其设计包括不同数据节点的CAN控制器,及单片机控制的CAN接口模块和基于DSPTMS320 LF 2407a的CAN总线接口等。
The design includes designs of different can controllers for different data nodes, the can module controlled by single chip computer and can bus interface based on DSP TMS320LF2407A, etc.
本文通过一个实例,介绍以IBM-PC微机为管理机与STD总线控制下的模块式工业控制机之间的远距离数据通讯、原理及方式。
This paper presents a method for data communication between IBM PC and control sys-tems under STD BUS in distributed control of computer systems.
该接口卡FPGA芯片内部VHDL程序含:ISA总线与FPGA接口、串行异步通信发送及接收模块。
The VHDL program embedded in the FPGA chip includes: interface combine ISA bus and FPGA, serial asynchronous communication module for transmitting and receiving.
并利用单片机的SPI和US B串口总线分别实现无线接收模块数据流传输及计算机的通信。
SPI and USB serial buses are used to realize data transmission through wireless receiving modules and computer communication.
硬件系统主要包括MSP430单片机、远程通讯模块、GPS定位模块、CAN总线及电源部分。
The hardware system is mainly composed of MSP430 SCM, remote communication module, GPS positioning module, CAN bus and power source.
介绍了PC 104总线的特点,给出了一种基于PC 104总线及CPLD的多功能模块的设计。
The specialties of PC104 bus are introduced. A design of multifunctional module based on PC104 bus and CPLD is provided.
阐述了系统的硬件构成和软件模块的设计及CAN总线网络接口的实现。
The composition of the system hardware and the design of software blocks and the achievement of CAN interface are described.
提出了一种实时图像信息处理系统模块化可扩展的多总线结构,详细论述了其系统总线结构、DSP芯片选型及系统复位流程等系统实现中的关键问题。
Some Key points in system realization, such as the system bus structure, the selection of DSP chips and the process of system reset, were discussed in detail.
AHB总线接口设计划分为主控模块接口设计及从模块接口设计。
As the basic SoC design technique, the AHB bus interface design consists of master module interface design and slave module interface design.
采用STD总线和模块式结构,以时序鉴别法选线技术,准确定位故障线路,并发出语音报警、灯光及数字显示。
The paper adopts STD bus and modular structure and uses sequence identification wire selection technique to correctly locate the fault lines and indicate with language alarm, light and digitals.
此外,对测量模块的总线通信工作原理及控制逻辑实现也作了具体讨论。
In addition, this paper discusses the principle of bus communication and logic control in detail.
此外,对测量模块的总线通信工作原理及控制逻辑实现也作了具体讨论。
In addition, this paper discusses the principle of bus communication and logic control in detail.
应用推荐