结果表明光纤的编入对材料的拉伸弹性模量和压缩弹性模量影响也较小。
Results show that co-braided optical fibers have just a small quantity of effect on the elastic modulus of the braided composites.
研究结果表明，复合材料拉伸弹性模量随增强体含量增加而升高，断裂延伸率下降。
It is shown that the elastic modulus increases with volume fraction of ceramic particles, though the fracture strain decreases.
PTT纤维具有良好的手感柔软性、拉伸弹性、尺寸稳定性等，因此适宜开发机织面料。
PTT has pleasant softness, high resilience and good dimensional stability, so it is suitable for making woven fabric.
在新原理图中，三组曲线分别是升温—降温、压缩—拉伸和拉伸弹性—塑性变形的分界线。
In the new diagram, 3 curves are heating up cooling down, compressive tensile and tensile elastic deformation tensile plastic deformation respectively.
测试了塑木板材的拉伸强度、弯曲强度、冲击强度、拉伸弹性模量、弯曲弹性模量等力学性能；
The tensile strength, bending strength, impact strength, tensile modulus of elasticity and bending modulus of elasticity were determined.
文章介绍了一种利用普通的智能电子拉力试验机配以计算机来计算塑料薄膜拉伸弹性模量的方法。
This article introduces a method to determine the plastic membrane tensile modulus by using a normal mart electron tensile testing machine and computers.
研究得出，进口毛织物的手感特征依次为纬向拉伸弹性、厚实性、硬挺性、经向拉伸弹性和尺寸稳定性；
The evaluation index of foreign wool fabric in turn is weft tensile elastic, think and heavy performance, stiffness, warp tensile elastic, and size stability;
拉伸弹性模量与压缩弹性模量有明显差异，木质部属各向异性材料，建立力学模型应采用各向异性的本构关系。
There is a distinct difference between tensile and compressive modulus. Xylem is a kind of anisotropic material and modeling its mechanical model needs anisotropic constitutive relations.
测试了针织泳衣面料的氨纶含量、拉伸弹性回复率及水中浮力，分析了氨纶含量与泳衣面料的弹性回复率及水中浮力之间的关系。
Tested the ammonia percentage of swimming suit fabric, its elastic recovery and buoyancy in water, and analyzed the relationship between ammonia percentage and the elastic recovery and buoyancy.
拉伸图片还会有伸缩弹性的感觉。
Stretching an image could result in an elastic kind of resistance.
大多固体，一经拉伸或弯曲，都会出现弹性变形这一过程。
Most solids, if pulled or twisted, will give a little in a process known as elastic deformation.
也许是你的鞋不好，检查你的脚看看是否需要更稳定和有弹性的鞋，同时试试垫高你的脚踵使得腓肠肌不被拉伸太多。
You might have the wrong shoes. Check your feet to see if you might need more stability and/or cushioning.
拉伸载荷模量约等于比例极限内的弹性模量。
The tensile modulus approximately equal to the compressive modulus of elasticity within the proportional limit.
由于依附于细支气管壁面上的肺组织具有相当的“弹性”，因此，这些毛细管构成的组织壁面由肺组织向外拉伸，进而使毛细管扩张。
Due to the fact that the lung tissue that attaches itself to the walls of the bronchioles has a certain "elasticity", the walls are pulled outwards, thereby expanding the bronchioles.
我离开了在后部弹性无拉伸，然后沿缝缝在它举行的地方。
I left the elastic unstretched in the back portion and then stitched over it along the seams to hold it in place.
结果得出了对照组和实验组动物肘关节尺神经拉伸最大载荷，最大应力，最大应变，弹性模量等数据。
Results We got out the data of stretch ultimate load, maximum stress, maximum strain, elastic modulus on elbow joint ulnar nerve between control group and experimental group.
提出了获取脆性材料动态拉伸强度及弹性模量的实验步骤及相关记录数据的分析方法。
An experimental procedure and accompanying method for analyzing recorded data for deriving dynamic tensile strength and elastic modulus of brittle material is presented.
特点：弹性好，有韧性，拉伸比大，能达到环保标准。
Feature: Good elasticity, resilient, great tensile ratio, achieving environmental standards.
通过湿热老化试验，研究了APMOC纤维吸湿性能、拉伸强度、断裂延长率以及弹性模量随老化时间的变化。
The changes of moisture absorption properties, tensile strength, fracture elongation and elastic modulus of APMOC fiber with aging time were investigated through the hygrothermal aging test.
整个焊接板由弹性变形区、压缩塑性变形区、拉伸塑性变形区和熔池组成。
Whole weldment includes practically elastic deformation zone, compressive plastic deformation zone, tensile plastic deformation zone and melting pool.
第一章综合论述了大豆蛋白纤维研究的国内外状况，以及简要介绍了大豆蛋白纤维织物在尺寸稳定性、拉伸性能、弹性等方面的一些相关理论。
The first chapter summarizes the research condition at home and abroad, and introduces some theory correlation to the dimension property, stretching property, elasticity of spandex fabric etc.
结果表明，不同角度圆锥口模挤出过程中，熔体在收敛流道受到拉伸流变，导致强烈的入口弹性效应，表现出熔体在不同角度圆锥口模挤出时有不同的挤出胀大比。
The results show that the extensional flow of melt in convergent die results in intense entrance elastic effect and distinct extrusion swell in conical die with different angles.
根据预拉伸铝合金厚板的特点，运用弹性力学理论推导出厚板内部残余应力测量的新方法。
According to the characteristics of the thick pre-stretched aluminum alloy plate, a new method of measuring the residual stresses in thick plate is deduced by the elastic mechanical theory.
本文研究了含中心微孔的超弹性矩形板在单向拉伸时的有限变形和受力分析。
In the present paper, the finite deformation and stress analysis for a hyperelastic rectangular plate with a center void under a uniaxial extension is studied.
介绍了涂膜拉伸强度、断裂时的延伸率，防碳化效应特性试验以及弹性外墙乳胶涂料施工应用技术。
Tests on film tension strength, elongation rate at breaking, anti carbonation effect etc. and applied technique of elastomeric latex coating for exterior wall are described.
测定了低温下聚氨酯硬泡沫塑料拉伸、剪切和压缩弹性模量与泡沫密度、方向以及温度的关系。
Measurements have been made to determine the relation of the tension, the compression and the shearing of PUR foam at low temperature with its density, direction and temperature.
选择适当的温度和拉伸比进行热定形，可提高PTT织物的断裂强力和弹性回复率，但其延伸性变差。
The breaking strength and resilient-elasticity recovery of PTT fabric can be increased under suitable temperature and drawing ratio during heat setting, but its dilatability took worse.
对于传统非织造材料，弹性差，经拉伸后回复率低是长期以来难以克服的一个缺点。
It is a severe shortcoming for traditional nonwovens that they have rather low elasticity and elastic recovery.
测试了不同层数玻纤布制成的玻璃钢拉伸强度和弹性模量。
The tensile strength and elastic modulus of glass fiber reinforced plastic(GFRP), which was made by different layers of glass fiber fabric, were tested and analyzed.
利用分子动力学方法研究了双晶铜在单向拉伸载荷作用下弹性性能的应变率效应和尺寸效应。
Molecular dynamic simulations were used to investigate the effect of strain rate and size on the mechanical properties of nano-bi-crystal Cu under uniaxial tension.
应用推荐