给出了汽车行驶记录仪CAN总线接口电路硬件设计原理和软件设计流程。
The hardware design principle and software flow chart of the CAN interface circuits were introduced.
OLED显示板主要设计了OLED显示屏的电源电路和显示驱动器的总线接口电路。
The design of OLED display board is mainly on the circuit of the OLED power supply and bus interface of display driver.
设计了上电自检电路、热电偶信号处理电路、DSP与CAN总线接口电路以及电源电路。
Automatic detecting circuit, signal adjusting circuit, DSP and CAN peripheral port circuit and electrical source circuit are designed.
设计了上电自检电路、热电偶信号处理电路、DSP与CAN总线接口电路以及电源电路。
Automatic detecting circuit, signal adjust circuit, DSP and CAN peripheral port circuit and electrical source circuit was designed.
详细介绍了整个系统的硬件电路设计，包括光栅传感器信号的CPLD处理、PCI总线接口电路设计；
The design of the whole hardware circuit, including theCPLD processing of the sensor signal, the PCI bus inter-face circuit is introduced.
另一个是PCI总线接口电路，本设计中采用PERICOM公司的PCI桥接芯片PI7C8150B实现图像数据的传输。
The other module is PCI bus interface circuit. PI7C8150B chip of PERICOM Corporation is used to finish transmission of the image data.
介绍了基于SJA1000的CAN总线接口电路的软硬件设计方法，给出了CAN总线接口电路、SJA1000初始化程序、接收及发送数据程序的框图。
This paper discusses the designing method of CAN bus juncture circuit based on SJA1000 and presents the CAN bus juncture circuit, the SJA1000 initialization programme and the flow charts.
在数据通信方面，提出了由总线控制器与报文收发器构成的CAN总线接口电路，并详细论述了与总线接口初始化、总线中断处理、总线数据收发相关的设计实现过程。
For the purpose of data communication, the paper lodges the CAN interface circuit, and expatiates the programs of bus initialization, bus interrupt service routing, receiving and sending bus data.
深入探讨了DSP技术和计算机的总线接口技术，设计了PC及DSP的硬件电路接口。
Deep research into DSP technology and computer bus technology, design the hardware and circuit interface of PC and DSP.
论述了基于SJA1000的CAN总线的硬件接口电路的设计、芯片的选择、软件设计及CAN通信的实现。
The design of CAN bus hardware interface circuit based on SJA1000, the selection of chips, the design of software and the realization of CAN communication are expatiated.
本文介绍了利用计算机ISA、PCI总线和打印机接口设计密码电路。
The paper proposes a password circuit that by using computer ISA and PCI bus and printer interface.
其硬件电路及软件编程简单、方便，可节省程序代码空间和CPU运行时间，是一种使用广泛的串行总线接口标准。
And its hardware circuit and software programming are simple and convenient, so it can economize program code space and CPU running time. It is a sort of standard of serial bus interface used widely.
作为标准化的尝试，本系统实现了标准的保护电路单元和恢复时间电路单元，通过44芯总线插座与标准总线接口连接。
As a try for circuit standardization, the system realizes the standard protection circuit unit and recovering-time circuit unit, which are connected to system through standard 44 pins' bus interface.
前端数据采集装置和后台上位机之间数据通信采用RS485总线，设计了RS485通信接口电路和通信协议。
The data communicating between the data sampling unit and the computer adopts RS485 fieldbus. At the same time, the communication protocols and RS485 communication interface are designed.
分析了总线接口芯片选择原则和总线冲突解决方案，给出了系统实现的硬件接口电路和软件实现详细框图。
The selection principle of bus interface chip and solution of bus conflict are introduced, together with its concrete hardware circuits and software block chart are given.
对于VME总线，用户可以根据特定要求自行设计接口电路，比如只实现从模块访问。
For VME bus, users themselves could design interface circuit according to particular demand such as only slave interface.
本发明提供了一种基于PCI总线的管脚复用的方法。该方法可以明显的减少PCI接口设备的端口数量，而且不需要大幅度增加电路的复杂度。
This invention provides a method for multiplexing pins based on PCI bus which can reduce port numbers of PCI interface equipments but does not increase complexity of adding circuits.
介绍了ARINC4 2 9串行总线在试飞测试系统中的应用及其接口电路设计。
The application of ARINC429 serial data bus in flight test system and design of the interface circuit are described .
详细介绍了CAN/LIN总线技术在灯控模块中的应用，完成了CAN和LIN的网关设计，并给出了CAN/LIN总线的硬件接口电路和软件设计思想。
This paper introduces the CAN/LIN bus' application in the light's control module, the design of the CAN/LIN gateway is finished, and the hardware interface circuit and the software idea are given.
该电路设计方案用于1553B总线接口卡的研制，现已通过验收并经测试证明运行稳定可靠。
This circuit scheme used in the design of 1553b bus interface board has been checked and accepted and runs well.
因此研究开发基于PCI总线接口和通信协议的超大规模集成电路芯片是具有应用前景和市场价值的。
Therefore, it will have a bright future to develop VLSI chip based on a PCI bus and related a communication protocol.
介绍了CAN总线适配卡的接口电路和译码逻辑。
In this paper, the hardware interface and decode logic of CAN adapter are introduced.
介绍了通用串行总线模块usb10 0模块的基本特点和使用方法，并给出了USB10 0与单片机的硬件接口电路和通信程序源代码。
The fundamental characteristics of USB100 and its application are introduced. The interface circuit between USB100 and MCU is given, and the source code of communication program is listed.
基于ISA总线的虚拟万用表，分计算机和ISA总线板卡两部分，由A/D转换、交变电压测量、电阻测量及接口电路组成。
The virtual multimeter based on ISA bus is divided into computer and ISA bus board. It is composed of A/D conversion, alternating voltage measurement, resistance measurement and interface circuit.
采集系统包括模拟输入、A/D变换、数据缓存、数据DMA传输及PCI总线接口等电路。
The data acquisition system includes analog input, A/D conversion, data buffering, DMA transferring and PCI interface.
系统实现了电源模块的设计，提供主电源和备用电源两种方式，同时具体完成了以太网模块、存储电路、总线接口模块等的设计。
This article realizes the design of power module which provides two ways for power: main power and backup power, and completes the design of Ethernet module, and storage module.
系统实现了电源模块的设计，提供主电源和备用电源两种方式，同时具体完成了以太网模块、存储电路、总线接口模块等的设计。
This article realizes the design of power module which provides two ways for power: main power and backup power, and completes the design of Ethernet module, and storage module.
应用推荐