设计了基于CAN总线的地址编码器,通信总站的数码显示电路,控制继电器电路,LNK501开关电源芯片电路。
Design the CAN bus address encoder, communication terminal digital display circuit, control relay circuit, LNK501 switching power supply chip circuitry.
抖动,说明极有可能是消磁电阻损坏,如果没有响声则可能继电器及其控制电路有问题。
Jitter, that is very likely damage degaussed resistance, in the absence of sound may be the relay and control circuit problem.
电子模块取代原有的继电器,直接实现对道岔、信号机、减速器的控制和对轨道电路的状态识别。
Electronic modules, instead of traditional relays, perform directly the control of switches, signals and retarders and identification of the status of the track circuits.
使用继电器、接触器、按钮、空气开关、行程开关等低压电器构成的控制电路称为继电接触控制电路。
Use relays, contactor, button, air switch and travel switch etc low-voltage constitute control circuit called relay contact control circuit.
无集成电路控板,采用继电器程序控制。
No integrated circuit control board, adopts relays to control the sequence.
控制电路通过水位检测信号,利用继电器和接触器控制排水机构。
The control circuit controls the water drainage mechanism using a relay and a contactor by the water level detection signal.
对采用继电器控制系统进行控制的某实验室船舶燃油辅助锅炉,采用计数法进行可靠性评估,得出控制电路的平均无故障时间。
The reliability lab ship fuel oil donkey boiler controlled by relay control system is evaluated using counting method, and mean time to failure (MTTF) of the control circuit is educed.
本文提出电流继电器控制绕线式异步电动机起动电路改进方法,并对改进电路优劣进行了分析。
A method in the improvement of current relay controls winding asynchronous motor starting circuit is put forward, and the merit, demerit of it are described in the paper.
刮水器间歇控制与刮水器控制开关、刮水间歇控制继电器及其在刮水器工作电路中的控制方式有关。
The intermittent control of wipers is related to the control switch, control relay and its control mode of the wipers operating circuit.
电路中设置的温控继电器开关装置,使取暖床垫达到了自动恒温控制目的。
The temperature control relay switch device arranged in a circuit ensures that the warming mattress realizes the aim of automatic constant temperature control.
设计和实现了一种采用工控机与温度模块、PWM输出卡、固态继电器及相关控制电路搭建的计算机电阻炉温度控制系统。
Temperature computer control system of a resistance furnace is designed with industry person computer (IPC), temperature input module, PWM output card, solid state relay(SSR) and interrelated circuit.
介绍了利用固态继电器组成的电机控制、保护、运行状态显示装置的电路组成和工作原理。
This paper exemplifies the circuit construction, the function and working principle of the device of control, protect and working state display of electric maching using solid state relay.
电流互感器通常与电流表、控制电路、保护继电器配套使用。
Current transformers are commonly used in metering and protective relays in the electrical power industry.
电路板往往被置于从电气上控制继电器开路和闭合的设备上。
The boards are often placed in a mainframe that electronically controls the opening and closing of the relays.
要切换到压缩机,可以通过电流接触器开关,继电器或者双向可控硅来控制电流盒或者电路板。
Control electric box or circuit board with contactor, relay, or triac that switches to the compressor.
本文介绍了一种由8031单片机控制的三参数电池检测仪。该检测仪全部采用无触点继电器和集成电路实现,具有较高的可靠性和抗干扰能力。
The three-parameter battery tester controlled by 8031 chip microcomputer was described. The tester was made of contactless electric relays and IC. Its reliability and noise immunity were high.
操作表示机是计算机联锁系统中关键的人机界面设备,硬件上利用继电器组成的逻辑电路,实现双机热备的倒机逻辑控制和设备接口电缆的动态切换。
Therefore it is necessary to perfect the existing relay equipment based on the rule of fault-safety in order to achieve the function of railway signal computer-based interlocking control system.
本文将机车继电器控制电路等效为数字组合逻辑电路,建立了它的固定故障等效模型。
The electric locomotive bang-bang circuit is converted into an equivalent digitalcombinational logic circuit for setting up its stuck-at fault model.
本文以常见的继电器顺序控制电路为例,重点分析了在设计有触点的电器控制线路及实际应用中,常常忽视的临界竞争问题。
Based on usual circuit, this paper analyzed the critical competition in the design of electric appliance control of circuit with contact.
本文介绍了温度继电器自动测试系统的设计,此系统由温控箱、开关量检测电路、温度控制电路、接口电路及工控机等硬件组成。
This system was composed of a temperature controlled tank , switch measurement circuit , temperature control circuit , interface circuit , an industrial manipulative computer, and so on.
微处理器和微控制器取代模拟电路在静态继电器用于实现中继功能。
Microprocessors and micro-controllers replaced analogue circuits used in static relays to implement relay functions.
该电路采用晶体管门电路及可控硅代替继电器进行程序控制。具有体积小、成本低、使用稳定可靠、抗干扰能力强、控制精度高等优点。
By using gate control and SCR rectifier circuit instead of relay control system, it makes the unit smaller, cost lower, reliability higher and control function more accurate.
在分析和设计继电器-接触器控制电路时,往往忽视临界竞争现象,结果造成电气控制达不到预期目的,甚至造成事故。
In the practice of analyzing and designing of relay-contactor circuits, the critical-competition phenomenon is usually ignored, causing failures in reaching the intended purpose or even damages.
主要部件是串联连接的一组继电器和电阻,通过微机控制继电器的状态可以使这一电路的阻值发生变化。
It employs several relays and the corresponding resistors, which are in series connection. By microcomputer control of the relays, different resistance can be obtained just like a regulation-resistor.
本实用新型属于一种控制焊机启闭的焊把式控制器,其主要由变压器、接触器、继电器、开关指示电路所组成。
The utility model belongs to a welding holder type controller used for controlling the on-off of a welder, mainly comprising a transformer, a contactor, a relay and a switch indicator circuit.
继电器连接在安装头与灯头之间,并在控制器的控制下接通或断开安装头至灯头的电路。
The relay is connected between the mounting head and the lamp head and for connecting or disconnecting the circuit from the mounting head to the lamp head under the control of the controller.
乘法电路的输出端通过继电器或输出电路连接除雾控制开关。
The output end of the multiplying circuit is connected with the demisting control switch through the relay or the output circuit.
在典型的R LC振荡放电电路中,引入5 5 5时基电路和水银继电器作为控制电路,设计了阻尼正弦瞬变信号发生器。
In typical R-L-C resonance circuit, the 555-time-circuit and mercury relay are used as control unit. A damped sinusoid source is designed. It has been proved that the source satisfies our request.
在典型的R LC振荡放电电路中,引入5 5 5时基电路和水银继电器作为控制电路,设计了阻尼正弦瞬变信号发生器。
In typical R-L-C resonance circuit, the 555-time-circuit and mercury relay are used as control unit. A damped sinusoid source is designed. It has been proved that the source satisfies our request.
应用推荐