从案例研究中得出的数据随后进入一组研究发现中，而后用分析工具和后设分析方法加以分析。
Data from case studies are then entered into a data set of findings and analyzed using the tools and methods of meta-analysis.
此传输协议是在IBM分析了他们的客户在其业务中使用WebSphereMQ消息传递的情况（包括通过它传递数据）之后设计的。
The transport was designed after IBM analyzed their customers' usage of WebSphere MQ messaging in their businesses, including the data moving through it.
分析了空间矢量pwm的调制算法以及实现方法，最后设计了异步电机的双闭环矢量控制系统。
After space vector PWM modulation algorithms and implementation methods have been analyzed, dual closed-loop vector control system of asynchronous motor is worked out.
同时对湿度、风向、风速、雨量信号进行分析后设计了调理接口电路。
Adjust circuit was designed to humidity, direction of wind, wind velocity, rainfall signal after carry on the analysis.
写作阶段包括分析归纳基本经验、列出存在问题、提出今后设想等步骤；
The writing stage should include the analysis and summary of the basic experience, listing the problems existing and putting forward the conceptions for the future work.
分析了基线漂移产生的原因并提出了基线漂移的克服方案，最后设计了抑制基线漂移的硬件电路。
The reasons of producing baseline excursion was analyzed and a scheme of solving baseline excursion was made.
最后设计出了两种控制器，分别是极点配置控制器和变结构控制器，并通过仿真进行了性能比较分析，以及发现与解决应用中可能出现的问题。
At the end, we designed two controller, pole placement and VSC, and did simulation to compare the performance, find and solve the possible problem.
文章通过分析比对，阐述了几点看法，以期在今后设计中引起注意。
The points in lighting design are summarized and are valuable to be paid attention in future design.
最后设计了气体配制系统，完成了气体分析仪的实验平台的搭建。
Finally, the system of gas preparation was designed, and the gas analyzer test platform was built up.
之后设计了铁路企业安全文化评价模型，分析了模型的评价结论，指出了其安全文化的薄弱环节。
Then, design the railway corporate culture evaluating model, and analyze the evaluation result, pointing out the weaknesses of railway corporate safety culture.
最后设计并搭建了充电电压均衡和放电稳压方案的硬件电路，通过分析测得的实验数据，最终验证了方案具有一定的可行性和较高的实用价值。
The design and construction of hardware circuit is discussed in the end. The proposed methods of voltage balancing and voltage stabilizing are proved feasible through analysis of experimental data.
最后设计并搭建了充电电压均衡和放电稳压方案的硬件电路，通过分析测得的实验数据，最终验证了方案具有一定的可行性和较高的实用价值。
The design and construction of hardware circuit is discussed in the end. The proposed methods of voltage balancing and voltage stabilizing are proved feasible through analysis of experimental data.
应用推荐