理论上来说,这正是模拟了传统油门控制方式中油门线在刹车套管中动作时产生的摩擦力。
It simulates the intrinsic friction that is present in the traditional throttle cable as it passes through the cable housing.
对拉丝工艺中的反张力与界面摩擦系数及产品性能间的关系作了理论和实践方面的详细论述。
In this article, relations among reverse tension, friction coefficient and quality of wire are discussed in theory and practice of cold drawing process in detail.
滑动摩擦系统是一种本质非线性振动体系,尚有许多理论和工程实际问题有待解决。
In nature, a sliding friction system is a nonlinear vibration one, there are still many problems, in theory and practical engineering, to be solved.
现有的资料及文献对O形密封圈产生摩擦阻力的理论计算方法介绍甚少。
The theoretical calculation method for the friction resistance produced by O-sealing washer is seldom expounded in existing referance materials and document.
从理论上分析了滑动摩擦对接触变形的影响,给出了压陷量的修正公式,并通过试验加以验证。
This paper analyzes the influence of sliding friction on contact deformation in theory and demonstrates it by means of test.
理论上,一个无摩擦力的,或者说是理想的机器,输入和输出的功相等,因此效率是1,或者说是100%。
In a theoretically frictionless, or ideal, machine, the work input and work output are equal, and the efficiency would be 1, or 100%.
对于上述三个方面的研究,本论文将主要采用已有的摩擦学原理,纱线结构理论,及气圈理论来进行研究。
This dissertation will use the frictional theory, the yarn structure theory and the balloon theory to research these three content.
通过应用模糊设计理论和可靠性设计理论,建立了摩擦力作用下直齿圆柱齿轮传动的模糊可靠性优化设计的数学模型,并对其进行优化处理。
In this paper, the fuzzy reliable optimum design's mathematical model of the spur gear under the action of the sliding friction is set up by using the fuzzy and reliable theory.
基于分形几何理论,推导出了滑动摩擦力分形预测模型,并从理论上对该模型的正确性进行了分析。
A fractal prediction model of sliding friction forces was derived based on the fractal geometry theory. The validity of the model was verified theoretically.
本文以常见的力学现象为例,从理论上阐述判断静摩擦力方向的方法及作功问题的证明方法。
From the common mechanical phenomenon, present a theoretical method on how to judge the direction of static friction force.
运用部分膜承载热弹流理论计算齿轮传动中的滑动摩擦力和滚动摩擦力。
Upon the theory of hot elastohydrodynamics about part film load bearing, the sliding and rolling friction forces in gear transmission device can be calculated.
力学原理是动画设计的理论基础,其中重力、空气阻力、地面摩擦力以及惯性力、弹力原理在动画设计中运用较多。
Mechanics principle is the theoretic foundation of animated drawing design, especially, gravity, air resistance, ground friction force and inertia force, elasticity principle are used abroad.
本文首先简要介绍节理形貌的描述方法和分形几何理论,然后将分形理论引人岩体节理摩擦角的研究中,得出了用分形维数表示摩擦角的经验公式。
In this Paper the joint profile expression and fractal theory are reviewed, and the fractal theory is used to study the frictional Angle of the rock joint.
通过对摩擦力形成理论的归纳与分析,提出了金属切削力等效于刀具—工件副间摩擦力的新概念,由此导出了计算切削颤振系统阻尼系数的方法及相应结论。
Through inducing and analyzing the formation theory of friction, the article advances a new concept that the metal cutting force equals the friction of the tool and workpiece.
从而为这种非牛顿流体在摩擦学中的应用提供了理论分析基础。
Therefore, the basis of theoretical analysis is presented for the application of non-newtonian fluid in tribology.
基于磨粒识别分析的结果,并结合摩擦学理论,实现对发动机磨损状态检测与故障诊断。
Depending on the result of debris analysis and combing with tribology knowledges, we can diagnose and predict wear fault of engine.
采用模糊集理论,提出了一种模糊反演疏水沉降地层井筒负摩擦力的分析方法。
By applying theories of Fuzzy sets, proposal is offered of an analytic method of Fuzzy inversion of negative friction on shafts through DE watered subsiding grounds.
在纳米摩擦学中,目前应用得比较多的是分形几何理论。
In nano-tribology, the fractal geometry theory is widely used presently.
进而采用该解绘制塑性加工中测量摩擦系数的理论校准曲线。
The theoretical calibration curves for friction of plastic working was plotted and the exact position of the neutral layer of plastic flow was given in the solution.
从理论上对多缸内燃机缸套活塞系统摩擦学与动力学的耦合问题进行了研究。
The coupling problem between the dynamic behaviors and the tribological behaviors of the piston-liner systems in multi-cylinder internal combustion engines was studied.
本文提出了一种可以很好地解释在磁盘驱动器中头盘界面之间的吸附机理和滑动摩擦机理的理论。
To study the adsorptive mechanism and sliding frictional mechanism between the head and disk of the magnetic disk unit, a qualitative analysis theory is given in this paper.
从理论上对两个定义下的矩形管道单位长度摩擦阻力进行了分析和论证。
Friction resistance of unit length of rectangular pipeline under the two definitions was analyzed and demonstrated theoretically.
本文分析了斜面-滑块问题现有解答的理论缺陷,得出了库仑静滑动摩擦定律在这一基本问题中的适用范围。
This paper analysed the theoretical shortcoming of the conventional method solving the oblique plane-block problem. The applicable range of Coulomb's friction Law in the fundamental problem are given.
对驻波马达的驱动机制进行了细致的分析,从理论上得到各种预压力情况下马达的最佳驱动状态,并定性分析了马达在摩擦力驱动下的驱动特性。
The driving mechanism of the standing wave motor is analyzed in detail, the optimal driving status in various pressures is obtained, and its diving character is given qualitatively.
然而,至今只有岩土极限分析与塑性力学中考虑岩土体的内摩擦力,而在弹性理论与能量理论等诸方面均未体现。
However, until now the internal friction is only considered in limit analysis and plastic mechanics, but not included in elastic mechanics and energy theory.
其理论完整,在力学、物理学、光学、摩擦学、经济学、宇航理论、信息论和自动控制论等诸多方面有广泛的应用。
Its theory is complete and has extensive application in mechanics, physics, optics, tribological, economics, aerospace theory and automatic control theory, etc.
通过有限元模拟,进一步研究了整形温度、摩擦系数对最大载荷的影响规律,为此类零件的局部精整工艺制定提供了理论参考。
Then the FEM simulation was applied to study the influence of friction factor and initial forging temperature on maximum forming force, which provided reference on finishing process for similar parts.
以静压气浮导轨为研究对象,对导轨气浮块底部气体压力的二维分布规律及影响摩擦力的因素进行了理论分析。
Aimed at aerostatic guideway, a two dimensional distribution of air pressure and effect factor on the friction force were analyzed under high speed working conditions.
以静压气浮导轨为研究对象,对导轨气浮块底部气体压力的二维分布规律及影响摩擦力的因素进行了理论分析。
Aimed at aerostatic guideway, a two dimensional distribution of air pressure and effect factor on the friction force were analyzed under high speed working conditions.
应用推荐