作者研制的动态流量计是国内流量控制系统中所缺乏和急需的器件，已成功地应用在国产液压电梯流量反馈控制样机上。
This type of flow sensor is widely needed in the flow control systems and has been successfully used in the home-produced prototype hydraulic elevator with flow electrical feedback control system.
本文通过对细胞水分无创探测方法研究，设计研制了红外光谱细胞水分检测系统实验样机。
Through research of the nondestructive detection methodology of cellular water, the infrared spectroscopy experimental prototype is developed.
最后，将研制的系统样机在地面试验成功后，将其应用于煤矿井下输送带的纵向撕裂监测。
At last, the system prototype is applied to mine conveyor belt monitoring longitudinal tear after tested success on the ground.
描述了自级联式感应电动机的数学模型及其控制系统的结构，研制成功该类电机矢量控制系统样机。
The mathematical model and control system structures of self-cascade induction machine drives is proposed, which is firstly developed in the world successfully.
在研制出样机的基础上，对数学模型的验证，起重传感器测量系统的标定，以及现场测试等方面进行了全面系统的实验研究。
Experiments concerning the verification of the mathematical model, calibration of the sensing and measuring system, and field applications are carried out on the basis of the prototype.
研制了机器人实验样机，进行了硬件电路实验和系统性能实验，实验证明本康复训练机器人的机构和控制系统达到了设计要求，具有良好的康复训练效果。
Experiment results indicate that the machinery and control system of the lower limbs rehabilitative robot reach the design request, and this robot has good rehabilitative effect.
分析了系统参数选择对测试精度的影响，并完成了测试系统软件、硬件设计，研制了测试样机。
The effect to accuracy by different system parameters was analysised, the hardware and software of measure system had been designed and the measure instrument was developed.
研制了基于ARM的电磁流量转换器样机系统。
An electromagnetic flowmeter converter prototype based on ARM has been developed.
研制了直线电机直接驱动动态聚焦模块试验样机系统。
A prototype system of the linear motor applied in the direct drive dynamic focus module is developed.
在此基础上，采用高速数字信号处理器（DSP）、大规模现场可编程门阵列（FPGA）和实时软件进行系统设计，完成了原理样机的研制。
On this basis, a prototype is developed with a high speed digital signal processor (DSP), huge field-programmable gate arrays (FPGAs) and real-time software.
为了全电刹车系统原理样机的研制和实验，必须设计相应的全电刹车测试系统。
The test system is necessary in the course of developing the electric braking system.
在此基础上，采用高速数字信号处理器、大规模可编程逻辑门阵列和实时软件进行系统设计，完成了原理样机的研制。
On this basis, the principle prototype is developed with high speed digital signal processor (DSP), the huge reprogrammable logic gate arrays (FPGA) and real-time software.
课题最后研制出样机子系统一套，并对前端和检测台进行了单机测试，对整个子系统进行了联机测试。
The subject developes a suit of sample Subsystem instruments ultimately. The author tests the Front-end and Detection Base separately. The online test for the Subsystem is introduced, too.
介绍IGBT弧焊逆变器的红外遥控的设计，详细介绍系统设计、主电路设计、红外遥控系统硬件设计和红外遥控系统的软件设计。按设计研制出的遥控逆变焊机试验样机。
The design of infrared telecontrol IGBT converting welder is presented in this paper and the designs of the system, power circuit, infrared system hardware and software are presented in detail also.
介绍IGBT弧焊逆变器的红外遥控的设计，详细介绍系统设计、主电路设计、红外遥控系统硬件设计和红外遥控系统的软件设计。按设计研制出的遥控逆变焊机试验样机。
The design of infrared telecontrol IGBT converting welder is presented in this paper and the designs of the system, power circuit, infrared system hardware and software are presented in detail also.
应用推荐