利用弹性理论，分析推证出了裙式支座搭接焊逢内的应力分布规律及其定量解答。
According to the elastic theory, this paper gives partition Law of stress and quantitative answers over the overlap joint weld on skirted support.
扁钢与扁钢焊接应采用搭接焊，搭接长度至少为扁钢宽度的2.5倍，且至少3边焊接。
The overlapped length should be at least 2.5 times of the width of the flat steel, and at least 3 edges need to be welded.
搭接贴角焊接金属薄板的老方法，现今已基本上为对接坡口焊所取代。
The old method of soldering metal sheets together has now been largely replaced by welted joints, which are made by a special efficient mechanical device.
这些元素可以以不同方式组合在一起，例如：一个搭接接头可能用角接、塞焊和缝焊固定，一个丁字接头可以用一个搭接或槽焊来完成。
The elements can be put together in various ways. For example, a lap join may be held by a fillet, plug, or slot weld, and and a tee joint by a fillet or groove weld.
通过优化搭接焊形式能提高焊接接头的最大剪切力。
The maximum shear strength of welded joints can be increased by optimizing the form of lap welding.
指出了在承力结构中应该尽量避免搭接焊。
It suggested lap joint should be avoided in load carrying structures.
引进国内、国际先进工艺，拥有大功率电阻搭接焊生产线；
The introduction of domestic and international advanced technology, with high-power resistors Overlap welding production line;
引进国内、国际先进工艺，拥有大功率电阻搭接焊生产线；
The introduction of domestic and international advanced technology, with high-power resistors Overlap welding production line;
应用推荐