先进的US B端口监视器是一个软件工具，分析了USB总线，USB设备和协议。有了这个程序，你可以调试和测试usb设备和软件。
Advanced USB Port Monitor is a software tool that analyzes the USB Bus, USB device and protocol. With this app you can debug and test USB devices and software.
本文以应用于工业测试系统的在线状态检测数据采集系统的设计为例，讨论了基于DSP数字信号处理器和USB通用串行总线接口数据采集系统的软硬件设计的主要步骤和过程。
Taking the design of the industry on-line state detection Data Acquisition System as example, the paper discusses the main processes on the software and hardware design based on DSP and USB.
试验方法直接通过综合电子系统采集数据，测试设备以总线监视器模式接入综合电子系统。
The test method directly gathers data through synthesis electronic system. The testing equipment is inserted into synthesis electronic system through bus monitor mode.
设计和验证超高密度FPGA的方法是采用逻辑分析仪、示波器和总线分析仪，通过测试头和连接器把信号送到仪器上。
Making use of logic analyzer, oscillograph and bus analyzer, we can design and test the superhigh density FPGA, and transmit the signal to the instrument through probe and linker.
介绍了一种基于CAN总线的电涡流传感器测试系统，重点研究了EPP模式下并口扩展CAN总线技术。
A data measurement system of the eddy current sensor based on the CAN is presented. A parallel interface technology, which enlarges CAN, in EPP mode is mainly discussed.
该传感器使用两组旋转变压器实现了电源及信号的非接触传递，并通过现场总线技术实现远距离测试监控。
The sensor uses two revolving transformers to transfer the electrical source and the signal without contacting. It also implements remote monitoring tests through the field bus technology.
将USB所具有的独特优点引入到以GPIB为标准的自动测试系统中，设计并开发了具有USB总线的GPIB接口控制器和性能较为完善的VISA函数库，介绍了所设计的GPIB控制器VISA标准函数的格式与功能。
The inimitable merits of USB are introduced into the GPIB automatic testing system and the GPIB controller with the USB bus and the VISA function lib is designed and developed.
阐述了机载实时容错分布式计算机系统测试体系结构及测试方法，并简要介绍了测试总线和测试控制器的设计。
The test structure and test method in an air-born real-time fault-tolerant distributed computer system are dealt. The design of test controller and test buses are also discussed briefly.
红色的I /OLED闪烁，而这种情况正在发生自检完成后，总线耦合器开始测试连接的总线端子 （汽车总站测试） ， 并读取配置。
The red I/O LED blinks while this is happening After completion of the self-test, the Bus Coupler starts to test the attached Bus Terminals (the Bus Terminal Test), and reads in the configuration.
经测试，阀门定位器实现了FF总线通信功能，证明了开发方案的可行性。
The experiment indicates that the intelligent valve positioner fulfills the FF communication function.
采用译码器构成单总线控制，设计了智能电压源组成气体放电管直流击穿电压自动测试系统。
By using some encoders to construct 1-wire control bus, an intelligent power source is designed and the automatic test system of arrester direct current spark-over voltage is built up.
采用DSP和边界扫描总线控制芯片74lvt8980设计边界扫描测试控制器。
A boundary scan controller with the USB interface is designed. DSP and 74lvt8980 are adopted to control the boundary scan bus.
1553B总线系统已广泛应用于飞行器中，为确保大系统的电磁兼容性，有必要开展总线连接器的屏蔽效能测试研究。
The 1553b bus system has been widely used in aircraft, so it is necessary to analyze shielding effectiveness of the bus connectors to ensure electromagnetic compatibility of the whole system.
1553B总线系统已广泛应用于飞行器中，为确保大系统的电磁兼容性，有必要开展总线连接器的屏蔽效能测试研究。
The 1553b bus system has been widely used in aircraft, so it is necessary to analyze shielding effectiveness of the bus connectors to ensure electromagnetic compatibility of the whole system.
应用推荐