并利用背散射电子衍射(EBSD)技术分析了晶粒取向变化。
The grain orientation was determined by orientation mapping of EBSD technique.
随着晶粒取向度的提高，纳米晶单相磁体的矫顽力逐渐增加，这完全不同于烧结磁体。
The investigation shows the increase of coercivity with improved grain alignment in nanocrystalline magnets, which is completely different from the phenomena in sintered magnets.
结果表明：经等径角轧制后的板材，晶粒取向由等径角轧制前的(0002)基面取向演化为基面与非基面共存的取向。
It is found that the orientation of the sheet processed by ECAR is changed and the crystal orientation evolves from (0002) basal plane orientation to coexistence of basal plane and non-basal plane.
就所包含晶粒数相同的多晶集合体来说，在确定晶粒随机取向时，选取不同的方法对它的各向异性程度也有一定的影响。
Even for the same number of grains when taking the different methods to determine the random orientation, the degree of anisotropy of simulated is different.
本文采用图像分析的方法，系统地研究了一种优等石墨电极中针状焦晶粒的取向与其在电极中的径向位置的依赖关系。
This paper reports a systematic study on the needle-coke grain orientation as a function of radial position of a premium grade graphite electrode using image analysis.
分析了二次再结晶过程中高斯取向晶粒与晶粒尺寸的关系及取向差分布；
The Goss oriented grains, their grain sizes and their misorientations to the surrounding grains were analyzed.
发现冲击波的主要效应体现为对晶粒的破碎、细化和取向作用，对晶格结构几乎没有影响。
It is found that shock wave mainly changes the crystallite size and orientation, but has little effect on its lattice structure.
结果表明，晶粒异常长大的择优取向依赖于热处理温度及气氛。
The experimental results indicate: The preferred orientation of the abnormal grain growth depends on the annealing temperature and atmosphere sensitively.
金属的铸造、塑性成形、热处理等过程会使晶粒的尺寸大小、取向分布、形状等发生一定的变化，产生不同的微结构。
During the casting, plastic forming, and hot processing, the sizes, orientation distributions, and boundary structures of the crystallites change and produce various microstructures.
从应变能的最小化考虑，这些取向的晶粒将依次优先生长。
Considering strain energy minimization, we predicate that the grains with these orientations should be favorable in crystal growth successively.
两种薄膜晶粒的生长取向不同。
The orientation of the crystalline grains of the films is different.
常规轧制板材具有明显的晶粒择优取向，大部分晶粒的(0002)基面都平行于轧板表面。
Normal rolling sheets have obvious preferred grain orientation and basal plane (0002) is parallel to the rolling plane.
多晶生长暂停拉伸时，新晶粒将在柱状晶顶部晶界夹角处形核并长大，而且新晶粒的晶格取向与原有晶粒的取向无关。
When pulling halts, the combination of grains occurs, and the lattice orientation of new grain is not related to the original grains.
介绍了一种六角晶系铁氧体轴比及晶粒均匀性的控制方法，并对烧结磁体取向度的提高作了讨论。
In this paper, a control method of axis ratio and grain distribution of hexagonal ferrite is introduced, and improvement of sintered magnet orientation is discussed.
更高温度的保温处理使得回火马氏体的晶粒发生偏转，导致许多区域整体的取向关系难以满足K-S关系和N-W关系。
The heat treatment with higher temperature caused the orientation of martensite grains rotated to some extent, which caused most areas in the heated samples do not follow K-S and N-W OR accuratly.
研究了金刚石膜内晶粒尺寸和取向程度对金刚石膜然导率的影响。
The effects of grain size and orientation on thermal conductivity of diamond film are studied in tills paper.
发现薄膜中晶粒的结晶取向、晶粒大小和晶粒边界条件直接影响其电畴的形态复杂程度。
It was revealed that the crystallographic orientation, dimensional sizes and boundaries of ferroelectric grains significantly affect the domain structures of thin films.
铁电畴图像复杂的畴衬度与晶粒中的畴排列和晶粒的取向密切相关。
Complex domain contrast is related to the arrangement of domains in grains and to the orientation of the grains in the film.
结果表明，随着铸坯加热温度的提高，冷轧无取向硅钢成品晶粒尺寸减少，有利织构组分增加。
The results show that the grain size of cold-rolled non-oriented silicon steel finished product decreases and benefiting texture component increases with increasing slab reheating temperature.
熔块完全融熔去除内部晶界之后，促进了取向性晶粒结晶。
Crystallization of the particles with preferred orientation was promoted, after the removal of internal interface through complete melting of the frit particles.
后者被认为由于随机取向的微小晶粒占优势，其硬度比生长面略高。
The hardness of the reverse side is harder than the right side, because it have an advantage in small crystal of random direction.
电渣熔铸中的工艺参数决定金属熔池的形状和微观晶粒的尺寸及取向，并最终影响熔铸钢锭的质量。
The technological parameters determine the metal pool profile and the microstructure's size and tropism in the electroslag casting process, which affects the quality of ingot casting.
利用背散射电子衍射取向成像技术分析了在热模拟单向压缩条件下Q235碳素钢应变强化相变中铁素体晶粒的取向（差）变化特点。
The microstructure evolution of Q235 plain carbon steel in multi-pass hot deformation was investigated by means of hot compression simulation.
在拉伸过程中，具有退火孪晶的晶粒内部首先发生变形，产生的变形孪晶遗传了退火孪晶的取向。
On the deformation process the annealing twins transform into deformation twins, which is TWIP effect, and so th.
在拉伸过程中，具有退火孪晶的晶粒内部首先发生变形，产生的变形孪晶遗传了退火孪晶的取向。
The results show that there are 60% annealing twins in TWIP steel before deformation and 32% deformed twins after deformation.
在拉伸过程中，具有退火孪晶的晶粒内部首先发生变形，产生的变形孪晶遗传了退火孪晶的取向。
The results show that there are 60% annealing twins in TWIP steel before deformation and 32% deformed twins after deformation.
应用推荐