所以，双极点滤波器组具有较好的实用性。
Therefore, the two pole filter banks is robust and practical.
因而双极点滤波器组是一种稳健的积累器。此外，它与双极点滤波器具有相同的运算量和几乎相同的性能。
In addition, the new integrator has the same computation amount and nearly the same performance as the two pole filter.
滤波器的元件值不是用一般的综合方法，即从输入阻抗中逐个移去全极点或部分极点，而是用极点交换法求得。
The element values of filters can be calculated by permutation method instead of the usual synthesis, i. e. successive complete and partial pole removals from the input impedances.
应用此设计简表能方便地综合设计全极点与椭圆点滤波器。
Using the proposed design tables, all pole and elliptic filters can be synthesized easily.
设计一种用于网电源上，既能串联使用，又能并联使用的对电网污染具有一定治理作用，又可起到节电效果的多极点电源波形矫正滤波器。
The paper described a multi-pole waveform absorbing filter used in the grid for series or parallel connection, to control the grid pollution to a certain extent and save the power consumption.
本文对全极点有源滤波器进行了计算机辅助设计。
In this paper, we try to make use of Computer Aided Design for all pole active filter.
提出了一种高阶全极点ota -C高通滤波器的设计方法。
A novel design method for high order all poles OTA C high pass filters is presented.
这种控制器给出了避免非最小相位过程零极点对消的有限脉冲响应滤波器。
The resulting controller is a finite impulse response (FIR) filter and hence problem of non-minimum phase zero cancellation is avoided.
在时滞滤波器的设计中全面考虑系统的零极点，可以大大提高系统的响应速度。
By considering all the poles and zeros of the system the system response can be quicken up.
而滤波器的零点、极点个数及其位置又完全决定了其相移和群延迟的性质。
The characters of phase shift and group delay are controlled by the number and position of zeroes and poles.
从频率的角度设计滤波器电路，必须考虑诸如滤波器带宽设计和阶数(极点的数量)之类的问题。
Approaching the filter circuit from the frequency perspective will force you to consider issues such as the filter bandwidth design and order (number of poles).
陷波滤波器中的其他三个参数，与滤波器的带宽和极点分布相关，可影响系统的稳定性。
The other three parameters were relevant to the bandwidth and the polar distribution of the filter, which could be used to influence the stability of the system.
文章列举了几组滤波器的实测结果，其中一组在不加任何特别措施的情况下，相对带宽作到了27％，另有一组具有明显的带外衰减极点。
Some experimental results for the filters are given, one has bandwidth of 27% without special measure employed, and another has two evident attenuation poles on either side of the passband.
采用频域的零点配置方法，通过在系统极点附近配置多个滤波器零点设计强鲁棒性的多峰极不灵敏（E I）最优随机时滞滤波器。
Zero placement method in the frequency domain is utilized to design robust multi-hump EI optimal arbitrary time-delay filter (OATF) by placing two or more filter zeros nearby the system poles.
通过采用经验最优零、极点组织零、极点配对方法，可使该滤波器内部幅度限最小。
The internal magnitude bound of this filter can be minimized by using an empirical optimal method of poles and zeros organization.
本文介绍一种利用示波器，对由双运放组成的有源滤波器的二阶节电路的零、极点进行准确调整的相位调试法。
In this paper the phase tuning methods by using oscilloscope for the tuning of the pole and zero of the two—amplifier biquads are given.
本文提出了三个有源补偿rc二阶带通滤波器，给出了这类电路主极点位移的一般公式。
Three active RC second-order bandpass filters with active compensation are introduced. A general formula for analysing the shift in dominant poles is also presented.
为了提高系统的稳定性，抑制滤波器的谐振，在双闭环控制的基础上提出了一种基于虚拟电阻思想的控制策略。通过对滤波电容电流的积分处理，改变了系统传递函数的极点，确保了系统的稳定运行。
To suppress resonance of LCL filter and improve stability of system, it is pre - sent that a voltage and current double loops control strategy based on virtual resistor concept.
为了提高系统的稳定性，抑制滤波器的谐振，在双闭环控制的基础上提出了一种基于虚拟电阻思想的控制策略。通过对滤波电容电流的积分处理，改变了系统传递函数的极点，确保了系统的稳定运行。
To suppress resonance of LCL filter and improve stability of system, it is pre - sent that a voltage and current double loops control strategy based on virtual resistor concept.
应用推荐