足够的空气发现混合可以渗透周围的节流阀值和通过怠速系统来维持柴油。
Enough air-found mixture can seep around the throttle value and through the idle system to maintain the dieseling.
怠速系统提供很浓的可燃混合气供起动使用。
提出一种矿山液压工程机械的空载怠速全自动控制系统，分析引起仿真和实测结果差异的原因。
In the paper puts all-automatic control system of noload idling for mine hydraulic-engineering machine different of cause analysised emulation and practical measure.
因此，本文将研究基于FAI电控技术的摩托车怠速控制系统。
Therefore, the idle control system based on FAI's EFI system is the main research issue in this paper.
本文介绍了自行研发的四冲程摩托车汽油机用MCEFI电喷系统在发动机怠速工况的匹配研究。
This paper introduces the idling matching test about MCEFI motorcycle electronic fuel injection system for four-stroke engines.
同时，在发动机台架试验台上研究了该系统的怠速启停控制功能和控制器输入输出响应性能。
Meanwhile, this paper verifies the function of engine idling start-stop control system and the performance of controller IO response using the engine testing bench.
建立了基于悬置元件怠速工况下动刚度的发动机悬置系统MATLAB力学模型。
A mechanics model for engine mount system is established with MATLAB based on dynamic stiffness of engine mounts in idle condition.
针对怠速工况分别设计了变参数PID控制系统和模糊控制系统，并进行了实车试验对比。
In this paper, both PID controller with variable parameters and fuzzy logic controller for idling model are designed and evaluated by field tests on a production vehicle.
为了改善电喷汽油机冷起动及冷态怠速运转（即暖车过程）性能，自行研制了基于高能双火花塞点火的快速燃烧系统。
Improvement of cold starting and cold idling circulation(engine warming up)combustion process of motorcycle gasoline engines by dual-spark plug-based rapid burning system was introduced.
介绍了怠速模糊控制系统的结构和工作原理以及模糊控制器的设计过程。
The construction and working principle of the fuzzy controller are described, and the design procedure of the fuzzy controller is given in detail.
怠速工况试验表明，优化后的挂钩不仅降低了车内驾驶员右耳侧噪声，而且减小了排气系统传到车身地板的振动。
Test result shows that vibration from exhaust system to floor and sound pressure to driver's right ear on idle running are reduced with the optimized hanger systems.
本文介绍了基于电子节气门，怠速控制系统的开发中，我们使用的方法。
This article introduces the method we used in the development of idle speed control system based on electric throttle.
分析了发动机激励的特点，运用ADAMS进行了动力总成液压悬置系统的怠速和高速工况下的仿真计算。
The characteristic of engine exciting is analyzed. The hydraulic mount system' simulating calculation on idle working condition and high speed working condition is carried out by ADAMS.
浸渍的摄入量，或者打开发动机进气空气进入系统，必须保证孔足够大以确保有足够的空气可以在引擎的所有条件从怠速到全油门。
The intake snorkel, or the opening for the intake air to enter the system, must be large enough to ensure sufficient air is available to the engine under all conditions from idle to full throttle.
发动引擎，并快速的怠速运转，然后左右转动方向盘到底数次，将系统内的空气排出。
Start the engine and run it fast idle, then turn the steering from lock-to-lock several times to bleed air from the system.
首先，根据汽车动力传动系统的扭振当量原则与方法，分别建立了怠速工况与正常行驶工况下发动机、双质量飞轮以及传动系统的无阻尼多自由度扭振当量模型。
First of all, the two undamped multi-freedom torsional vibration models of DMF under idling and driving condition are built based on the principles of vehicle power train equivalent torsional model.
同时对稀薄燃烧、增压中冷发动机做了ECUI/O标定、怠速标定、冷启动标定、对电控系统进行全工况内点火提前角的标定、内空燃比的标定、发动机增压压力标定。
Then basic calibration such as ECU I/O calibration, idle speed calibration, cold start calibration, ignition advance calibration, air fuel ratio calibration, boost pressure calibration are conducted.
该系统可以在怠速或低速行驶情况下完全依靠电池提供的动力驱动。
The system can operate the vehicle entirely on battery-electric power during idle or low-speed driving situations.
开发了基于扭矩的控制模型，包括传感器信号处理模型、扭矩模型、怠速模型、节气门模型、空气系统模型、起动控制模型等。
A control model based on torque was developed, including signal processing model, torque model, idle model, throttle model, airflow model, start control model and so on.
在采用了具有空档怠速模式的变速箱的常规动力系车辆中，这种控制系统指示变 速箱退出空档怠速模式。
In a conventional powertrain vehicle that utilizes a transmission with a neutral-idle mode, the control system directs the transmission to exit neutral-idle mode.
本文对基于模糊控制的汽车发动机怠速控制系统进行了研究。
This paper studies the intelligent engine control based on fuzzy control.
本文对基于模糊控制的汽车发动机怠速控制系统进行了研究。
This paper studies the intelligent engine control based on fuzzy control.
应用推荐