多路数据传输总线的性能决定着装甲车辆电子综合化系统的优劣。
The multiplex bus's capability decides the quality of integrate electrical system.
微小卫星本身不复杂，研究把各种新技术应用于微小卫星是其中的应用热点，而总线数据传输和管理是其中相当关键的一部分。
Although Small satellite is not so complex, the research on new technology in satellite is paid more attention to while temperature control and management of bus data transmission is the key point.
考虑到现场的环境干扰较强，对总线电缆及CAN控制器、驱动器采用了冗余设计，保证数据传输的可靠性。
Considering strong disturbance environment in the field area, redundant design in bus cable, CAN controller and driver is involved to assure the reliability of data transmission.
这种接口采用点对点架构，外周设备协商解决总线冲突问题，以确定哪个设备控制数据传输最佳。
This interface uses a peer-to-peer architecture in which peripherals negotiate bus conflicts to determine which device can best control a data transfer.
重点介绍了通过软件设计由FPGA来实现PC104总线数据传输控制；
This paper emphasizes on using FPGA realizing the data transmission control of PC104 bus through the soft-ware.
第四章讨论总线管理，阐述了数据传输、流量控制和差错控制在网络式仪器总线中的实现。
In chapter four, describes the bus management, and discussed the implementation of data transfer, flow control and error control in the network-stye instrument bus.
VME总线控制器是VME总线系统的关键设备，具有完整的VME总线数据传输能力。
VMEbus Controller, which has the complete data transfer capability, is the key device of the VMEbus system.
该系统从功能上可以分为数据采集模块、无线数据传输模块、通用串行总线接口传输模块。
The system can be divided into three modular by function, sensing data acquisition part, wireless data transmitting part, and universal serial interface part.
本文将嵌入式计算机技术，虚拟仪器技术和CAN总线数据传输技术引入到车载仪表中，设计、研制了嵌入式车载虚拟仪表。
In this paper, the embedded technology, virtual instrument technology and CAN bus technology have been applied to design, and manufacture the onboard virtue instrument.
并通过设计和编写接口应用驱动程序，实现了基于PCI总线方式下数据传输的中断和查询两种方案。
By designing and compiling interface application driving program, the interrupt and query schemes of data transmission based on PCI bus are realized.
解决CAN现场总线在网络带宽利用率高时，数据传输的实时性问题，尤其是保证了低优先级信息的实时性；
The real-time problem of the data transfer was solved and especially for the lower PRI information when the utility of controller area network (CAN) fieldbus was high.
同时，系统中利用了现在已经较成熟的CAN总线技术，实现了有线和无线相结合的数据传输系统。
Meanwhile, the system USES the mature CAN bus to realize the data transfer system with wire and wireless.
分析了工控领域广泛应用的现场总线PROFIBUS-DP与MODBUS的协议结构与数据传输方法、设计协议转换网关的可行性以及网关的电路设计与工作流程。
The structures of two widely used fieldbus, i. e. , PROFIBUS-DP and MODBUS are analyzed, as well as the data transmission methods and the feasibility to design the protocol conversion gateway.
这将传统的个人计算机上的USB总线管理体系微型化，使用到嵌入式设备内部，使得嵌入式设备的数据传输更为简洁。
Traditional management system of USB Host on PC are introduced in embedded instruments or devices, which makes convenience of data transport of these devices and instruments.
RETHER是一种基于以太网的定时令牌总线协议，能够对数据传输提供实时性能。
RETHER is a timed-token-passing bus protocol based on Ethernet. It provides the real-time transfer performance.
地址总线为数据传输指明内存位置(地址)。
The address bus specifies the memory locations (addresses) for the data transfers.
系统采用半双工式RS- 485总线型通信网络和累加和校验通信算法进行数据传输。
System adopts RS-485 bus communication network which way of communication is half duplexing and accumulate and check-up communication algorithm, which are carried on data transmission.
以自行开发的PCI总线存储卡为背景，详细论述了PCI总线的信号定义和命令操作，以及总线上的数据传输过程。
Based on the designed PCI bus memory card, the signal definitions and command operations of PCI bus and the process of data access on the PCI bus are discussed in detail.
片外存储系统的访存延迟主要由DRAM延迟决定，带宽则是由内存总线的数据传输率所决定。
Off-chip memory latency is mainly determined by DRAM latency, and memory bandwidth is determined by data transfer rate through the memory bus.
基于串行总线的异步通信是一种实用高效的数据传输方式。
The serial asynchronous communication is an efficiency data transfer method.
数据传输部分采用的是在工控领域中应用广泛的CAN现场总线进行传输。
CAN field bus ACTS as data transmission, which has been extensively applied to industrial automatic control.
本文提出了一种使用通用并口进行数据采集的方法，能在多种场合下使用，其数据传输率可以接近IS A总线。
A data collecting method with general parallel port can be used in many occasions. Its data transfer rate approaches the rate of ISA bus.
介绍了上海通用别克GL型轿车二级串行数据总线的工作原理，论述了其一起数据传输特殊故障的诊断与排除。
The operation principle of two-stage serial data bus for Shanghai GM Buick GL car was introduced in this paper, a special trouble diagnosis and shooting was also discussed.
介绍在CAN现场总线控制网络中保证优先级较低站点数据传输实时性的有效方法。
This paper introduces that a real time transmission of some low priority stations can be guaranteed in CAN field bus control network.
介绍了采用CPLD实现DSP芯片TMS320C6713和背板VME总线之间高速数据传输的系统设计方法。
The method of using CPLD to realize high speed datatrasmission between DSP chip TMS320C6713 and VMEbus onthe backboard is described.
在基于VME总线或CPCI总线的雷达信号处理机中，板与板之间的数据传输速率受限于总线的速率。
The data transfer rate between varied boards in radar signal processors based on VME or CPCI bus was limited by the bus rate.
在基于VME总线或CPCI总线的雷达信号处理机中，板与板之间的数据传输速率受限于总线的速率。
The data transfer rate between varied boards in radar signal processors based on VME or CPCI bus was limited by the bus rate.
应用推荐