在一例典型毛细胞白血病细胞胞浆中见有少数小的电子致密颗粒，其性质和意义尚不清楚。
In one of the cases, some small electron dense granules were found in the cytoplasm, their nature and significance are still unknown.
采用毛细管粘度计考察了稳定剂对石油沥青质溶液粘度性质的影响。
The effect of stabilizers on viscosity behavior of petroleum asphaltene solutions was studied with a capillary tube viscosimeter.
应用毛细管流变仪测量了在接近实际挤出工艺条件下低密度聚乙烯熔体的流变性质；
The rheological properties of low density polyethylene (LDPE) were measured under conditions close to the practical extrusion process by means of a capillary rheometer.
土壤粘附强度主要由毛细管作用力和界面水膜粘滞力构成，固体表面性质对其产生影响。
The soil adhesive strength is mainly composed of capillary pressure and viscous resistance of the water film, which are affected by the nature of solid surface.
为了阐明转变的性质，用毛细管流变仪和微型平板粘度计研究了其熔体粘度的温度依赖性。
In order to clarify the nature of the transition, the changes of melt viscosity with temperature and shear rate were investigated by capillary rheometer and micro-parallel type rheometer.
结论：麦饭石的应用与它的表面性质有关且与它的毛细管凝聚作用相关联。
Conclusion The Maifanshi adsorption is concerned with specific surface and capillary tube coacervation.
性质：将干燥毛细管的一端与水面接触，则在毛细管中上升，其吸水力即称为毛细管力。
The water content of attraction and capillary decreased with the increase of the matrix suction, which consisted of attraction and capillary powers.
中文内容：在毛细管电色谱中，由于溶质在输运过程中所具有的电性质，常会产生一些特殊的现象。
Content: Due to the electric characteristics of the solute transport in capillary electrochromatography (CEC), some special phenomena might occur.
毛细孔分布均匀、孔径适宜、韧度高、耐油性高、不易腐蚀、容易清洗干、不易变色、性质温和柔软，是美容界认定的一种高级产品。
They are thought as high quality products for their densities are well distributed; aperture is proper, high ductile, high oil resistance, not easy to corrode and fade away, easy to wash and soft.
应用毛细管流变仪测量了在接近实际挤出工艺条件下低密度聚乙烯熔体的流变性质； 应用流动可视化技术，观测了试样熔体流经突然收缩的轴对称口模时的入口收敛流型。
The entry convergent flow pattern was observed with flow visualization technique when the resin melt flowed through a die featuring abrupt contraction in cross-section of channel and axial symmetry.
应用毛细管流变仪测量了在接近实际挤出工艺条件下低密度聚乙烯熔体的流变性质； 应用流动可视化技术，观测了试样熔体流经突然收缩的轴对称口模时的入口收敛流型。
The entry convergent flow pattern was observed with flow visualization technique when the resin melt flowed through a die featuring abrupt contraction in cross-section of channel and axial symmetry.
应用推荐