用双探针技术对生成的氧等离子体进行了诊断测量。
The produced oxygen plasma has been measured by double probe technique.
在替换的实施例中，可以使用氧等离子体代替臭氧。
In an alternative implementation, oxygen plasma can be used instead of ozone.
用双探针技术对生成的氧等离子体进行了诊断测量。
The produced oxygen plasma has been measured by double probe technique. The obtained oxygen beam has be...
采用氧等离子体处理可以使金刚石薄膜的表面导电性能消失。
The conductive surface layer could also be removed by oxidation using oxygen plasma treatment.
然后在氧等离子体中用电子束刻蚀法去除沟道区石墨烯形成晶体管的沟道。
They then defined the transistor channel using electron-beam lithography, removing graphene outside of channel regions with an oxygen plasma.
接着这些高能电子与产生的氧等离子体和臭氧将二氧化硫分子氧化。
Secondly molecules of sulfur dioxide are oxidized into sulfur trioxide by those particles, which are including ozone and oxygen plasma.
用低能氧等离子体对电子束热蒸发后的沉积氧化锆薄膜进行了后处理。
ZrO_2 films deposited by electron beam evaporation method are treated by oxygen plasma.
研究了PBO(聚对苯撑苯并双唑)浆粕在氧等离子体不同处理条件下对PBO纸页性能的影响。
The influence of oxygen plasma treatment on the PBO paper properties was studied in this paper.
由于尺度放大，氧等离子体源各组件间会出现失配现象，直接导致系统性能差、能耗高、维护任务重。
Owing to the enlarging of scale, components of plasma source no longer match with each other, resulting in performance descending, high energy cost and more frequent maintenance.
采用低温氧等离子体对纯棉坯布进行处理并退浆，从微观形态分析了氧等离子处理对退浆效果的影响；
The cotton fabrics are treated with low-temperature oxygen plasma and then desized. The influence of the treatment on the desizing effect is analyzed through micromorphology.
超高分子量聚乙烯（UHMW-PE）纤维经过低温氧等离子体处理后，与环氧树脂基体的界面粘结性能明显改善。
The fiber-resin adhesion has been reinforced by plasma treatment on Ultra-high Molecular Weight Polyethylene (UHMW-PE) fibers.
研究结果表明，低温等离子体表面改性处理能够刻蚀牦牛毛纤维表面的鳞片，而且空气等离子体的刻蚀效果优于氧等离子体的刻蚀效果；
The results reflect that treated by low temperature plasma processing the surface squama of yak hair is etched and the effect of air plasma is better than that of oxygen plasma.
本文对比了用氩等离子体和氧等离子体预刻蚀电极的情况，认为在电极表面是否有含氧基团存在对氩等离子体聚合制备修饰电极影响不大。
The effects of etching electrode with argon and oxygen plasmas in advance on the preparation of argon plasma polymerized vinylferrocene film electrode were compared.
经氧等离子体处理后，ITO薄膜的表面粗糙度减小，平整度提高，提高了ITO薄膜表面的润湿性能，改善了有机物在其表面的成膜性能。
It is found that ITO surface roughness decreased after oxygen plasma treatment, which can improve its wetting performance and consequently improve the film performance.
ESCA分析结果显示，经等离子体处理后，有相当量的氧导入了高分子表面。
From the results of ESCA analysis, it was found that a significant amount of oxygen was introduced to the polymer surface by the plasma treatment.
用氧低温等离子体对棉坯布处理，可以使棉坯布从完全的疏水状态，变为具有良好的吸水性，从而使棉织物的前处理简单化。
Treated by O_2 low temperature plasma, the cotton gray can be changed from a totally hydrophobic state to a well hydrophilic state.
利用微波等离子体化学气相沉积方法，以H 2、CH4和八甲基环四硅氧烷(D4)为原料，在硬质合金基体上沉积了金刚石涂层。
Diamond coatings were deposited on cemented carbide substrates with H2, CH4 and D4 as precursors by using microwave plasma chemical vapor deposition technique.
在无氧铜的基体上制备了等离子喷涂钨基涂层以应用于核聚变反应堆中偏滤器部件的面向等离子体材料。比较了不同过渡层对等离子喷涂钨基涂层结合强度的影响。
The plasma sprayed tungsten coatings were prepared on oxygen free copper substrates, which are to be used as the plasma-facing materials of the divergent components in fusion reactors.
在无氧铜的基体上制备了等离子喷涂钨基涂层以应用于核聚变反应堆中偏滤器部件的面向等离子体材料。比较了不同过渡层对等离子喷涂钨基涂层结合强度的影响。
The plasma sprayed tungsten coatings were prepared on oxygen free copper substrates, which are to be used as the plasma-facing materials of the divergent components in fusion reactors.
应用推荐