底模用铝合金底板,含可调装置。
本文分析并介绍了制动器底板精整模结构、模具的设计要点和其工作过程。
This paper analyzed and introduced the size die structure, die design points and working process.
本文介绍了AG50C摩托车头盔箱底板拉伸模的设计与制造过程。
In this paper the design and manufacture procedure of. The drawing die for the helmet box base in AG50C motor is introduced.
底板是以槽钢焊接成框架,钢板为面板的平板结构,其尺寸与模框相对应。
Channel bottom is welded into the frame, steel structure for the flat panel, and its size corresponds with the mold box.
定期清洁机台表面、底板及下模滑板、沟槽、上模内压板及保险杆(注:必须关闭电源并恢复常温)。
Clean the machine including the surface, base, slip board, groove, pressed board and oriented pole in the fixed time. (turn off the power until the machine to normal temperature).
模框和底板的强度及平整度要求很高,达不到质量标准的模框和底板直接影响加气混凝土生产的成品率。
Mold frame and floor flatness requirements of strength and high quality standards reach the bottom of the mold box and a direct impact on the production of aerated concrete yield.
模框与底板形成一套模具,搅拌好的浆料通过浇注发泡、静养、初凝过程使之成为可以切割的坯体。
Mold to form a mold box with the bottom, stirred slurry by pouring foam and resting, the initial setting process of making the green body can be cut.
模框与底板形成一套模具,搅拌好的浆料通过浇注发泡、静养、初凝过程使之成为可以切割的坯体。
Mold to form a mold box with the bottom, stirred slurry by pouring foam and resting, the initial setting process of making the green body can be cut.
应用推荐