随固相体积分数的增加，水基凝胶注模法坯体密度逐渐增加，但强度逐渐降低。
With increasing solid loading, density of AGC green body increases gradually, but strength decreases gradually.
用水基凝胶注法制备出ysz固体电解质薄膜，研究了温度、湿度和坯体厚度对干燥过程的影响规律。
YSZ solid electrolyte film was prepared by aqueous gel casting. The influences of temperature, relative humidity and sample thickness on drying process were studied.
采用水基凝胶流延工艺制备四方多晶氧化锆薄膜，确定合理的烧成制度，并考察薄膜的显微结构与烧结性能。
The present work was to determine the optimum sintering system and properties of the nanometer tetragonal polycrystalline zirconia green body by the aqueous gel tape casting process.
对纳米yTZP(氧化钇稳定)坯片在新型水基凝胶流延成型工艺中，气氛条件对浆料固化过程的影响进行了研究。
The influence of atmosphere condition on solidification procedure of nanometer tetragonal polycrystals zirconia (YTZP) slurry in the AqueousGelTapeCasting process was investigated.
通过水基溶胶-凝胶法合成了粉体颗粒均匀、高分散性、高活性的纳米掺杂剂。
The nano-dopant obtained by water-based sol-gel method was well dispersive and active.
证实了水基料浆注模凝胶法制备高压真空开关管壳是一种新的低成本制备技术，值得推广应用。
Meanwhile experiments prove that aqueous gel-casting is a novel technique of low cost fabrication aproch for high voltage vacuum interrupter housing and it will have wide application in many field.
本文采用水基料浆凝胶注模法制备出了高质量的氧化锆陶瓷刀具。
Zirconia ceramic knives of high qualities ceramic knives were prepared using aqueous gel-casting method in this paper.
本文采用水基料浆凝胶注模法制备出了高质量的氧化锆陶瓷刀具。
Zirconia ceramic knives of high qualities ceramic knives were prepared using aqueous gel-casting method in this paper.
应用推荐