块检验顺序 BCS?。
小型加工中心负荷试验主要是为了检验设备在额定负荷下的工作能力,负荷试验可按加工中心设计功率的百分比递增方式顺序进行。
In order to test the working ability of the equipment under rated load, the load test can be carried out according to the percentage increasing mode of the design center.
从安装、组对、焊材选用、焊接顺序、坡口形式到焊接检验、验收标准均进行了详细叙述。
The inspecting standards from installation, selection of materials, welding sequence and groove shapes to the welding check are given a minute description.
结合层序地层学研究的结果对模拟结果进行检验,把不同时间单元的沉积微相平面分布提取出来,根据时间的先后顺序进行排列,甚至做成动画,对沉积微相的演化得到直观的认识。
By taking a mid-period cycle as a unit, the planar distribution of the sedimentary microfacies in different units are aligned according to time sequences and even can be drawn into animated cartoons.
最后,论文通过实体试验段工程分析了隧道内连续配筋混凝土路面板及其端部锚固的施工工艺及组织顺序,并给出了相应的质量检验标准。
Finally, through the pilot the paper analyzed the construction sequence of the CRCP and its end fixing equipment, and the corresponding quality checking standards.
本文结合实例介绍了交叉试验的计量与计数资料的统计方法。先比较两个顺序组每例的疗效和,以检验两种疗法残余效应的差别。
The inference concerning a difference between the two carry-over effects may be tested by comparing the intrasubject sums of patients in the A-B sequence with that in the B-A sequence.
本文结合实例介绍了交叉试验的计量与计数资料的统计方法。先比较两个顺序组每例的疗效和,以检验两种疗法残余效应的差别。
The inference concerning a difference between the two carry-over effects may be tested by comparing the intrasubject sums of patients in the A-B sequence with that in the B-A sequence.
应用推荐