随载荷的增大摩擦系数减小；
The friction coefficient decreases with the increase of load.
分析表明，载荷、密封间隙、橡胶密封筒高度对应力最大值有影响，而摩擦系数影响很小。
The result shows that load, seal gap and seal height have influence on the maximum stress while friction coefficient has little influence on it.
文中以一菌型叶根为对象，分析了界面摩擦系数和初始间隙对接触力分布、载荷分配及最大应力的影响。
Aimed at a straddle blade root, the influence of the interface friction coefficient and initial clearance on the contact force distribution, load distribution and the maximum stress is analyzed.
而镍与APS间的摩擦系数随滑动速度的增大而增大，随载荷的增大而减小。
However, the friction coefficient between Ni and APS increased with sliding velocity increasing and reduced with load increasing.
考察了载荷和速度等可控因素对这种轴承摩擦系数的影响。
The influence of some controllable factors, such as load and speed, on the friction coefficient of the bearing was investigated.
用BP人工神经网络建立了重载丝杆螺母副的摩擦学特性与载荷之间关系的磨损自补偿数学模型。
The BP neural network used the wear-self-compensation mathematics model of the relationship of tribology characteristic with load of the heavy load screw-nut pairs was established.
根据对碳素钢进行的干燥滑动摩擦磨损试验结果，对碳素钢的磨损量、磨损形态与载荷的关系加以分析。
According to the friction and wear experimental results of dry slide of carbon steel, this paper analyses the relationships between the wearing amount, types of carbon steel and load.
在研究中还发现，钛合金及钛金属陶瓷的摩擦系数都存在明显的载荷依赖性，但二者具有相反的变化趋势。
The friction coefficients of both titanium alloy and titanium cermets showed a remarkable load dependence, but had a totally different trend.
静摩擦系数不是简单的随载荷的增加而减小。
The static frication coefficient does not simply decrease with the increase of load.
摩擦力大小和方向的改变，将使因高温高压产生的较大载荷无法向远处扩散，从而引起油管局部严重变形。
The fiction can prevent large loads caused by high pressure and high temperature from spreading, which can result in severe deformation in a short part of tubing.
试验中得到了载荷、变形度和摩擦力相互问的确切关系。
The precise relation among the load, degree of deformation and friction is found on the experimental results.
对于致密有序的自组装分子膜，在摩擦力与载荷间存在“平台”效应。
There existed a "Platform" effect between the frictional force and the load for fine packed OTS self-assembled molecule film.
自动调节气压卸荷导轨利用压缩空气支承部分导轨载荷，以降低导轨面上的正压力，从而降低摩擦力。
In the automatic regulating pneumatic unloading guideways the compressed air is used to support part of the guideway load in order to reduce the normal force on the guideways.
通过有限元模拟，进一步研究了整形温度、摩擦系数对最大载荷的影响规律，为此类零件的局部精整工艺制定提供了理论参考。
Then the FEM simulation was applied to study the influence of friction factor and initial forging temperature on maximum forming force, which provided reference on finishing process for similar parts.
随着载荷的增加其摩擦系数略有增加；
主要分析差动滑动和弹性滞后等因素对承受预加载荷下的滚动直线导轨副摩擦力的影响，得出了过盈量与摩擦力的关系。
The effect of differential sliding and elastic hysteresis on the frictional force in the rolling linear guide (LG) subjected to preloading is analyzed.
磨损达到稳态后载荷对复合材料摩擦系数的影响不大。
The effect of load on the friction coefficient becomes small during the steady stage of wear.
结果表明，在相对较低的载荷下，复合薄膜比硬脂酸钾薄膜具有更好的摩擦学性能。
It was found that the composite films on the hydroxyl-terminated silicon substrate showed better tribological properties as compared to potassium stearate films under relative lower load.
梯度薄膜在较大的载荷条件下，具有良好的滑动摩擦性能。
The gradient(Ti, Nb)N film possesses better sliding friction property under higher loads.
研究了铝合金及不同成分复合材料在不同温度及载荷下的摩擦系数和磨损率；
The friction coefficients and wear rates of the aluminum alloy and composites reinforced with ceramics of different volume fractions were measured at various temperatures and loads.
研究了铝合金及不同成分复合材料在不同温度及载荷下的摩擦系数和磨损率；
The friction coefficients and wear rates of the aluminum alloy and composites reinforced with ceramics of different volume fractions were measured at various temperatures and loads.
应用推荐