本文提出薄壁箱形梁计算的一种分析解法。
In this paper an analytical method for calculating thin-walled box girders has been proposed.
基于竖向弹性地基梁计算模型,提出了板桩结构计算的拟简支梁法。
Based on the calculation model of vertical elastic grade beam, a method called virtual simply-supported beam method for design of sheet pile walls is introduced.
该方法突破了日本学者提出的以弹性分析法为基础的预弯梁计算理论。
Elastic analysis method of preflex composite beam proposed by Japanese was broken through.
本文根据主动土压力大小,应用均布荷载梁计算方法,计算其挠度等参数。
Based on the magnitude of active soil pressure, parameters like bend are calculated applying evenly distributed load method.
本文通过某工程实例的计算,充分表达了新规范中墙梁计算的原理与方法。
The principle and method of the wall beam calculation in the new norm is explained fully in this paper through calculation of some work example.
通过对空间悬挑梁的分析计算,论证不应简单按单一悬挑梁计算的必要性。
By analysing and calculating the cantilevering beam, expounds and proves the necessity and correctly of calculate which shouldn't simple according to the single beam.
运用本文公式对试验梁计算结果较试验值约偏小10%,可以满足设计精度要求。
The results computed were 10% smaller than the test ones, which can satisfy the request designing accuracy.
该文介绍了箱梁墩台截面处横隔梁计算的简化方法,并与较精确的梁格法计算结果进行比较。
The paper introduces the simplified calculation method of diaphragm beam section of box beam at piers and abutments.
与一般的筏板基础有所不同,由于有柱墩,有肋梁墩式筏板基础梁的内力需按变截面梁计算。
Different from general raft foundation, the inner force of ribbed beam is calculated as variable section because of the stump.
根据乌鞘岭隧道岭脊地段地质状况和二次衬砌实际受力特点,采用拟地基曲梁计算法来分析二次衬砌的裂缝宽度与间距。
This paper discussed the calculation analysis of the secondary lining crack width and spacing by using simulating soil curved beam's stress.
利用winkle r地基模型分析锚索框架的受力特征,并通过现场试验加以验证,提出锚索框架的弹性地基梁计算模式。
Analysing the character of internal forces of anchor cable frame by winkler model and verifying it by field test a calculation method is put forward based on elastic foundation beam.
“调度员的工作是以秒为单位计算的。”中心的调度员梁瑞梅说。
"A dispatcher's job is counted in seconds," says Liang Ruimei, a dispatcher in the center.
所述分析方法可推广到其它直线桁梁的抗剪刚度的计算。
This method can be used in other shear stiffness calculations for straight line truss.
通过分析得出了被加固梁最佳支承刚度的计算方法,以及与其对应的最大承载力的计算方法。
This paper gives a method of calculating the optimum support rigidity of the reinforced beam and calculating the corresponding greatest bearing capacity.
与相应的水平加劲梁和不考虑收缩、徐变影响的计算结果比较,差值均在20%以上。
Compared with corresponding horizontal stiffening girder and the computational result without concrete's shrink and creep, the difference is more than 20%.
提出了一种计算竖向结构的侧限作用导致梁、板预应力损失的估算方法。
An assessment method of the loss in prestress which is caused by the influence of lateral structures is produced.
根据试验数据提出了存在斜裂缝钢筋混凝土梁的抗剪强度折减系数的计算公式。
The formula of reduced shear strength coefficient of RC beams with inclined cracks is put forward to according to the test data.
采用该模型计算了健康和局部破损梁的振动特性参数,计算结果与实际测试结果相吻合;
The parameters of vibrational characteristics for healthy and broken RCBs were calculated by the model and the mode parameters of a real RCB were tested.
通过一工程实例中悬挑梁的正截面配筋计算,对钢筋混凝土悬挑梁正截面超筋的概念进行了分析和探讨。
Through a calculation of the strength of normal section of extra-reinforced cantilever beam for an actual project, the conception of normal section of extra-reinforced cantilever beam is analyzed.
阐述了作用于PC轨道梁桥结构上的荷载,曲线pc轨道梁的内力计算,预应力计算,应力计算及组合。
The article have expounded the load acting on PC single track beam, and the calculation of curved PC single track beam including force, prestress and the stress etc.
并对变截面弹性地基梁的计算进行研究,得出计算公式。
The calculation of changing section foundation beams is also studied, and the calculation formulae are worked out.
本文着重论述了圆截面工字梁剪力传感器的理论设计与计算。
The theoretical design and calculation of the circular-section I-shaped beam shearing force sensor have been emphasized in this paper.
本文就钢筋轻骨料混凝土梁的抗剪强度计算问题进行了论述。
This paper deals with the calculation of the shear strength of reinforced lightweight concrete beams.
本文介绍了用于梁变形计算的共轭梁法的原理,并举例说明了该方法的应用。
This paper presents the principle of conjugate beam method which can be applied to the calculation of deformation.
文章通过对曲线简支板桥盖梁标高计算程序的介绍,解决了手工计算的缺点,对于提高工作效率起到了一定的作用。
This paper introduce the calculational program of coping elevation for free plate girder curve bridge and resolve the handworked calculational defect, it will useful for improving work efficiency.
研究目的:研究顶板横向预应力钢束对箱梁横向计算结果的影响,给箱梁结构设计提供借鉴和帮助。
Research purposes: This paper analyzes the effect of the lateral prestressing tendon in top deck on the lateral calculation result of box beam.
提出了新的变截面梁临界弯矩计算式,其表达形式与等截面梁的公式相同,便于工程应用。
A new critical moment formula of tapered beam is proposed, which is similar to the expression for beams with uniform cross-section.
根据结构分析中的虚功原理推导弹性地基梁位移计算的一般公式,介绍了连续弹性地基梁的静力分析方法。
Based on the visual work principle of structure analysis, a general formula for the displacement calculation is deduced for the static analysis of the beam on elastic foundation.
梁,挠度,弯曲,应力计算器。
梁,挠度,弯曲,应力计算器。
应用推荐