两年后，在将要参加工作的最后一年里，突然有好几个男生对我有好感。
All of a sudden, there were some boys like me In the last year of working.
最后本文探讨了一下电解电火花复合加工微型压气机的可行性，对今后的工作提出了一些意见。
At last, the feasibility of the manufacture of micro-compressor with ECM-EDM complex technology is discussed, and advices are put forward for the later work.
光整加工作为模具加工的最后一道工序，其加工质量一般影响着产品的最终质量和使用性能。
Finishing machining as the last procedure of mould machining usually is the most important working procedure, its finishing quality affects directly the final quality and using performance of product.
本文首先介绍了螺纹数控切削的编程方法，并就其对加工误差的影响进行了分析，最后根据实际工作总结出数控车床螺纹切削编程及加工时的注意事项。
This paper discussed the methods about cutting thread on nc Lathe. The cutting errors was analyzed. The program about cutting thread and the notices in cutting process were concluded.
床身导轨粘接铜板，工作台镶板，再二次加工，用样板检验，最后与工作台合研。
It is that the bed way is bonded with copperplate, the work table is paneled, then is processed again and checked with the standard plate, finally is gathered with the work table.
床身导轨粘接铜板，工作台镶板，再二次加工，用样板检验，最后与工作台合研。
It is that the bed way is bonded with copperplate, the work table is paneled, then is processed again and checked with the standard plate, finally is gathered with the work table.
应用推荐