境温度和液体的汽化潜热对液滴的蒸发速率有着重要的影响。
The environmental temperature and evaporation heat of liquid influence evaporation rate of liquid droplets significantly.
汽化程度与齿面温度及磨损状态有关。
The evaporation is affected by temperature and wearing condition of gear tooth flank.
本文研究了铸膜液溶剂、铸膜温度等铸膜条件及膜厚度对过氯乙烯膜渗透汽化分离乙醇水溶液性能的影响。
In this paper, the effect of solvent and temperature of preparing membrane and the thickness of the membrane on its performance was studied.
进入干汽室的蒸汽处于供汽温度和基本上大气压力下，使任何尚存的水雾再次汽化。
Steam entering the drying chamber is at supply temperature and essentially atmospheric pressure, so any remaining mist is re-evaporated.
预测350种各类物质13117个温度点的汽化热，与文献常用值相比较的总绝对平均误差为2.8％。
The equation was tested for 350 pure substances of 13117 temperature points, the absolute average deviation was 2.8%.
用前向神经网络，对纯物质的蒸气压和汽化热与温度的函数关系进行预测。
A feedforward neural network was used to predict functional relationship of temperature with steam pressure and heat of vaporization of the pure material.
汽化充分，电热盘温度均匀，从而使得蒸汽电熨斗具有蒸汽量输出大小稳定、使用寿命长的优点。
The vaporization is adequate, and temperature of the electric hot tray is uniform, thereby enabling the steam electric iron to have the advantages of stable steam output amount and long service life.
从实验得到了推算页岩油平衡汽化的温度-压力-汽化率的关系相图。
From the experimental results, the phase diagrams, which correlate the temperature, pressure and percentage of vaporization of equilibrium flash vaporization of shale oil, are constructed.
结果通过数值计算，得出活体组织表面汽化速度及内部温度分布。
Result Ablation velocity, coagulation depth and temperature profiles in living tissue were numerically obtained.
通过以水代釉模仿工艺实验，初步证实了造成坯釉爆裂的直接原因是由于坯体施釉后，表层残留水分过多，进窑后遇到高的窑道预热温度，水分汽化速度过快；
The reason of bursting phenomena is that residual water in body skins after application of glaze is far too enough and the evoporization speed is far too fast in high initial heating.
液体温度低于沸点时，发生在液体表面的汽化过程。
Three-dimensional Simulation on Liquid Film Vaporization in the Process of Spray Impingement;
给出了一维空间中激光热损伤的简化近似数学模型，并以此模型为基础计算了金属材料铝、银、铜的温度场分布和熔融阈值与汽化阈值。
The temperature of some metal materials and semiconductor materials have been described, and the melting damage threshold and boiling damage threshold were calculated.
利用排气管温度加热汽化乙醇并通过进气管道供入气缸，与原机进行了性能对比试验。
Diesel engine, which was mixed with ethanol boiled by the preheated exhaust gas pipe and supplied into cylinder via air intake, was compared with the engine fueled only with diesel in this paper.
利用排气管温度加热汽化乙醇并通过进气管道供入气缸，与原机进行了性能对比试验。
Diesel engine, which was mixed with ethanol boiled by the preheated exhaust gas pipe and supplied into cylinder via air intake, was compared with the engine fueled only with diesel in this paper.
应用推荐