模拟信号采集模块和数字信号采集模块是本系统与外部信号的接口。
Aanalog signals acquisition module and digital signals acquisition module are the interface between the system and the external signals.
在电路设计过程中，对后级接口电路进行了最优化设计，采用VHDL描述的方式实现了低压数字延时电路模块的设计。
In this paper, the optimization method was used to design the interface circuit, and use VHDL description to design low voltage digital delay timer.
为了提高数字信号处理速度，现在一些实现专用算法的DSP模块和通信接口也由FPGA或者CPLD实现。
In order to improve digital signal processing speed, dedicated algorithm to achieve some of the DSP and communication interface module also realized by the CPLD or FPGA.
主要介绍CPCI数字存储示波器模块的模拟通道设计、A/D采样设计、数字控制电路设计、电源设计以及CPCI接口设计。
The hardware design of the module mainly presents analogue channel circuit design, A/D acquisition circuit design, digital control circuit design, power and CPCI interface design.
现在的问题是，模拟和数字模块之间的接口，直至最后一分钟才做测试，因为这些团队没有一起工作。
The problem is that the interface between the analog and digital blocks is not tested until the last minute because these teams aren't working together.
该测试平台主要由下面几个部分组成：usb接口、数字存储式示波器模块、信号源模块、以及配套软件等。
This instrument platform mainly consists of digitizing storage oscilloscope module, signal generator module, USB interface circuit and corresponding software.
在简要地介绍了单兵短波数字通信系统的基础上，给出了MGLS12864T点阵液晶显示模块与第三代数字信号处理器(DSP)TMS320C31的硬件接口电路。
Firstly, the data communication system on short-wave for single soldier is present in brief. And then the hardware interface between the lattice LCD MGLS12864T and the 3g DSP TMS320C31 are introduced.
简要介绍了数字信号处理器TMS320LF2407A的串行通信接口模块及其串行通信接口电路。
This paper introduces the serial communication interface(SCI) module and the interface circuit of TMS320LF2407A.
简要介绍了数字信号处理器TMS320LF2407A的串行通信接口模块及其串行通信接口电路。
This paper introduces the serial communication interface(SCI) module and the interface circuit of TMS320LF2407A.
应用推荐