但是，目前的检测方式通常都是使用激光扫描，这些方式都价格昂贵并需要长时间的设定。
But current checking methods, generally involving laser scanning, are expensive and require lengthy set-up.
你可以设定daemon提醒你的预约，扫描附近的无线设备等等。
You can set daemons up to remind you of appointments, to scan for nearby wireless devices and more.
许多激光测量设备有显示最小和最大尺寸的设定；操作者必须只能沿着边缘点扫描。在测量对角线长度的时候这一点非常有用；
Many laser measuring devices have setting which shows minimum and maximum dimensions; the operator must merely scan the dot along an edge. This is helpful for taking diagonal measurements.
帧复位在用户通过重新设定照相机用于新的帧扫描的控制情况下结束。
Frame reset ends frames under user control by resetting the camera for new frame scanning.
深入分析会自动开始扫描，请按「停止」， 以作其后的设定。
Scanning will start automatically, please click "Stop" so that we can change some settings.
扫描采样率对成像质量至关重要，可通过驱动信号的频率选择和图像采集时间的设定来控制。
The scanning sampling density crucial to imaging quality can be deliberately controlled by setting of the driving frequencies as well as fetching duration.
源码爱好者注：如果设定的端口扫描范围较宽的话，程序可能出现假死。
Source enthusiasts Note: If you set a wide range of port scan, the program may be suspended animation.
管理员可设定网络有若干范围。你可在此选择要扫描的范围。
An administrator can configure the network to have several scopes. If this is the case, you can select the scope to scan here.
定时空闲运行功能，可设定球机空闲一段时间后，自动调用预置位、预置位巡航扫描、花样扫描、水平扫描、看守位等；
Auto activation at fixed time, and can auto execute different scans and presets after a given leisure time.
在NOD32手动扫描器中，按“动作”页面，再按图中所示作出设定，最后按“检查及清除”。
In the NOD32 manual scanner, press "Action" TAB and make changes referring to the following picture. After that, press "scan and Clean".
被合成的频率扫描信号的起始频率、终止频率和扫描时间可根据需要随意设定，并且可以实现对三者的精确控制。
Start frequency, stop frequency and sweep time of the signal synthesized by the method can be preset freely and controlled accurately.
被合成的频率扫描信号的起始频率、终止频率和扫描时间可根据需要随意设定，并且可以实现对三者的精确控制。
Start frequency, stop frequency and sweep time of the signal synthesized by the method can be preset freely and controlled accurately.
应用推荐