成核机理和稳定性是无皂乳液聚合的关键。
The nucleation mechanisms and colloid stability are the key aspects of emulsifier free emulsion polymerization.
结果表明：4VP/BA的无皂乳液聚合遵循均相成核机理。
The results indicate that the soapless emulsion polymerization of 4VP/BA followed homogeneous nucleation mechanism.
通过乳胶粒粒度分析及引发聚合速率的测定，探讨了微皂乳液聚合的成核机理。
The nucleation mechanism of the emulsifier-minor latex particles was discussed by measuring the particle size and the polymerization rate for the seeded stage.
本文采用电化学方法制备聚苯胺薄膜，并对其成核机理和生长过程进行了研究。
In this thesis, PANI film was prepared by electrochemical method, and its nucleation mechanism and growth process were also studied.
初步探讨了在复合乳化剂存在下聚合方法-成核机理-粒子微观结构-乳胶性能之间的关系。
The relationship among polymerization methods, nucleation and growth mechanism of the particle, particle microstructure, properties of latex and films was discussed.
初步探讨了在复合乳化剂存在下聚合方法-成核机理-粒子微观结构-乳胶性能之间的关系。
The relationship among polymerization methods, nucleation and growth mechanism of the particle, particle microstructure, properties of latex and films was...
在讨论钼酸铵成核机理的基础上，研究了不同酸化速度下四钼酸铵(AQM)结晶的成核速率。
On the basis of discussion for nucleation mechanism of ammonium molybdate, the crystallized nucleation rate of AQM at different speed.
结果表明原子转移自由基乳液聚合和常规乳液聚合存在着很大的差异，特别在成核机理和动力学方面。
As a result, there were great differences between ATRP and conventional emulsion polymerization, especially the nucleation mechanism and the kinetics.
深入探讨了包裹率、粒度与RTM/EC示温微胶囊变色性能之间的关系，并研究了油相相分离的成核机理。
The relation between the embedding efficiency and particle size and the thermochromism performance of the RTM/EC thermochromic microencapsule and the mechanism of oil phase separation are discussed.
本文研究了对向靶溅射薄膜的成核机理。给出了在薄膜的生长初期基板上的岛密度随生长条件（如沉积时间、基板温度）的变化。
This paper studies the nucleation mechanism of the target-facing sputtering, and the variation of island-density with such parameters as deposition time and substrate temperature.
经过几年的努力，目前主要在超顺排碳纳米管阵列的可控制生长、碳纳米管生长动力学、碳纳米管成核机理等方面取得一些阶段性成果。
After several years of efforts, we have made some progress in the controlled synthesis of super-aligned CNT arrays, the growth kinetics, and the nucleation mechanisms of CNTs.
首先分析了超声波对制冷剂水合物成核生长的影响机理，然后进行了实验研究。
Influencing mechanism of ultrasonic on refrigerant hydrate nucleation and growth was first analyzed and then experimental study was made.
最后讨论了基片表面预处理对金刚石成核作用的机理和两种新的表面预处理方法。
Finally, we discussed it's mechanism of and two new methods of substrate surface pre-handle.
本文运用位错理论分析了裂纹成核、裂纹扩展机理；
The mechanisms of nucleation, formation and propagation of cracks are analysed with dislocation theory in the paper.
就无机水合盐的过冷机理及非均匀形核的动力学机理进行了探讨，加入成核剂是降低过冷度的有效措施。
This paper discusses the nucleating mechanisms of the salt hydrates and comes to the conclusion that adding suitable nucleating agents reduces significantly the degree of supercooling.
因此，滴状冷凝初始液滴形成机理符合成核中心假说。
Therefore, the mechanism of the formation initial condensate droplets for dropwise condensation accords with the hypothesis of surface nucleation sites.
结果表明，玻璃纤维增强聚丙烯的拉伸强度、弯曲强度和冲击强度有较大提高。此外，本文还对成核剂、交联剂和助交联剂的增强机理进行了探讨。
The results show that the tensile strength, the flexural strength and the impact strength of glass fiber reinforced polypropylene are improved to a considerable extent.
结果表明，玻璃纤维增强聚丙烯的拉伸强度、弯曲强度和冲击强度有较大提高。此外，本文还对成核剂、交联剂和助交联剂的增强机理进行了探讨。
The results show that the tensile strength, the flexural strength and the impact strength of glass fiber reinforced polypropylene are improved to a considerable extent.
应用推荐