课题着重对这两个模块的电路结构以及版图结构进行了深入的研究和分析，并采用SPICE工具进行了模拟验证。
The paper has an emphatical discussion on the study and analysis of the circuit structure and layout structure of these two modules, and makes a lot of SPICE simulation and verification.
采用IR 2110作为该功率放大电路的驱动模块，构成的整个驱动电路具有结构简单、驱动能力强、功耗低的特点。
The entire drive circuit has characteristics of sample construction, powerful drive energy and low consumed power by using IR2110 as the drive modular.
本平台采用模块化设计，可运用不同模块在平台上搭建各种实验电路，具有结构简单，操作方便，易于扩展的特点。
Adopting the modularization design, the platform has a simple structure, convenient operation and easy expansion. And different modules can build up the various experiment circuits.
为了实现低电压低功耗设计的要求，改进了调制器结构，并进行了从系统到电路模块的优化。
The low voltage and low power target is attained by improving the modulator structure and optimizing from system to circuit blocks.
分析了功能模块的硬件结构并设计相应的硬件电路。
Analyze the hardware structure of functional modules and then design the relative hardware circuit.
给出了系统的硬件电路结构原理，PC、单片机与蓝牙模块hci接口的软件实现方法。
The systematic hardware circuit construction principle and the software realized methods of PC, SCM and Bluetooth module HCI interface are proposed.
频谱搬移法不仅可以改善高通道的性能，而且还可以使电路结构模块化、标准化、系列化，因而具有较强的实用性。
The new scheme can not only improve the performance of higher channels, but also make circuit modular, standard and series. So, it is of higher practicality.
过滤器逻辑结构的模块化特别适宜用标准单元法来实现ASIC(专用集成电路)的版图设计。
The modularization of filter logical architecture is especially suitable for layout design of ASIC with standard cell.
介绍了利用高频开关管IGBT构成模块化充电电源的主电路、控制电路及保护电路的结构、原理。
The structure and theory of main circuit, control circuit and protection circuit of modularized charge power supply composed by IGBT high frequency switch tubes are introduced in this paper.
介绍基于无线数据传输模块及单片机设计的比赛计分计时系统，硬件电路的结构、软件的设计过程及系统所实现的功能。
This article presents hardware circuit of the reckon by time and score, the program operation by PC , the foundation of this system.
在系统结构的实现上，该装置的主电路采用基于IGBT的智能模块IPM构成三相桥三电平变流器；
On the structure of system, the three-level converter of three phase bridge of the equipment in main circuit is built with IPM module based on IGBT, and its controller is made up of double CPU.
在研究变频调速系统的基本结构中，对变频调速系统的基本结构，以及如何利用IGBT智能模块IPM实现变频调速主电路的进行了介绍。
In the study of, I introduce the the basic structure of the Frequency Control System, and tell something about how I use intelligent IGBT module IPM to produce the Frequency Control main circuit.
同时对硬件电路原理和软件模块化结构的设计进行了分析和讨论。
The structure of main circuit of this power control , the system basic principle of the microprocessor hardware system and the design of software are described.
详细叙述了通讯板接口模块的硬件结构设计，其中，对数据缓冲电路、数据传输速率选择电路、逻辑控制电路等各关键点做了重点介绍；
Secondly, the hardware structure of the interface module is described in detail, mainly including data latch and buffer circuit, choice circuit of transmission rate, etc.
本文给出了完整的系统结构框图和各部分电路原理图，描述如何利用微控制器和蓝牙模块组建系统，介绍了所用器件的原理。
The thesis gives a detailed block diagram and describes the design of every part of hardware circuit. The thesis introduces how to constitute the system using MCU and Bluetooth module.
整个校正电路为一附加的功能模块，对原接收机结构无要求。
As an additional functional module, this correction circuit requires no changes to the original structure of the receiver.
在上述理论分析的基础上，分别设计了三种不同结构的低功耗电源恢复电路和解调电路以及参考电压源电路等电路模块。
Thirdly, according to the design techniques mentioned above, three kinds of Low-Power rectifier, demodulator and other circuits, such as bias circuits, POR generator, etc. are put forward.
其次，本文对超高频射频电子标签的整体结构做了介绍，同时分析了射频前端各电路模块的设计指标。
Secondly, this paper has made the instructions of the overall structure about the UHF RFID tags, and analysis the circuit design specification of the RF front-end modules.
在此基础上，提出利用开关管与二极管电路连接光伏模块，实现小型光伏阵列的宏观与微观结构布局电气重构。
The circuit composed of switch and diode is applied to connect photovoltaic modules for the electrical reconfiguration of small-size photo-voltaic array in macro and micro layouts.
介绍一种技术性能比较先进的交通信号控制机，这种信号机不仅能够自动地进行多时段控制，还可以接入网络实现在线控制；电路设计采用模块式的电路结构，可根据用户的功能需要增减模块电路。
This paper introduces an advanced traffic signal controller, which can not only implement multi-time block control, but also can be connected with network in order to realize on-line control.
通过增加少许电路结构，解决了由于内部多时钟以及多个嵌入式存储器模块的结构带来的影响可测性要求的问题。
With a very small extra number of circuits, the testability problem was removed which is caused by the asynchronous clocks and embedded memories.
简单介绍了模块温度采样电路和TEC制冷驱动器的硬件结构及工作原理；
The paper firstly briefly introduced the hardware structures and the working principles of sampling circuit and TEC driving circuit;
简单介绍了模块温度采样电路和TEC制冷驱动器的硬件结构及工作原理；
The paper firstly briefly introduced the hardware structures and the working principles of sampling circuit and TEC driving circuit;
应用推荐