介绍激光跟踪仪精度校验方法。
The inspection method of laser tracking system is described in this paper.
第三条规则是鼓励政策合规准则和校验方法的定义。
Rule three encourages the definition of the policy compliance criteria and mechanisms for their verification.
文中论述了测量的基本原理，线路结构和校验方法。
It illustrates the fundamental principle of the measurement, the circuit layout and the method of calibration.
对于知识校验，提出一种基于有向图的知识校验方法。
A method is presented for knowledge verification based on a directed graph.
本文叙述了一种感应分流器和电流比较仪的绝对校验方法。
This paper describes an absolute method for the calibration of the complex cur-rent ratio of the inductive current divider and the current comparator.
采用多种输入校验方法和有效性验证技术，减少输入错误；
Multiple input validation methods and effective(verification) approaches which can reduce data error are adopted in the software.
本文叙述DJS—130计算机磁鼓接口的校验方法，着重于校验字的求算。
This paper describes the checking method used in the drum interface of Computer DJS-130. Emphasis is placed upon the calculation of check words.
提出了一种AES算法的抗差分差错分析的并发错误检测方法——二维奇偶校验方法。
A two-dimensional parity-based concurrent error detection method for AES algorithm against differential fault attack is proposed.
对断路器延时保护特性的校验方法进行研究，提出一种断路器在线智能测试校验新方法。
In this paper the test technique of protecting time-delay of circuit breaker is discussed and a new online test method is proposed.
计算机继电保护取代常规保护是大势所趋，其校验方法与常规继电保护校验方法大有较大区别。
It is a trend for computer relay protection to replace conventional protection, but there is a large difference between check methods of them.
一般二进制校验方法不适用校验多值数据，给出的重复码和互补码，可适用于任意值数据校验。
Normally, the check method of binary is not suitable to the multiple value data. The duplication code and complementary code given in the paper can be applied to check arbitrary value data.
组合时采用了合理的测量点定位及校验方法，得到了不同轻相流量下的油水两相流速度分布曲线。
An effective position of LDA measurement points and position verification method have been utilized, and a series of velocity profiles with different oil flow rates achieved.
提出了一种提高串口通信准确性的校验方法即带时限多次握手技术，并对通信的可靠性作了仿真分析。
For enhancing precision of serial port communication, the checking method of repeated handshaking with time limit is stated. The reliability of communication is analyzed by simulation.
文章介绍了活塞式压力计的技术性能指标的影响因素，并对其校验方法和提高测试精度的措施进行了分析。
In this paper was introduced the factors of Influencing technical performance index of piston manometer, and analyzed the calibration and test ways of it and the measures of improving test precision.
本文从面向城市配电网规划角度出发，提出了一种基于接线模式规则的配电网规划快速n - X校验方法。
So from the view of urban distribution network planning, the fast N-X verification method is proposed in this paper.
进而提出了基于多回路-有限元耦合数学模型的同步发电机定子单相接地故障三次谐波电压保护方案校验方法。
Furthermore, a checkout method for the third harmonic voltage based protection scheme of stator ground fault in generators is presented based on the verified MLM-FEM coupled model.
对HammingCode信息校验的组成规则、校验方法及校验条件做了探讨与研究，并给出了应用实例。
The article is a discuss and study about the composition rules, methods and conditions of Hamming Code information checking with application examples.
介绍了三种在线校验方法：备用励磁调节、无功负荷转移和甩无功负荷。这些工业试验方法曾在葛洲坝电厂成功使用。
The methods of using reserve excitation device, transferring reactive load and dropping reactive load are put into service for detecting polarity in Gezhouba Hydropower Plant.
为此重点介绍了对交流采样测量装置的校验方法：现场实负荷校验及虚负荷校验； 并对校验方式的适用情况进行了分析。
This paper introduces the checking methods of the measuring devices adopting AC sampling mode, and analyses the appropriate cases these methods are used in.
最后对校验方法的实现过程进行了仿真与实测，验证了方法的性能及效率。为便携式智能化校验装置的研制提供了强有力的理论支持。
It shows that the performance and efficiency of new calibration method is satisfied. It will provide the powerful theory support for the development of portable intelligent calibration equipment.
该系统避开了干度测量的困难，利用双重校验方法及基于故障机理的效率修正方法，初步解决了核电机组湿蒸汽汽轮机的热力计算问题。
This system USES the double-check method and efficiency correction method based on fault mechanism to partly solve the problems occurring in the heat calculation for wet steam turbine.
鉴于传统的电流互感器测试方法已经不适于校验新型的电流互感器，依据IEC标准和误差分析理论，提出了光电电流互感器的测试和校验方法。
Because the traditional calibrating method is not suitable for testing optical electric current transformer, a novel test system is designed based on the IEC standard and error analysis theory.
四是本文采用三种检验方法，即自身检验法，交互校验法和预测值检验法，对财务危机预警模型进行有效性检验。
Finally, this paper adopts three different methods to test the validity of financial crisis warning model, that is self-validated, cross-validated, and forecasting-validated.
通过对电能表校验装置的各项误差源的分析，利用数理统计和实验方法对电能表校验装置的不确定度进行分析和计算。
By analyzing each error source of power meter calibration device, the uncertainty of power meter calibration device is analyzed and calculated with mathematical statistics and experimental method.
通过对用电现场管理终端校验装置的各项误差源的分析，利用数理统计和实验方法对用电现场管理终端校验装置的不确定度进行分析和计算。
By analyzing each error source of checking device of USMT, the uncertainty of checking device of USMT is analyzed and calculated with mathematical statistics and experimental method.
本论文主要阐述了一种可远程传输数据的电能表校验系统的主要功能、误差检验方法、硬件电路、软件流程、短消息编码和测量误差分析。
In the thesis, we mainly describe the function, error test method, hardware circuit, software flow, coding message and measurement error analysis of the system.
本论文主要阐述了一种可远程传输数据的电能表校验系统的主要功能、误差检验方法、硬件电路、软件流程、短消息编码和测量误差分析。
In the thesis, we mainly describe the function, error test method, hardware circuit, software flow, coding message and measurement error analysis of the system.
应用推荐