用扫描电镜观察了膜的微观形态。
The microstructure of the film was studied by scanning electron microscope.
微观形态对空间电荷包产生的电场阈值有明显影响。
Morphology has apparent effects on electric field threshold of space charge initiation.
两种磨损的金属流失过程的微观形态是不完全相同的。
The microstructure of two kinds of metal loss in process of wear and tear is not exactly the same.
对羟丙基糯米淀粉微观形态及其淀粉糊性质进行了研究。
The microcosmic configuration and the paste properties of hydroxypropylated waxy rice starch were studied.
目的探讨毛发枪弹损伤微观形态与射击距离之间的关系。
Objective to study the relationship between the microtopography of the gunshot damaged hair and the shooting distance.
通过XRD和SEM测试对样品的微观形态进行了研究。
The microcosmic configuration of PA11/PVDF composites were studies by XRD and SEM.
对复合材料进行热性能、结晶形态及微观形态测试分析。
The thermal behavior, crystalline morphology and micromorphology of the composite were tested and analyzed .
并对共混物的力学性能、磨耗性能及微观形态进行了研究。
The mechanical properties, wear properties and micro-morphology of the prepared blend were studied.
碳纤维复合材料的孔壁表面微观形态是孔加工质量的重要特征之一。
The microstructure on the hole surface of CFRP is a very important characteristic of the quality of hole drilling.
扫描电镜对炭膜断面微观形态观察表明,膜层与支撑体之间结合良好。
The SEM analysis of the cross-section of the carbon membrane shows a good combination between the support and membrane.
研究结果表明,聚合物水凝胶的微观形态、性能与凝胶的化学结构有关。
Results show that microcosmic morphology and property of hydrogels depend on their chemical structure.
微观形态、试品种类、外加电场等因素都会影响高场强下聚乙烯空间电荷特性。
Many factors such as morphological parameters, specimen species and applied electric field affect space charge properties of polyethylene under high electric field.
研究了复合材料的冲击强度和拉伸强度的变化,用扫描电镜考察了复合材料的微观形态。
The changes of the impact strength and tensile strength of the composite was studied, and the microstructure of the composite was also observed by means of SEM.
有冲刷磨损和撞击磨损两种基本类型。两种磨损的金属流失过程的微观形态是不完全相同的。
There are scouring abrasion and impact wear two basic types. The microstructure of two kinds of metal loss in process of wear and tear is not exactly the same.
方法应用ESEM观察分析不同锐器、钝器及致伤方式形成的毛发机械性损伤的微观形态特征。
Method ESEM was used to image and analyze the morphological characterizations of the physical damaged hairs, which caused by different sharp or blunt instruments and with different manners.
应用光学显微镜和扫描电子显微镜对加福煤粉燃烧过程中微观形态的变化规律进行了详细的观察。
Chip behaviors were analyzed using scanning electron microscope(SEM), to study the effects of applied load, scan cycles and scanning direction on nanomachining of Al and Cu samples.
并借助动态光散射粒径分析仪、TEM分别考察了复合胶乳粒径及其分布、乳胶粒的微观形态结构。
The size and distribution, the morphological structures of latex were determined through dynamic laser scattering and TEM.
对无镍奥氏体不锈钢经塑性变形后自由表面微观形态变化以及对耐腐蚀性能的影响进行了观察分析。
The micromorphic change of free surface and property of corrosion resistance were observed after austenitic stainless steel was treated by plastic deformation.
采用低温氧等离子体对纯棉坯布进行处理并退浆,从微观形态分析了氧等离子处理对退浆效果的影响;
The cotton fabrics are treated with low-temperature oxygen plasma and then desized. The influence of the treatment on the desizing effect is analyzed through micromorphology.
借助TG、DSC、SEM和TEM对改性酚醛树脂体系的耐热性能、固化反应和微观形态进行了表征。
Heat resistance, curing reaction, and morphology of the modified phenolic resin system were characterized by TG, DSC, SEM and tem.
用扫描电子显微镜(SEM)对包膜肥料的表面、界面及养分溶解释放后的表面进行了微观形态结构研究。
Morphological microstructure, such as surface, interface and surface of coated fertilizer after nutrient being released in water, was studied by scanning electron microscopy (SEM).
Inconel 718切屑的微观形态在低速下呈带状,高速下由于发生了绝热剪切导致切屑为锯齿状。
The microstructure of Inconel 718 chip is continuous under low cutting speed and serrated under high cutting speed because of adiabatic shearing.
加入了助燃剂后,焦炭原有的微观形态被破坏,这不仅提高了焦炭的燃烧速率,而且也增加了焦炭的燃尽率。
After the addition of combustion-supporting agent, the original microcosmic structure of coke is broken, thus not only increases the combustion rate, but also increases the burn-off rate of the coke.
加入了助燃剂后,焦炭原有的微观形态被破坏,这不仅提高了焦炭的燃烧速率,而且也增加了焦炭的燃尽率。
After the addition of combustion-supporting agent, the original microcosmic structure of coke is broken, thus not only increases the combustion rate, but a...
在开发设计的振动诱导动态全硫化实验装置上,对热塑性硫化橡胶(TPV)的性能与微观形态进行了测试与分析。
The experimental equipment of vibrational induction for dynamically full vulcanization was designed and used to measure and analyze the property and micromorphology of thermoplastic vulcanite (TPV).
研究了实验室制备的两种导电聚苯胺材料与乙烯-丙烯酸共聚物(EAA)的共混及共混物的导电性能和微观形态。
Studied in this paper were the conductive properties and the microstructure of two blends of polyaniline with EAA, doped with ethylene-acrylic acid copolymer and DBSA respectively.
利用开发设计的振动诱导动态全硫化实验装置,对稳态与动态条件下TPE的宏观力学性能和微观形态结构进行了研究。
The Mechanical properties and morphological structure of TPE in steady and dynamic states are studied through the experimental device of vibration-induced dynamic vulcanization.
由于三种填料具有不同的微观形态,其对体系粘流活化能的影响是不同的,其中细颗粒填料填充的体系有较低的粘流活化能。
The viscous flow active energy is different because of different morphology of fillers, and the system filled with small size filler has a low viscous flow active energy.
文中还就苹果果肉细胞的微观形态、影响悬浮稳定性的因素进行了探讨,以深入探究完全成熟的苹果更加适宜制取浊汁的机理。
In this paper, the microcosmic morphological characters of apple pulp cells and the factors that affect cloudy juice stability were also discussed.
文中还就苹果果肉细胞的微观形态、影响悬浮稳定性的因素进行了探讨,以深入探究完全成熟的苹果更加适宜制取浊汁的机理。
In this paper, the microcosmic morphological characters of apple pulp cells and the factors that affect cloudy juice stability were also discussed.
应用推荐