总线驱动器的多行的AC 890常见的桥接在一起使用通用总线适配器模块。
Multiple rows of AC890 Common Bus Drives are bridged together using Common Bus Adapter modules.
检测的水表数据通过单片机串行输入到CAN总线驱动器并经过总线驱动器、中继器实现信息的网络传输。
The measured data of water meter is input by micro-computer to CAN Bus-driver serially. And, through Bus-driver and carrier, network transmission of information is realized.
第一总线驱动器（11）基于是否检测到传输的符号模式，从星形网络（1）中禁用第一网络分支（112）。
The first bus driver (11) is disabling the first network branch (112) from the star network (1) based on whether the transmitted symbol pattern is detected.
最后基于LPC 2194微控制器和TJA1050高速CAN总线驱动器开发了各通信节点。实际应用表明，该系统稳定可靠。
Communication nodes are developed based on microcontroller LPC2194 and high speed CAN bus driver TJA1050. The application shows that the network is reliable and stable.
使用高速适配器连接磁盘驱动器，这一点是非常重要的，但是您必须确保该总线本身不会成为一个瓶颈。
Using high-speed adapters to connect the disk drives are extremely important, but you must make certain that the bus itself does not become a bottleneck.
如果您准备用SCSI设备创建一个RAID - 0卷，注意不要让所有驱动器的总吞吐量超过SCSI(和PCI)总线的最大吞吐量。
If you're creating a RAID-0 volume out of SCSI devices, be aware that the combined throughput of all the drives can potentially exceed the maximum throughput of the SCSI (and potentially PCI) bus.
考虑到现场的环境干扰较强，对总线电缆及CAN控制器、驱动器采用了冗余设计，保证数据传输的可靠性。
Considering strong disturbance environment in the field area, redundant design in bus cable, CAN controller and driver is involved to assure the reliability of data transmission.
通常，必须在某一总线主控PC I扩展槽中拥有驱动器适配器。
In general, must be in a PCI bus master expansion slot has a drive adapter.
请选择用于检测驱动器的总线地址(使用箭头键)。
Select the bus address used to detect the drive (use arrow keys).
该驱动器通过RS485总线与外界通信，可按照预定参数完成速度和位置伺服。
This driver can communicate externally with RS485 bus and accomplish speed servo and position servo with the scheduled parameters.
本机传输速率超过SCSI总线速度的50%的驱动器必须在专用SCSI总线上，以避免降低性能。
Drives whose native transfer rate exceeds 50 percent of the SCSI bus speed must be on a dedicated SCSI bus to avoid loss in performance.
较旧的计算机没有足够的总线(端口)电源来运行驱动器。
Occasionally, older computers have insufficient Bus (port) power to operate the drive.
OLED显示板主要设计了OLED显示屏的电源电路和显示驱动器的总线接口电路。
The design of OLED display board is mainly on the circuit of the OLED power supply and bus interface of display driver.
接口是数字控制器与伺服驱动器间的串行实时通信总线。
SERCOS (SErial Real-time Communication System) is the serial real-time communication fieldbus between digital controller and servo-driver.
重点讨论了微机控制部分，其特点是把DDFS经缓冲驱动器直接挂到微机总线上，以实现频率与相位控制，设计了全部硬件和软件。
Its character is that the DDFS is linked to a microcomputer bus through buffer driver to control frequency and phase. The necessary hardware and software are designed.
设计了数控系统与伺服驱动器间基于CAN总线的数据结构。
The data struction was designed based on the bus structure between the CNC and the servo system.
设计了数控系统与伺服驱动器间基于CAN总线的数据结构。
The data struction was designed based on the bus structure between the CNC and the servo system.
应用推荐