合适的渗透溶剂可提高印迹膜对模板分子的渗透选择性。
Appropriate solvent could increase the permeation selectivity of the imprinted membrane for the template.
同时采用量子化学的方法对活性构象模板分子电子结构作了讨论。
In the paper the electronic structures of the template molecules are discussed through quantum chemistry calculation.
此外，控制实验的研究结果表明非印迹微球对模板分子的响应极其微弱。
Additionally, the results of control experiments showed that only negligible signal was obtained for non-imprinting microspheres.
当竞争物尺寸小于模板分子时， 尺寸效应起主要作用， 竞争物优先传输；
When the competitive analogue is smaller than the template, it preferentially transports through the MIMs because of the size effect.
以S-（-）-2，2’-联二萘酚为手性模板分子，合成出了它的两个七元环衍生物。
Two 7 - membered ring derivatives of S-(-)-2,2'- binaphthyl - diol, were synthesized.
用电聚合的方法在金电极上制备了以对硫磷为模板分子的自组装邻氨基硫酚分子印迹膜传感器。
A novel electrochemical sensor for the detection of parathion based on molecularly imprinted polymer of self-assembled o-aminothiophenol onto gold electrode was constructed.
讨论不同摩尔比例的功能单体与模板分子合成印迹聚合物的效果，得出最佳的摩尔比为4：1。
Effect of different molar ratios of the functional monomer to the template on the performance of the synthesized MWNTs-MIPs was discussed and the results showed that the optimum ratio was 4:1.
以氨基安替比林为模板分子，采用原位聚合法制备了具有特定识别性能的棒状分子烙印聚合物。
The recognition of the molecularly imprinted polymer rod was evaluated by comparing the retention values of aminoantipyrine and its analogues.
本文首次以毒死蜱、鱼藤酮为模板分子，采用单步溶胀聚合法制得了单分散分子印迹聚合物微球。
In this paper, Chlorpyrifos and Rotenone were firstly chosen as template. Monodisperse molecular imprinted polymer microspheres were prepared by a single-step swelling and polymerization method.
这种方法使用了液态NMR和动态光散射（DLS）来研究模板分子和胶粒的联系以及微粒的动态成长过程。
This method employs solution 1H NMR and dynamic light scattering (DLS) to investigate the association of template molecules with colloidal particles and the dynamic process of particle growth.
用红外光谱对镍离子印迹聚合物的结构进行表征，红外光谱研究表明聚合物中存在与模板分子相互作用的特征基团。
The structure of polymer was studied by IR spectrometry. The result indicated that some characteristic groups in the ion-imprinted polymer interacted with the template.
对该膜进行扫描电镜测试，结果表明高选择性分离膜中存在较为规整的孔结构，且与模板分子在大小和形状上相匹配。
The scanning electron microscope (SEM) tests of HSM showed that there were regular channels with corresponded pore sizes matched with the template molecules in the HSM.
通过振荡吸附法对聚合物的结合特性进行了评价，发现印迹聚合物微球对模板分子的识别选择性优于块状印迹聚合物和非印迹聚合物。
Binding property was evaluated with a batch adsorption method. The results indicate that the selective recognition of the template molecule with the molecularly imprinted Po...
至关重要的是，这些结果决定性地表明，分子复制过程，不需要以DNA,RNA的模板为基础。
Critically, these results demonstrate conclusively that molecular reproduction need not be based on template replicating DNA, RNA.
无酶模板复制RNA分子的早期努力。
Early Efforts at Enzyme Free Template Replication of RNA molecules.
对遗传信息进行编码。基因——长长的脱氧核糖核酸分子中的不连续的片段——把它们的序列转录成单线信使核糖核酸分子，核糖核酸又成为蛋白质的模板。
Genes — discrete segments of long DNA molecules — transcribe their sequences onto single-strand messenger RNA molecules, which then serve as templates for proteins.
HAR1编码的是一小段RNA(一种分子，往往在DNA翻译成蛋白质的过程中起模板的作用)，据推测，该段RNA对神经系统发育具有某些直接的功能。
It codes for a bit of RNA (a molecule that usually ACTS as a template for translating DNA into protein) that, it is speculated, has some direct function in neuronal development.
需要特别强调的是，康瑞得认为人脑的能力大多来源于构成脑细胞的单个分子的熟练化意识模板。
Specifically, Conrad believes that many of the brain's capabilities stem from the pattern-recognition proficiency of the individual molecules that make up each brain cell. CET-6, 2000.6.
考察了聚合反应条件，如溶剂种类、聚合温度、模板浓度、引发剂用量、转速、预聚合时间等对分子印迹聚合物微球特性的影响。
The effects of reaction conditions were studied, including the kind of solvent, polymerization temperature, the concentration of template and initiator, rotational speed and pre-polymerization time.
扼要概述了非共价法制备分子模板聚合物的影响因素及控制措施。
Influence factor and control measure on the preparation of molecular template polymer by non-covalence method were reviewed concisely.
固载方法有柔性配体法、模板合成法、分子渗透法及沸石合成法。
The method of encapsulation included flexible ligand route, template synthesis route, molecular impregnation route and zeolite route.
许多分子能与核酸发生相互作用，破坏其模板作用，使核酸链断裂，进而影响基因调控和表达功能。
Many small molecular can interact with nucleic acid, make it rupture and affect the gene's function of adjust, control and expression.
用非共价法，在极性溶剂中，以丙烯酰胺作功能单体，以强极性化合物槲皮素为模板，制备了分子烙印聚合物(mip)。
A molecularly imprinted polymer (MIP) was prepared using quercetin as the template and acrylamide as the hydrogen-bonding functional monomer in a polar solvent.
本论文以分子印迹理论为指导，以不同的分子为模板合成了不同的分子印迹聚合物，系统研究了分子印迹聚合物的几个方面。
With the direction of theory of molecularly imprinted polymer, this paper synthesize different polymer with template molecular and study several field of molecularly imprinted polymer in system.
结果表明，采用阶段焙烧法脱模板剂可以有效的抑制分子筛脱铝，更好的保持分子筛原始结晶态和比表面积；
The results showed that stage-by-stage calcination could prevent effectively the molecular sieves from eliminating aluminum and keep well the original crystallites and the specific surface area.
利用改良的SDS法提取DNA效果很好，RAPD反应时，DNA模板中RNA对扩增结果无影响，SDS、氯仿、异丙醇等小分子物质对扩增结果有干扰作用。
The modified SDS method which was used to extract DNA got good results. During RAPD , RNA in the DNA template had no effects on the amplification results.
本文通过模板诱导有机发光小分子定位沉积的方法构筑了大面积纳微米尺度的荧光图案。
In this paper, micro - and nano - scale fluorescent pattern over large area was fabricated by template directed selective deposition of organic luminescent molecules.
研究表明，合成条件，如晶化温度和时间、有机模板剂的类型和组成等，都对SAPO - 11分子筛的合成有很大影响。
The study indicates that synthetic conditions such as crystallization temperature and time, the type and composition of organic templates, could effect on SAPO-11 molecular sieves synthesis greatly.
采用分子印迹技术合成了对药物氟哌酸有高度选择性的模板聚合物。
The selective binding characteristics of the template polymer was evaluated by Scatchard analysis.
采用分子印迹技术合成了对药物氟哌酸有高度选择性的模板聚合物。
The selective binding characteristics of the template polymer was evaluated by Scatchard analysis.
应用推荐