凹槽-晶圆片边缘上用于晶向定位的小凹槽。
Notch hAn indent on the edge of a wafer used for orientation purposes.
凹槽-晶圆片边缘上用于晶向定位的小凹槽。
Notch - An indent on the edge of a wafer used for orientation purposes.
硅片的工艺性质与某些材料特性均与晶向有关。
The processing characteristics and some material properties of silicon wafers depend on the orientation .
铁及锌的掺杂会降低锐钛晶向金红石的转变温度。
Iron and zinc doping can lower the transformation temperature of anatase to rutile.
差热分析没有测出过氯酸铵从正交晶向立方晶的相变。
Differential thermal analysis did not reveal the ammonium perchlorate phase change from rhombic to cubic.
就在那时，然而，所以他的鼻子碰晶向乔治的移动的手。
Just at that moment, however, Akira bowed so his nose touched George's moving hand.
提出了适合于读者习惯的应用坐标来标定六方系晶向指数的方法。
This paper presents a method suitable to readers custom to mark the indices of crystallographical orientation in hexagonal system with coordinates.
试验发现，单晶DD3的屈服特性随温度、应变率、晶向而变化。
Test results show that the yield characteristics of DD3 single crystal depend on test temperature, strain rate, and orientation of samples.
而且通过调节工艺参数，可制备出沿不同晶向择优生长的多晶金刚石薄膜。
Moreover, by adjusting the technological parameters, polycrystalline diamond films grown preferentially along the different crystal orientations can be prepared.
在晶体加工中，特殊晶向及晶体棱镜的切割一直是困扰加工者的一大难题。
It is always a great difficult around fabricators to cut the special orientation and prism of crystal in the cutting process.
重点研究了加工单晶材料时晶向对临界切深、微切削力和表面粗糙度的影响；
The crystallographic effects on critical depth, micro cutting forces and surface waviness when machining single crystals are emphatically investigated.
本文主要研究应变硅空穴各机制散射几率及空穴迁移率与晶向、应力的理论关系。
The main work is focused on models of hole scattering mechanisms and hole mobility which is related to the crystal orientations and stress of strained Si.
柱状晶向等轴晶转变（CET）是在一定的凝固过程中必须控制的一种显微组织转变。
The columnar to equiaxed transition (CET) is a kind of microstructural transformation in certain solidification, which should be controlled.
柱状晶向等轴晶转变(CET)的研究具有重要意义，数值模拟是其有效的研究方法之一。
It is of great significance to the research of columnar-to-equiaxed transition (CET), and numerical simulation is one of the valid methods.
根据非整数次折迭链晶向整数次折迭链晶的转变，讨论了双层片晶和单层片晶的生长过程。
On the basis of the transformation of nonintegral folded-chain (NIF) crystals into integral folded-chain (IF) crystals, the growth processes of double lamellae and single layer lamellae is discussed.
根据非整数次折迭链晶向整数次折迭链晶的转变，讨论了双层片晶和单层片晶的生长过程。
On the basis of the transformation of nonintegral folder-chain (NIF) crystals into integral folded-chain(IF) crystals, the growth processes of double lamellae and single layer lamellae is discussed.
衬底诱生应力、工艺诱生应力和采用不同的衬底晶向等三类方法都可以显著提高载流子的迁移率。
Substrate induced stress, process induced stress and use of different substrate orientations are major techniques that can significantly enhance carrier mobility.
枝晶向球晶转变可以明显改善矿渣微晶玻璃的性能，而球晶向块状晶体的转变则恶化了微晶玻璃的性能。
The transformation from the branch to the ball could improve the properties of glass ceramic, and the transformation from the ball to the block could worsen the properties of glass ceramic.
射线衍射（XRD）测试表明ITO薄膜的晶粒尺寸随膜内氧的摩尔分数增加而增大，随氧气比例增加薄膜（400）晶向消失。
XRD test showed that grain size of ITO films increased and crystallization direction(400) disappeared with more oxygen flow.
由莫来石颗粒引入的基体拉应力使裂纹倾向于向晶内扩展。
The tensile stress in matrix introduced by mullite particles made the cracks incline to extend into the matrix.
这些特征温度随dsc升温速率的增大，不断向高温区偏移，其中晶化行为的这种动力学效应比其玻璃转变的更为显著。
The characteristic temperatures are gradually tended to high temperature zones with DSC heating rate increase, where the dynamic effect of crystallization is much higher that of glass transition.
本文对板条状马氏体的惯习面和位向关系、板条间相对取向关系的孪晶学说和其它论点以及板条状马氏体形态模型进行了讨论。
The paper discusses the twin theory and other theses on the habit plane of the lath martensite, the direction relationship and the relative oriented relationship between laths.
试验结果表明，在一定的工艺条件下，通过对基片的加热控制可以获得单一方向生长的柱状晶结构薄膜。
Under the given conditions, we can get films of columnar crystals of growth of single direction by controlled heating of substrate.
通过试验，论证了淬火钢中硼向奥氏体晶界的偏聚，是在冷却过程中发生的一种非平衡的晶界偏聚现象。
The test has been demonstrated that the boron segregation at austenite grain boundaries in quenched steel is a non-equilibrium grain boundary segregation phenomena occurred during cooling.
发现化合物3加热至各自的熔点以上都能形成液晶态，在液晶态可以观察到近晶相和向列相的典型织构。
It is found that the compound 3 went into liquid crystal phase when heated to their Tm. The typical smectic phase and nematic phase texture can be observed.
业已证实，淬火硼钢中硼向奥氏体晶界的偏聚，是在冷却过程中发生的一种非平衡的晶界偏聚。
It has been demonstrated that the boron segregation at austenite grain boundaries in quenched steel is a non-equilibrium grain boundary segregation phenomena occurred during cooling.
铸态组织中存在不同位向的孪晶，大孪晶中有许多平行的二次孪晶，沿孪晶界诱发微裂纹；
There are different direction twins in its casting structures, and parallel second twins emerge in one big twin where micro cracks appear along twin boundary.
铸态组织中存在不同位向的孪晶，大孪晶中有许多平行的二次孪晶，沿孪晶界诱发微裂纹；
There are different direction twins in its casting structures, and parallel second twins emerge in one big twin where micro cracks appear along twin boundary.
应用推荐