由三段长圆柱状组织组成，并由弹性组织和一层薄皮覆盖。
Three long columns of tissue extend through its length, covered by elastic tissue and a thin layer of skin.
过滤后铸棒组织中的柱状晶区缩小，中心等轴晶区扩大、晶粒度降低。
The area of columnar structures decreased, and that of equiaxed crystals enlarged. The grain size reduced.
焊缝区组织主要为等轴晶和树枝柱状晶，熔合区组织主要为柱状晶。
The crystallizing morphology on the weld seam was equiaxed grains and dendrites and that on the fusion area were columnar crystals.
柱状晶向等轴晶转变（CET）是在一定的凝固过程中必须控制的一种显微组织转变。
The columnar to equiaxed transition (CET) is a kind of microstructural transformation in certain solidification, which should be controlled.
陶瓷熔覆层的组织为柱状晶。其生长方向与基体表面垂直。
The microstructure of the ceramic layer is columnar and its growth direction is perpendicular to the substrate surface.
经过冷轧和冷拔，柱状晶组织细化为纤维晶组织，并产生显著的加工硬化。
After cold rolled and drawn, the columnar crystals fined to fibrous crystals, which resulted in remarkable work hardening.
通过引入异质形核模型、枝晶生长模型、几率形核基底模型，借鉴单元自动生长机制，仿真了等轴晶、柱状晶组织形成的过程。
Based on the cellular automata technique, the heterogeneous nucleation model, dendrite growth model and random nucleation model are used to simulate the formation of equiaxed and columnar dendrite.
核化温度升高后，样品边界定向生长的柱状晶组织减少甚至被等轴晶取代。
When the nuclear temperature increases, less columnar crystals at the border of the sample are observed and equiaxed crystals form.
结果表明，梯度过渡层的组织形态为细小的柱状晶-胞状树枝晶-树枝状晶。
The results indicated that the microstructure of the transition layer is a structure of fine columnar crystal-cystiform dentrite-dentrite.
尽管在组织学上由鳞状上皮和柱状上皮构成囊腔，囊内充满脂性液体，但难以根除。
They are difficult to eradicate, even though they are composed of histologically appearing squamoid and columnar epithelium lining cystic Spaces filled with oily fluid.
结果显示，新型模具ZA合金用TIG方法进行焊接，焊缝组织形态主要是柱状树枝晶和少量的等轴晶；
It was shown that after the ZA alloy was processed by TIG welding, the weld seam consists mainly of columnar dendrites and a small amount of equiaxial crystals;
结论：在鳞状上皮组织和柱状上皮组织中，RF A治疗组内镜活检标本出现上皮下结构的几率与非处理组相似。
Conclusions: In both squamous and columnar tissue, endoscopic biopsy samples after RFA were as likely to demonstrate subepithelium as untreated controls.
LC9铝合金在773K热扭转中显微组织由粗大的柱状晶转变为细等轴晶。
The coarse column-like grains of LC9 alloy are changed into fine nearequiaxed oneS during torsion at 773K.
研究结果表明：在不预热条件下，用KD286焊补钢轨，焊缝组织为柱状奥氏体组织，熔合区和过热区不可避免地产生脆硬的马氏体组织。
The results show that:under the no preheating condition, the microstructure of weld metal is columnar austenitic, and brittle martensite exists in the fusion zone and over-heated zone unavoidably.
研究结果表明：在不预热条件下，用KD286焊补钢轨，焊缝组织为柱状奥氏体组织，熔合区和过热区不可避免地产生脆硬的马氏体组织。
The results show that:under the no preheating condition, the microstructure of weld metal is columnar austenitic, and brittle martensite exists in the fusion zone and over-heated zone unavoidably.
应用推荐