变压器其交变电压的改变与初级线圈及其次级线圈的匝数成正比。
An electric transformer changes the alternating voltage applied to it in proportion to the Numbers of turns in its primary and secondary windings.
灯具泄漏电流测试线路中隔离测试变压器次级接地问题直接影响着测试结果的准确性。
The earthing of secondary circuit of an isolating test transformer on the circuit for luminaire leakage current test strongly influences the accuracy of test results.
在变压器的次级一侧有一个变阻器和齐纳二极管，它们起到进一步减小冲击脉冲的作用。
At the secondary side of the transformer there is a varistor and Zener diodes which act to stepwise reduce the surge pulse.
当处于焊接工况时，变压器次级采用全波整流方式，工作电压输出为36V；
The secondary side of the transformer uses the way of full-wave rectification and the output voltage is 36V, when it is in jointing.
变压器有一个初级线圈和次级线圈。
多个电容器，设置在所述多个负载的每个负载上，其一端共同连接到所述变压器的次级绕组，另一端分别连接到所述多个负载；
One ends of the capacitors are commonly connected to a secondary winding of the transformer, and the other ends thereof are connected to the respective fluorescent lamps.
差功变压器的次级线圈接成反向串联，以便在平衡时输出为零。
The differential transformer secondary windings are connected in subtractive series so that the output is zero at balance.
在变压器的初级使用二极管钳位电路，可以有效地抑制变压器次级的寄生振荡。
And the diode clamp circuit introduced in the transformer primary can apparently restrain from the peak voltage resonance in the rectified diodes.
供电电源则将14只功率场效应晶体管MOSFET接入电源变压器次级，两绕组的全部组合可构成18个不同扎数的次级。
The power source used 14 power file effect transistor MOSFET in power transformer second order; all the combinations of twist-coil could construct 18 different second orders.
当次级侧的分布式发电功率很小的时候，也有可能引起高电压，这是由于架空线路、次级线包和配电变压器上的电压降引起的。
This can even happen for a small DG located on the secondary because of the voltage drop along the service drop, the secondary wiring, and the distribution transformer.
特点：采用PLC程控，配置日本米亚基ct- 110焊接控制器，三段通电方式，具有电流缓升缓降功能。采用焊接变压器次级反馈控制电流及导通角控制。
Features: PLC programming, equip with Japan Miyachi CT-110 welding control device, three segments electrification method, with current slow increasing and slow dropping function.
特点：采用PLC程控，配置日本米亚基ct- 110焊接控制器，三段通电方式，具有电流缓升缓降功能。采用焊接变压器次级反馈控制电流及导通角控制。
Features: PLC programming, equip with Japan Miyachi CT-110 welding control device, three segments electrification method, with current slow increasing and slow dropping function.
应用推荐