脉冲宽度发生器404接收来自二极管405韵信号和选择信号。
The pulse width generator 404 receives a signal from diode 405 and a select signal.
扫频光源（SS）OCT使用波长扫频激光器光源，并使用平衡式光电二极管接收机作为检测器。
Swept Source (SS) OCT uses a wavelength swept laser source and photodiode balanced receiver as the detector.
本文介绍一种采用自扫描光电二极管列阵(SSPDA)作为激光干涉条纹接收器的新型单频激光干涉仪。
This paper describes a new mono-frequency laser interferometer using a self-scanning photoelectric diode array (SSPDA) as the receiving device of laser interference fringes.
它利用半导体激光器为光源，光电二极管阵列接收与表面粗糙度具有对应关系的散射光带。
It USES a laser diode as light source and a linear photodiode array to record the light-scattering band, which correlated to the surface roughness.
通过对大气衰减系数、放大器放大能力、光电二极管接收灵敏度等一些主要参数进行分析，建立了激光模拟系统的数学模型。
Secondly, the mathematical model of the laser simulation system is built upon the atmosphere attenuation, the amplifier extent, receiving-sensibility of photoelectric diode and other preferences.
带材正常运动时处于光柱的中心位置，光电二极管接收到的光功率为一定值；
When the web worked normally, it passed through the central axle of the light pole so that the optical power received by photosensitive diode was normal constant.
GJ-4型测头的光电接收器件使用高响应度的雪崩光电二极管，能够对一些弱反射表面获取到较好的测量信号；
Furthermore, the GJ-4 confocal probe uses an avalanche diode with high responsivity. Therefore, it can get better measuring signals from low-reflective surfaces.
系统采取调制光源作为探测信号，采用光敏二极管面阵作为接收组件，大大提高了系统的灵敏度和抗干扰能力。
Modulated light is used as detecting signal in this system, photodiode area array is used as receiving module, which greatly improves the sensitivity and anti-interference ability of the system.
在接收部分，本设计采用高速率的PIN光电二极管完成光信号的接收，并将接收到的光功率转换为电信号。
In this design, a high speed PIN photodiode is used in the receive part to receive the optical signal and convent it to the electrical signal.
楔形自扫描光电二极管列阵(CSSPA)是一个直接用于接收中心对称谱分布的二维空间光能量传感器。
The Cuneal Self Scanning Photodiode Array (CSSPA) is a 2-d spatial light energy sensor directly used for receiving central symmetric spectral distribution.
一种教学用演示电路板，由接收机、电池盒、舵机、触碰开关、发射机、舵盒、发光二极管组成。
A teaching demonstration circuit board consists of a receiver, a battery holder, a steering engine, a touch switch, a transmitter, a steering box and light emitting diodes.
一种教学用演示电路板，由接收机、电池盒、舵机、触碰开关、发射机、舵盒、发光二极管组成。
A teaching demonstration circuit board consists of a receiver, a battery holder, a steering engine, a touch switch, a transmitter, a steering box and light emitting diodes.
应用推荐