低氢焊条在焊前应烘干,烘干温度和时间遵照厂家说明。
Low hydrogen type electrode is baked out before welding, the baking temperature and duration as specified by the manufacturer.
解释了水蒸气保护焊焊缝的氢质量分数不高,不出现气孔的原因。
The reason for not high hydrogen content and free porosity in welds with this process is explained.
结果显示,一定的母材厚度和焊后热处理条件,使熔合线附近氢浓度峰值提高,从而使氢剥离倾向增大。
The results show that certain thickness of the base metal and the regime of heat treatment will increase the peak hydrogen concentration and promote the tendency of disbonding.
通过一系列电解充氢试验比较了不同焊后热处理条件对不锈钢堆焊层氢致剥离的影响。
The influence of PWHT conditions on hydrogen-induced disbonding were studied through a series of electrolytic hydrogen charging tests.
镀铝钢板焊接采用熔化极氢弧焊短路过渡方法,使其焊接接头的质量和耐蚀性都得到了提高。
The short circuit transfer of GMAW with argon shieding is used to weld aluminium-plated steel sheets or plates. In the way of this, both joint quality and corrosion resistance can be increased.
试验结果表明,该钢具有焊接冷裂纹倾向低、可用大线能量焊接、焊后不宜进行消氢处理等特点,可用作高强度大焊接线能量用钢。
A new low alloying steel with low susceptibility to weld cold cracking has been developed for large heat input welding in pressure vessel engineering.
试验结果表明,该钢具有焊接冷裂纹倾向低、可用大线能量焊接、焊后不宜进行消氢处理等特点,可用作高强度大焊接线能量用钢。
A new low alloying steel with low susceptibility to weld cold cracking has been developed for large heat input welding in pressure vessel engineering.
应用推荐