该放大器具有电源隔离电路和带宽限制，以减少振荡和汽船排气声。
The amplifier has a power isolation circuit and bandwidth limiting to reduce oscillations and motorboating.
对单电源、低功耗应用，在放大器的一些有限的选择面前，要达到适当的带宽和所需的精度，无疑对系统设计提出了重大的挑战。
Achieving adequate bandwidth and required PRECISION with a somewhat limited selection of AMPLIFIERs presents significant SYSTEM design challenges in single-supply, low - POWER applications.
补偿可以按照放大器的具体带宽进行。
Compensation should be chosen on the basis of amplifier bandwidth.
这种运算放大器具有较高的动态范围，并解决了偏置电压引起的信号摆幅受限的问题，而且具有更高的带宽。
This kind of operational amplifier has higher dynamic scope and has solved the problem that the signal amplitude gets limit by the bias voltage, and has higher bandwidth.
基于系统温度分辨力的要求，对光学系统的相对孔径及选频放大器的带宽进行了优化设计。
Bandwidth of amplifier and relative aperture of optical system are optimized based on the requirement of temperature resolution.
除了多级光纤放大器(EDFA)使带宽减小，噪声增大，光纤的材料色散也是对WDM系统影响的重要因素。
Besides multistage EDFA making the bandwidth reduced and noise increased, the material dispersion of optical fibers is also an important factor to affect WDM systems.
跨阻放大器(TIA)采用全差分结构，利用震荡反馈技术和可调节共源共栅(RGC)结构来增加其带宽。
The transimpedance amplifier (tia) takes a fully differential configuration, feedback oscillation technique, and regulated cascode (RGC) input stage for bandwidth enhancement.
该放大器采用有源电感负载技术和放大器直接耦合技术以提高增益，拓展带宽，降低功耗并保持了良好的噪声性能。
Active inductor loads and direct-coupled technology are employed to increase the gain, broaden the bandwidth, reduce the power dissipation, and keep a tolerable noise performance.
该限幅放大器的设计采用了电容中和技术来实现带宽的扩展，可满足2。
This limiting amplifier USES capacitance neutralization technology to improve bandwidth and can satisfy 2.
新的设备具有的LDMOS的射频带宽的两倍，这样，一个功率放大器（PA）的可支持多个工作频率。
The new devices have twice the RF bandwidth of LDMOS, so that one power amplifier (PA) can support multiple operating frequencies.
实验表明减法运算放大器增益带宽是硬件方法的关键。
Experiments showed that the gain-bandwidth of the subtracting operational amplifier is the key of hardware method.
在带宽限制放大器电路的设计中使用了全差分运放结构，能有效抑制电路的共模噪声。
A fully differential operational amplifier is introduced in the design of wideband limiting amplifier which can restrain the common noise effectively.
使用文中介绍的方法设计单电源运算放大器能巧妙地解决由偏置电压引起的信号摆幅受限的问题，有较高的动态范围，而且具有比交流耦合更高的带宽。
The novel design solved the problem of limited voltage swing range caused by bias voltage at input of the OPA and achieved higher bandwidth compared to ac coupled design method.
每个ADC均具有宽带宽、差分采样保持模拟输入放大器，支持用户可选的各种输入范围。
Each ADC features wide bandwidth differential sample-and-hold analog input amplifiers that support a variety of user-selectable input ranges.
与传统分布式放大器相比，该结构形成的放大器具有较高的增益和较宽的带宽。
Compared with traditional distributed amplifiers, the new structure has shown its higher gain and wider bandwidth.
每个ADC均具有宽带宽、差分采样保持模拟输入放大器，支持用户可选的各种输入范围。
Each ADC features wide bandwidth differential sample-and-hold analog input amplifiers supporting a variety of user-selectable input ranges.
对发散光束抽运的光参量啁啾脉冲放大器的增益带宽进行了系统的理论研究。
The gain bandwidth of optical parametric chirped pulse amplification pumped by divergent beams has been theoretically studied.
光放大材料是光放大器的重要组成部分，它决定光放大器的光放大功率及平坦增益带宽。
Materials with light amplification is a main part of light amplifier, which determine the power efficiency and flat gain bandwidth of light amplifier.
利用该程序研究了椭圆波导FEM放大器的输出功率、效率、带宽等高频特性，并对不同椭圆度的椭圆波导FEM放大器的性能进行了计算、对比分析。
The characteristics of FEM amplifier with elliptical guide, such as the evolutin of power, efficiency and bandwidth, are analyzed. These results are useful to design FEM devices.
运用一阶单时间常数低通函数模拟运算放大器的开环增益，对RC桥式振荡电路进行线性分析，得出最大振荡频率为运算放大器增益带宽积的16.67%。
The maximum frequency of RC-bridge oscillator is 16.67% of gain bandwidth product of amplifier analyzed based on a first-order single time constant lowpass function model.
代表的EL5292和EL5292A具有非常高的带宽600MHz的双电流反馈放大器。
The EL5292 and EL5292A represent dual current feedback amplifiers with a very high bandwidth of 600MHz.
作为光接收机前端的关键部分，限幅放大器要求具有高增益，足够带宽以及较宽的输入动态范围。
As the key component of optical receiver, design of a high-speed limiting amplifier with high gain, broadband and a wide dynamic input range is required.
该EL 5392a是三重一非常高的带宽为600mhz电流反馈放大器。
The EL5392A is a triple current feedback amplifier with a very high bandwidth of 600mhz.
对低噪声放大器的基本要求是：噪声系数低、足够的功率增益、工作稳定性可靠、足够的带宽和大的动态范围等。
The basic requirements of the LNA include: low noise figure, enough power gain, reliable work stability, sufficient bandwidth and the wide dynamic range.
从理论和实验上研究了长周期光纤光栅用于掺铒光纤放大器自发发射谱增益平坦展宽的特性、自增益谱的荧光峰和可用带宽。
In this paper, the properties of ASE gain flattened of EDFA are studied based on energy level and particle number shifting of EDFA both theoretically and experimentally.
如果使用如图1电路的电流反馈放大器，放大器闭环带宽较少的依靠闭环增益和输入通道数。
If you use a current-feedback amp with the circuit in Figure 1, the amplifier's closed-loop bandwidth depends less on the closed-loop gain and the number of input channels.
与采用传统的电压放大器相比，实现了恒定的增益带宽、高线性度、高精度和较低的功耗。
Compared to conventional voltage amplifier, the constant bandwidth, high linearity and precision, and low power are achieved.
电压反馈放大器的电路带宽等于增益带宽积除以噪声增益。
This circuit's bandwidth, with a voltage-feedback amp, equals the gain-bandwidth product divided by the noise gain.
电压反馈放大器的电路带宽等于增益带宽积除以噪声增益。
This circuit's bandwidth, with a voltage-feedback amp, equals the gain-bandwidth product divided by the noise gain.
应用推荐