优化设计的参数使得产量更高、粒度更细，从而降低了循环负荷。
Parameters of optimum design make higher yield and finer production size while reducing the circuit burden.
若合理选择设计参数完全可以避免循环负荷，并列举了详细的测试资料。
Through reasonable selection of design parameters, circulating lead can be completely avoided. Typical detailed testing information is also described in the paper.
当人们实际看到蒙皮在循环负荷作用下，像一头喘着粗气的怪物，就不难理解它的结构总有一天会变得脆弱不堪。
When one actually sees a fuselage expanding and contracting under the cyclic load, like a breathing monster, it is not difficult to understand how its structure may eventually become weakened.
试验结果表明，玻璃纤维长丝纱有较明显的应力松驰现象，反复循环负荷作用对玻璃纤维长丝纱的强伸性能有较大的影响。
As a result, the stress-relaxation of yarn is obviously observed, and the cyclic loading has much more influence on the tensile property of yarn.
试验结果表明，玻璃纤维长丝纱有较明显的应力松驰现象，反复循环负荷作用对玻璃纤维长丝纱的强伸性能有较大的影响。
As a result, the stress-relaxation of yarn is obviously observed, and the cyclic loading has much more influence on the tensile property...
采用德国洪堡公司的RP80/25型高压辊磨机对梅山选矿厂细碎产品进行了半工业试验，研究了能耗、水分、通过量及循环负荷等因素对辊压效果的影响。
The semi-industrial test on fine products by Meishan Dressing Plant was carried out with the RP80/25 type high pressure roller mill produced by Homburg Corporation of Germany.
有意义的分析是随其他变量而变化的行为，这些变量例如有沿着一个操作的循环，对系统所施加的负荷等等。
The interesting analysis is in changed behavior over some other variable like loops over an operation, load placed on the system, etc.
作者还指出，最大生产力和深度恢复的循环使我们可以持续不断地满负荷使用精力。
The authors also point out that cycles of maximal productivity and deep recovery allow for consistent and continuous usage of our full capacity.
在给水泵与除氧水箱之间，设置给水再循环母管，以满足给水泵在启动及低负荷运行时的需要。
The waterfeeding recirculation header pipe will be set between water-feeding pump and deaeration water tank to fulfill requirements for start-up and low load operation of waterfeeding pump.
有了标准，非循环压缩机上是否有高或低负荷仍然冷冻干燥机。
With standard, non-cycling refrigerated dryers the compressor remains on whether there is a high or low load.
试验目的主要是检验该炉在调峰低负荷运行时水循环的可靠性。
The test mainly aims at the verification of water circulation reliability during peak shaving low load operation.
自然油循环的冷却方式不仅广泛应用于电力网中的中小型电力变压器，也会在在大型电力变压器低负荷和低环境温度时应用。
The cooling method of nature oil circulation is not only widely used in small-middle type power transformer, but also used in large type power transformer with low load and low ambient temperature.
重点分析了间接式地热供热系统调峰负荷随环境温度的变化，以及所受末端散热器设计、地热水与循环水换热器设计运行参数的影响。
Emphasizes the variation of peak load regulating with ambient temperature, the design of terminal heat radiators, and the design operating parameters of geothermal heat exchangers in indirect systems.
潮模砂日益增长的热负荷，更快的循环时间以及对造型材料质量要求的提高，对型砂制备提出了更高的要求。
The growing thermal load of green sand, the quicker recirculation times and the increased requirements on the quality of molding material make new demands on the molding sand preparation.
而应用更多循环的负荷的话，其自身变质的过程会削弱结果。
With more load cycles, autolysis processes would hae impaired the results.
分析了影响循环流化床锅炉出力的因素，结合工作实际，提出了提高锅炉负荷的措施。
This paper analyzes the factors influencing the capacity of circulating fluidized bed boiler, and connecting with the working practice, advances some measures for increasing the boiler load.
在环境负荷不变条件下，运用控制方程求得的万元产值用水量无法满足循环经济的需求。
Under the constant condition of environmental load, water consumption of ten thousand Yuan output value is got from the control equation.
将热水锅炉的水循环由自然循环改为引射循环，强制提高回路的循环水量，使各回路的循环水量分布与其受热面的热负荷相匹配。
By replacing natural circulation with ejecting circulation, the circulating water in each loop can be increased and match with the heat load of related heating surface.
在发动机试验台上，用CB-466燃烧分析仪对四气门汽油机低速低负荷燃烧压力循环变动进行了试验研究。
The cyclic variation of the combustion pressure in the cylinder of a four-valve gasoline engine was analyzed at low speed and light load with the CB-466 combustion analyzer on the engine test-bed.
在不同工况下进行了循环流化床多联供负荷调节试验，验证了气动分配阀的负荷调节性能。
Experiments on the load-adjustment of the circulating fluidized bed multi-generation system are conducted under different operating conditions.
在环境负荷不变条件下，运用控制方程求得的万元产值用水量无法满足循环经济的需求。
Under the constant condition of environmental load, water consumption of ten thousand Yuan output value is got from the control equation. It is unable to meet the recycling economy's demand.
为解决循环流化床锅炉发电机组负荷变化时的机炉协调控制问题，需要对发电机组的热功效率进行在线计算。
Online calculation of heat to power output efficiency of thermal generator set is important for the load coordination control in the CFB boiler thermal generator set.
指出循环流化床锅炉点火或低负荷投油助燃所采用的床上启动燃烧器、风道燃烧器和床枪的特点及选择原则。
The start-up burners for igniting circulating fluidized bed boiler or combustion-supporting with oil under low load mainly include over-bed start-up burner, in-duct burner and bed lance.
论述了在100MW机组电站锅炉所作的低负荷水循环试验。
Water circulation reliability tests were held at low loads in a 100mw utility set's boiler.
利用本文计算软件，对更多不同负荷下的工况进行了热力计算，就135MW再热循环流化床锅炉的部分负荷调节性能进行了更为细致的分析，得到了一些有益的结论。
The performance of the real 135mw CFB boiler under various partial loads is investigated by this model. The calculation results provide some useful conclusions for boiler design and operation.
从曲线，我们得知负荷曲线是相对均匀的，其变化是循环和价格，其变化曲线的非齐次显示出少许的循环的财产。
From the curves, we learn that the load curve is relatively homogeneous and its variations are cyclic and the price curve is nonhomogeneous and its variations show a little cyclic property.
目的研制冷热循环机械载荷咀嚼模拟疲劳试验机来人工模拟口腔环境的温度变化和咀嚼负荷，检测口腔材料的疲劳寿命。
Objective to design a new kind of thermocycling and mechanical loading (TCML) chewing simulator and test the chronic fatigue characteristics of dental materials and prosthesis.
高温取热炉传热计算和水动力计算结果表明热负荷较低时，水循环容易发生停滞。水循环回路结构复杂容易导致并联管内的流量分配不均匀性较大。
The heat transfer and hydrodynamic calculation results of the waste heat boiler show that water circulation is stagnant when the thermal load is very low.
锅炉改造后25%以上负荷水循环正常，采取的改造锅炉水循环系统的措施是成功的。
No water circulation problem will arise with the boiler load 25%d0 after water circulation system of boiler was remade.
锅炉改造后25%以上负荷水循环正常，采取的改造锅炉水循环系统的措施是成功的。
No water circulation problem will arise with the boiler load 25%d0 after water circulation system of boiler was remade.
应用推荐