部分电流用相应的方程拟合。
Some current traces were fitted with corresponding equations.
不同类型土壤锰吸附动力学以权函数方程拟合度较好。
Power function equation could better describe the adsorption dynamics of soil Mn in different soil types.
根据其散点图形状进行方程拟合及优选，完成蓄积量的估测。
According to the shape of scatter plot, the authors fitted and optimized regressive equation, and then estimated the forest volume.
用热释光一般级动力学方程拟合发光曲线，得到了峰参数和陷阱参数值。
The peak parameters and trap parameters were estimated by fitting these curves using the TL general kinetic order equation.
结果表明该方程拟合是成功的，EGCG提取符合传质扩散动力学规律。
Results showed that the equation optimization was succeeded and the extraction of EGCG complied to diffusion kinetic rules.
通过四阶方程拟合实验数据和热力学数据得到的稳定带厚度更接近实际情况；
The calculated thickness of stability zone by the four-order polynomial using the experiment and thermodynamics data is close to practice.
采用加权曲面参数方程拟合型腔侧壁曲面的算法，实现了子午线轮胎活络模模具型腔曲面的构造。
Apply the weighted surface parameter equation to fit the algorithm of cavity lateral surface, and realize the cavity surface construction of radial parting mold of meridian tire.
分别介绍了用分段多项式和朗培其一奥斯古特三参数方程拟合应力应变曲线并求切线模量和割线模量的方法。
By piecewise polynomials and the Ramberg-Osgood three-parameter equation fitting the stress-strain curve, the expressions of the tangent and secant modulus are derived.
若添加浓度更大时吸附作用仍强烈，则该土壤对镉的吸附情况不宜用吸附等温线方程拟合，只能用图直观反映。
All cadmium adsorption curves could be well described by Langmuir, Freundlich and Henry equations, with better fitness by Langmuir and Freundlich equations.
土壤入渗过程的回归方程表现为乘幂函数形式，回归系数R在0.88 ~ 0.99之间，方程拟合效果较好。
Soil permeability coefficients regression equation performs exponent relation. Regression coefficients were between 0.88 to 0.99, and the equation analog effect was good.
方法构建累积正态分布函数的适当表达形式，对实验所得数据进行拟合，同时与常用的四参数方程拟合进行比较。
METHODS Construct proper accumulation normal distribution function form and fit with our experimental data, then compare with the common 4-parameter equation fitting.
用线性最小二乘法、迭代法以及二分法与最小二乘法相结合的方法，以积分方程、微分方程和放热速率方程拟合dsc数据。
The DSC data obtained are fitted to the integral, differential and exothermic rate equations by linear least-squares, iterative, combined dichotomous and least-squares methods, respectively.
该法用线性最小二乘法、迭代法以及二分法与最小二乘法相结合的方法，以积分方程、微分方程和放热速率方程拟合实验数据。
Thedata are fitted to the integral, differential and exothermic rate equations by linear least-squares, iterative, combined dichotomous and least-squares methods, respectively.
方法：构建累积正态分布函数的适当表达形式，对作者实验室所获得的实例数据进行拟合，同时与常用的四参数方程拟合进行比较。
METHODS: Construct proper accumulation normal distribution function form and fit with our experimental data, then compare with the common 4-parameter equation fitting.
该线性拟合方程的斜率为0.432cm/张。
The slope of this linear fitting equation is 0.432 cm/sheet.
通过水分特征曲线方程对试验数据的拟合，研究了拟合参数随干密度的变化情况。
A equation was used to fit the data of SWCC, and the relation between fitting parameters and dry density was studied.
该方法以测量的应变值为基础，由拟合的曲线方程计算接头载荷，并与试验时施加的总载荷对比。
In this method, based on the measured strain values, the joint load is calculated by the fitted curve equation and compared with the total load applied during test.
利用这一公式建立了常微分方程初值问题的正交多项式拟合算法。
By using this formula, orthogonal polynomial fitting algorithm for initial value problems of ordinary differential equations is established.
我们不仅在方程中加了一个拟合因子，而且在逼近第二个初始条件时也加了拟合因子。
We not only take a fitting factor in the equation, but also put one in the approximation of second initial condition.
通过测试数据拟合的稳态功率-电流方程，为设计红外模拟系统控制方案提供依据。
The steady state power-electric current equation by test data fitting provides the basis to design controlling project of infrared simulator.
对一个非球面反射镜进行了实测并对测量结果进行插值运算，进而拟合出零件面形的曲线方程。
An aspherical reflector is tested and testing data are processed by the interpolation calculation, then the curve equation of the component surface shape is fitted.
此外，用相关指数来检验曲线回归方程的拟合程度，而不采用在类似的研究中用相关系数来检验曲线回归这一不合适的方法。
Moreover, the fitting degree of curvilinear regression equation is tested by correlation index, in stead of correlation coefficient which has been unsuitably used for testing in similar works.
并得到相应的通量和截留率的拟合方程。
利用FAE静爆试验爆炸场的实测数据拟合出爆炸场特征方程，进而预估出FAE对人员毁伤的伤亡等级范围(威力圈)。
Based on the analysis of characteristics of explosive field formed by FAE, characteristic equation is fitted with trial data. Then the range of casualty ranking of FAE is deduced (the power range).
给出了冰蓄冷系统乙二醇管道水力计算方法和适用于CAD的拟合方程。
Provides a hydraulic calculation method of EG Pipes in ice storage systems, and some fitting equations for CAD.
根据不同条件下的拟合方程，对其回归系数进行了影响因素的分析。
From different fitting equations under different conditions, regression coefficients were also analyzed.
编制了程序，能自动拟合回归方程。并进行方差分析和回归效果的显著性检验；
The program designed may imitate the . regression equation automatically, engage in variance analysis and significance test for regression effects.
用这种方法可以求得最佳拟合直线方程和最小的非线性误差。
Using this method optimum imitative straight line equation and minimum non-linear error can be got.
采用核子的磁力相互作用拟合出核键方程，与磁极点作用能公式无矛盾。
A nuclear bond equation obtained by regression of the magnetic interaction between nucleons coincides with the interaction between point magnets.
采用核子的磁力相互作用拟合出核键方程，与磁极点作用能公式无矛盾。
A nuclear bond equation obtained by regression of the magnetic interaction between nucleons coincides with the interaction between point magnets.
应用推荐