在氙气灯内，电流通过一个充满气体的显像管，弯曲成弧形。
This is commonly a xenon lamp, in which electricity is arced through a tube filled with the gas.
所以气体流量一定要与切割电流和速度很好的配合。
So the gas flow must with cutting current and speed very good cooperation.
在这一区域内，阳极位降、阳极位降区厚度主要由放电电流和气体压强所决定。
In this region, its thickness and potential fall are mainly determined by discharge current and gas pressure.
放电管：装有低压气体的封闭绝缘容器，当电极有足够的电压时，通过它电流就开始流动。
Discharge tube: a closed insulating vessel containing a gas at low pressure through which an electric current flows when sufficient voltage is applied to its electrodes.
用压力和电能，所述激光通过使电流通过反应性气体，如氟或氯，和惰性气体，如氪或氩气的混合物产生二聚体。
With pressure and electricity, the laser creates dimers by passing electrical current through mixtures of reactive gases, such as fluorine or chlorine, and inert gases, such as krypton or argon.
当电流通过点火器时，产生的热量会点燃气体发生器中的某种物质。
When electrical current flows through the igniter, it produces heat, which ignites the generant material within the inflator.
在充满氙气的灯柱中的两个电极之间进行火花放电将产生“电离气体管”，电流通过该管流动，从而导致气体发光。
A spark discharge between two electrodes produces an "ionised gas tube" in the xenon gas-filled lamp piston through which electric current flows which in turn causes the gas to light up.
另一是由高能脉冲激光释放电子，记录预放电电子电流波形来确定混合气体的临界电场强度。
And the other is to use the recordings of the electron current waveforms in the gas mixtures studied in a discharge chamber.
实验数据还表明，快速报警响应时间与气体分子浓度和真空计规管灯丝的发射电流密切相关。
The results show that the alarm time depends strongly on both the gas concentration and the emission current of the ionization gauge.
试验结果表明，在回路电感值不变的条件下，焊接电流、电弧电压和气体流量是影响熔敷效率的主要因素。
Testing results show that the major factors affecting the deposition efficiency are the welding current, arc voltage and gas flow rate under the condition of same circuit inductance.
本文利用收集气体、测定腐蚀电流和模拟电池放电等方法来选择和检验缓蚀剂。
Corrosion inhibitors were selected and tested by method of collected gas, corrosion current measurement and simulated battery discharge.
得到了放电击穿时间、放电峰值电流随充电电压、不同气体介质变化的曲线；
The discharge breakdown time, peak current as a function of charge voltage and buffer gas are obtained.
压缩和复原阻尼力主要由三部分构成，即电流变液基础粘度引起的本底阻尼力，电场强度函数的电致阻尼力和气室气体引起的压力。
There are three sections of damping force, and they are background damping force of a fluid viscosity, electric damping force of applied electric field and pressure of gas.
汞弧光放电是一种低气压气体放电现象，放电电流密度大。
The discharge of mercury arc is electric discharge phenomena of low pressure gas and the current density is great.
如果碳纳米管阴极附近的真空度太低，将产生打火、气体电离、离子回轰阴极等问题，将导致阴极发射电流的迅速衰减。
If the vacuum near the cathode is too poor, it will generate spark, gas ionization and ion bombardment on cathode, which can result in a fast attenuation of the emission current.
气体的产生消耗电流引致泳透力下降，则不可能使隐蔽表面涂上漆。
Throwpower drops off as current is consumed in the production of gas and is not available to permit the covering of recessed areas.
基于气体燃料(一般是氢气)氧化产生电流的一种一次能源发生设备。
A primary power-generating device based on the production of an electric current by the oxidation of a gaseous fuel, usually hydrogen.
等离子显示器是平板显示器中最好的一种，像霓光灯泡，等离子显示器在电流存在的情况下使用一种发光的气体。
A gas-plasmadisplay is the best type of flat screen. Like a neon light bulb, the plasma display uses a gasthat emits light in the presence of an electric current.
利用X射线对气体分子的电离作用，在一定电压下用一束X射线照射真空灭弧室，使灭弧室内产生电离电流。
The remainder molecules in the vacuum tube will be ionized by X-ray irradiation, the ionization current can be detected at a constant DC voltage.
在连续大电流区间获得稳定的熔滴过渡形式才是采用无氦混合气体保护实现高熔敷率MAG焊工艺的核心问题。
It is the key to realizing high deposition rates MAG process with non-helium in shielding-gas mixture to acquire stable metal transfer mode in the region of high continuous current.
第二部分研究了在氩气作保护气体的情况下，用变极性TIG焊方法焊钢时，焊接电流、电压的变化情况和电弧形态的变化。
The second is, when steel is welded by means of VPTIG of argon, the changes in current, voltage and arc shape.
制冷气体由半导体制冷片产生，电流由蓄电池提供，鼓风设备由电动机充当。
Refrigerant gases generated by the semiconductor chip cooling, the current provided by the battery, the electric motor acts as blast equipment.
第三部分研究了在氦气作保护气体的情况下，用变极性TIG焊方法焊铝时，焊接电流、电弧电压的变化情况和电弧形态的变化。
The third is, when Al is welded by means of VPTIG method of helium, the changes in current, voltage and arc shape.
解决了连续大电流区间熔滴过渡稳定性问题，实现了无氟混合气体保护的高熔敷率MAG焊工艺。
The stabilization of metal transfer in the range of high continuous current is solved, and the high deposition rates MAG process without helium in shielding-gas mixture is realized.
介绍了SF 6气体绝缘电流互感器中动密封的应用与设计，并提出了提高动密封性能的方法。
Introduces the application and design of motive sealing on SF6 gas insulated current transformer and gives relevant solutions.
通过上述离子化过程会产生气体放电，从而使阻抗降低，放电电极之间就会有大量的电流流动，而产生较强的可视光。
The ionization will realize electric discharge of gas, so as to lower down the resistance, realize large amount of current flow between discharge electrodes and generates stronger visible light.
根据输出的电流及其积分电量可计算金属在气体中的瞬间及平均腐蚀速度。
Based on the cell current and its accumulated quantity the mean or instantaneous corrosion rates of metals in gases can be measured and recorded continuously.
根据输出的电流及其积分电量可计算金属在气体中的瞬间及平均腐蚀速度。
Based on the cell current and its accumulated quantity the mean or instantaneous corrosion rates of metals in gases can be measured and recorded continuously.
应用推荐