阐述了微晶纤维素的主要特征和物化性质；
The technological characteristic of process and the kinetic of hydrolytic degradation of cellulose are generalized and discussed.
还包含：微晶纤维素，二氧化硅，硬脂酸镁。
Also Contains: Microcrystalline cellulose, silicon dioxide, magnesium stearate.
结果用微晶纤维素作辅料制成颗粒效果较佳。
ResultsThe granules made by the excipient of MCC were suitable.
微晶纤维素，植物纤维素，蔬菜硬脂酸镁，硅，蔬菜甘油。
Microcrystalline Cellulose, Vegetable Cellulose, Vegetable Magnesium Stearate, Silica, Vegetable Glycerin.
微晶纤维素，蔗糖脂肪酸酯，磷酸氢钙，二氧化硅，甲基纤维素。
Microcrystalline cellulose, sucrose fatty acid esters, dicalcium phosphate, silicon dioxide, methylcellulose.
微晶纤维素，硬脂酸，洋槐树胶修改过的纤维素胶，和胶质二氧化硅。
Microcrystalline cellulose, stearic acid, acacia gum modified cellulose gum, and colloidal silicon dioxide.
微晶纤维素由于其良好的成锭性，为目前直接打锭剂型最常使用的赋形剂之一。
Due to its excellent compactibility, microcrystalline cellulose is one of the most preferred filler-binders in direct compression tablet formulations.
其他成分：明胶(胶囊)，双磷酸钙，微晶纤维素，胶体二氧化矽和硬脂酸镁。
Other Ingredients: gelatin (capsule), dibasic calcium phosphate, microcrystalline cellulose, colloidal silicon dioxide, and magnesium stearate.
结果：优化所得处方为微晶纤维素40%，羧甲基淀粉钠10%，糊精约15%。
Result: the optimized formulation contained 40% microcrystalline cellulose, 10% sodium carboxymethyl starch and 15% dextrin.
探讨了在实验室条件下，采用酸水解法处理豆皮制备食用微晶纤维素的工艺条件。
The technology of microcrystalline cellulose from soybean hulls was obtained by a lot of experiments made in LABS in this paper. Acidolysis of soybean hulls was the main preparation method.
结果：微晶纤维素与交联聚乙烯吡咯烷酮的最佳处方用量分别为40%、10%；
RESULTS:The optimized formula dosage of microcrystalline cellulose and crospolyvinylpyrrolidone were40%and10%respectively;
然而由于微晶纤维素颗粒形状的不规则，使得其粉末的流动性不佳，造成锭片重量上的差异。
Because the particle shape of MCC is irregular, it causes bad flowability, the variation of tablets weight, and the poor disintegration properties.
方法：考察糊精、羧甲基淀粉钠、微晶纤维素和低取代羟丙基纤维素对银黄酮片的质量影响。
METHODS: the effects of dextrin, CMS-Na, microcrystalline cellulose and L-HPC on the quality of Ginkgo flavone tablets were studied.
方法考察糊精、微晶纤维素、羧甲基淀粉钠和低取代羟丙基纤维素对扁蓄总黄酮片的质量影响。
Medthods The effects of dextrin, microcrystalline cellulose, CMS-Na and L-HPC on the quality of the total Flavone of Polygonum Aviculare Tablets were studied.
稀释剂（填充剂）可选择淀粉、微晶纤维素、甘露醇、预胶化淀粉中的一种或两种以上的混合物；
Among starch, microcrystalline cellulose, mannitol and pre-gelatinized starch, one ingredient or more than two ingredient compound can be chosen as diluent agent (filling agent);
结果：优选的崩解剂组成为：交联聚乙烯吡咯烷酮5%，微晶纤维素40%，低取代羟丙基纤维素15%。
Results: The composition of the choice breaking agents is 5% of cross-linked polyvinylpyrrolidone, 40% of microcrystalline cellulose and 15% of low-replacing hydroxypropyl cellulose.
由于其具备良好的压锭性，以及低化学反应活性，使得微晶纤维素被认为是目前最有用的直接压锭赋形剂之一。
Because it equipped with an excellent compactibility and a low chemical reactivity, it makes the MCC to become one of the most useful excipient of direct compression tableting.
探讨了反应温度、时间、液固比、液化气氛、催化剂等因素对微晶纤维素、蔗渣液化转化率以及各相产物分布的影响。
The effects of reaction temperature, time, ratio of liquid to solid (L/S), atmosphere and catalysts on liquefaction of microcellulose and bagasse were investigated in detail.
结果：优选的最佳处方为微晶纤维素20％、交联聚乙烯吡咯烷酮6％、羧甲基淀粉钠5．5％和聚乙烯吡咯烷酮8％。
RESULTS:The optimized formulation was composed of microcrystalline cellulose 20%, cross-link polyvinyl pyrrolidone 6%, sodium carboxymethyl starch 5.5% and polyvinyl pyrrolidone 8%.
方法采用L9(34)正交试验法，以崩解时限为指标，以微晶纤维素、低取代羟丙基纤维素、交联乙烯吡咯烷酮、甘露醇等为辅料，筛选最佳处方和制备工艺。
Methods the L9 (34) orthogonal was designed with disintegrating time as the assessment index, and MCC, LHPC, PVPP, Mannitol et al were used in the formulation and preparation.
碳纤维和基体碳的微晶尺寸也都有所增加，这些微晶沿纤维轴向择优取向；
The size of the microcrystallites both in carbon fiber and in matrix was also increased.
用x射线衍射法对棉纤维细胞壁的微原纤螺旋角和纤维素微晶相对取向指数在植株中的分布规律进行了研究。
The distribution of microfibril spiral angle and relative orientational index of cellulose crystallites in cotton fibre cell walls had been studied by X-ray diffraction analysis.
利用XRD研究了PAN基碳纤维在连续高温石墨化和热牵伸石墨化过程中纤维内石墨微晶沿纤维轴择优取向性的变化。
The changes of preferred orientation of PAN-based carbon fibers during continuous high temperature graphitization and hot stretching graphitization were investigated by X-ray diffraction (XRD).
本文研究了碳纤维增强微晶玻璃复合材计的制造工艺。
This paper deals with the manufacture of carbon fiber reinforced glass-ceramic matrix composites.
原丝经过预氧化后仍保持原来的微原纤结构，纤维外部表层的石墨微晶较大，所含孔隙较少，内部的微晶较小且含有大量孔隙。
The (graphite) crystallites in the outer layer of the carbon fibers are large with few pores, while the inner crystallites are small with many pores.
研究结果表明，PAN基炭纤维的氧化特性与其石墨微晶参数和表面形貌密切相关。
The results of the research works show that oxidation behavior of PAN-based CF is related with its morphology and graphite crystallite parameter.
结果表明，液氮处理后纤维素的侧序分布、结晶度、微晶尺寸、晶格形态都发生深刻的变化。
The resultsshowed that after the treatment of cellulose with L-NH3, the lateral order distribution, crystallinity, crystallite size and lattice form of cellulose were dramatically changed.
结果表明，液氮处理后纤维素的侧序分布、结晶度、微晶尺寸、晶格形态都发生深刻的变化。
The resultsshowed that after the treatment of cellulose with L-NH3, the lateral order distribution, crystallinity, crystallite size and lattice form of cellulose were dramatically changed.
应用推荐