应用最大电流自主均流法，设计负载均流电路。
Based on highest current automatic current sharing technique, a load sharing control circuit was designed.
载流是指继电器在触点闭合后能够承受的最大电流。
Carry current is the maximum current the relay can tolerate once the contacts have been closed.
切换电流是指继电器在开路和闭合触点时能可靠处理的最大电流。
Switched current is the maximum current that can be handled reliably while opening and closing contacts.
采用两路结构相同的最大电流选择电路实现输入级总跨导的恒定。
The constant gm of input stage is achieved by two identical maximum current selection circuits.
文中还讨论了各结构参数对JFFT的最大电流放大倍数的影响。
The effects of several configuration parameters in the JFFT on the maximum current amplification are also discussed.
试样所能承受的交流电压最高可达45v，最大电流2.69A。
The Max on-load voltage could be 45v and the Max current reached 2.69a.
最大电流恒定及截止式电路保护装置，免除故障手机线路板进一步损坏。
Protection devices of maximum current steady and cut-off electric circuit avoid further damage of failure phone circuit board.
影响通过开关卡的最大电流的因素包括电路板上的走线、连接器和继电器。
Factors that affect the maximum current through the switch card include the traces on the board, the connectors, and the relays.
为防止损坏开关卡，需验证最大电流和最大电压的乘积没有超过开关卡的功率额定值。
To prevent damage to the switch card, verify that the product of the maximum current and maximum voltage does not exceed the power rating of the switch card.
开关量输出模块的技术指标，它与不同的负载类型密切相关，特别是输出的最大电流。
Output switch module technology indicators, load it with different types are closely related, in particular, the maximum current output.
采用外接调压器最大输出可达1500V、20A；变比测试最大电流高达600A。
Use circumscribed regulator maximum output can reach 1500V, 20A, Change is the maximum current 600A than test as.
在评估最大电压或最大电流水平时，要想达到规定的寿命，则必须考虑继电器的功率额定值。
When evaluating either maximum voltage or maximum current levels, the power rating of the relay must also be considered if the specified life is to be attained.
基本上，我们需要使用达到最大电压或最大电流，但是该运行点永远也不需要立刻达到这两个。
Basically, we need to use up to a maximum voltage or up to a maximum current but the operating point will never require both at once.
推导出规划网架的线路损耗和配变负载损耗的等值电阻，利用馈线容量比值估算馈线最大电流。
The equivalent resistance is derived for distribution transformer load loss and line loss of planning grid, and the maximum current is calculated for each feeder according to their capacity ratios.
它可用于从12v车辆运行的最大电流约800毫安收音机，小灯，继电器，喇叭和其他24v配件。
It can be used to run radios small lights relays horns and other 24v accessories from a 12v vehicle with a maximum draw of about 800ma.
该电阻器的阻值要保证被测装置发生故障时的短路电流不会超过开关卡上任一组继电器的最大电流指标。
The value of this resistor is chosen such that, in the event of device failure, the short circuit current will not exceed the maximum current specification of the relays on either set of switch cards.
该变流器应用ZVS - PWM技术和平均电流模式控制方法，并采用最大电流自动均流法实现多机并联均流。
The converter use ZVS-PWM technique and the average current mode control method, and the use of maximum current flow to achieve automatic multi-parallel current.
文中通过对不同并联方法的分析比较，介绍了最大电流法自动均流控制电路的工作原理及设计，并由试验给出均流效果。
Classifies and evaluate paralleling methods, present the operation principle and design of "democratic current-sharing" method, the experimental results are given.
最大信号电流是在50毫安这个数量级。
这些电阻器的阻值应当使其在最大测试电流时的电压降不会影响测量的准确度。
These resistor values should be such that the voltage drop at the maximum measured current will not affect measurement accuracy.
最大输出电流受到额定功耗的限制。
移相线路中配有与弦移相器以满足可控硅整流器最大可能触发电流和电压。
A cosine phase shifter is applied in phase shifting circuit to meet the possible maximum trigger current and voltage of thruster.
比较好的经验法则是在最大被测电流下，使得该电阻器上的电压降为1v。
A good rule of thumb is to use a large enough resistor to cause a 1v drop at the maximum current to be measured.
“最大信号电平”是指能够切换但又不会损坏开关卡的电压、电流和功率的最大值。
"Maximum signal levels" refers to the highest levels of voltage, current, and power that can be switched without damaging the switch card.
输出为短路保护，接地，但获得最大的可靠性，如果输出电流不超过160毫安。
Output is short circuit protected to ground, however maximum reliability is obtained if output current does not exceed 160mA.
对于PWM电流控制，最大输出电流是由用户选择参考电压和感应电阻决定。
For PWM current control, the maximum output current is determined by the users selection of a reference voltage and sensing resistor.
最大正向整流电流该参数与灯功率有关，所选二极管的额定电流值至少应是交流母线中峰值电流的3倍以上。
Biggest positive the parameters associated with the lamp power rectifier current, the rated current value of the selected diode should be a peak current in ac bus at least more than 3 times.
剩余的障碍，也是公认的最大的一个，就是如何从纳米天线收集电流。
The remaining hurdle, admittedly a high one, is to collect the current from the antennae.
剩余的障碍，也是公认的最大的一个，就是如何从纳米天线收集电流。
The remaining hurdle, admittedly a high one, is to collect the current from the antennae.
应用推荐