攻击节点捕获网络中正常路由分组，通过“隧道”将其传输给另一端合谋节点，合谋节点再将该分组重放到网络中。
One attack node catches the routing packet in network and then transmits it to colluding node through "Tunnel". Colluding node retransmit the packet into the network directly.
这样，所有因特网的正常路由冗余便随之而来，并且还可以使用自动负载平衡和故障转移机制(这些机制普遍应用于当今的因特网中)。
This automatically gives you all the Internet's normal routing redundancy, plus the ability to use automated load-balancing and failover mechanisms which are ubiquitous on today's Internet.
在业务整合过程中，异常处理和选取适当的路由与处理正常情况一样重要。
In business process integration, handling exceptions and taking the appropriate route is as important as handling normal cases (such as happy flow).
需要特别注意的是，一个系统中的所有调度程序都必须使用相同的模式，否则路由可能出现冲突，该产品无法正常工作。
It's important to note that ALL dispatchers in a system must use the same mode otherwise routing might conflict and the product won't work as expected.
这些虽然不是公共地址，但路由本身仍旧需要使用IPv4地址以正常运作。
These work by not being publicly routable, but the router itself still needs an IPv4 address in order to operate at all.
同样，如果物理层的所有通信中断了，HA仍然会认为网络是正常的，因为它仍然能够通过Hypervisor上的虚拟lan路由通信流。
Likewise, if all communication at the physical layer was lost, HA would continue to think the network was OK, as it is still able to route traffic across the virtual LAN on the Hypervisor.
如果服务器出现故障，客户机api软件将把缓存读写操作重新路由到正常运行的备用服务器上。
If servers fail, the client API software reroutes your cache reads and writes to a working alternate.
对分布式拒绝服务攻击的防护，传统的方法是采用路由访问控制列表过滤的防护方法，无法识别虚假地址和针对应用层的攻击，而且容易造成服务器无法向外部提供正常的服务。
The traditional detect method of adopting acl for DOS can not identify the attack aiming at the fake address and application layer, and easily made the server cannot apply the normal service for user.
因此，无线传感器网络路由协议设计的主要目的是在保证数据传输正常的前提下尽可能地延长网络的生存时间。
Therefore, the wireless sensor network routing protocol design the main objective is to ensure that data under the premise of a normal extension of the network as much as possible the survival time.
它不仅能够管理路由器本身的配置信息，而且能够向网络管理站报告路由器的相关状态，从而保证整个网络系统的正常运转。
It ensures smooth operating of the whole network by managing configuration of the router and reporting network status to management station.
重要事项：请确保您配置路由器，以推动港口9日至电脑要开机，否则将无法正常工作，因为魔术包不能在您的网络。
IMPORTANT: Make sure you configure your router to forward port 9 to the computer that you want to boot up otherwise it will not work because the Magic Packet can't get in your network.
路由器在处理拥塞时，一般采用尾部丢弃TD-FIFO算法和随机早期丢弃RED算法。通常把网络载荷分为正常、拥塞避免和拥塞三个阶段，并在拥塞避免阶段开始采取行动。
Usually in the process of congestion control there are several methods, in which includes Tail Drop First In Out (TD-FIFO) method and Random Early Detection method (RED).
路由器在处理拥塞时，一般采用尾部丢弃TD-FIFO算法和随机早期丢弃RED算法。通常把网络载荷分为正常、拥塞避免和拥塞三个阶段，并在拥塞避免阶段开始采取行动。
Usually in the process of congestion control there are several methods, in which includes Tail Drop First In Out (TD-FIFO) method and Random Early Detection method (RED).
应用推荐