实验目的是测量钢的弹性模量。
The objective of this experiment is to measure the Elastic Modulus of steel.
弹性模量是木材的重要力学性质。
Elastic modulus is an important mechanical characteristic of wood.
拉伸载荷模量约等于比例极限内的弹性模量。
The tensile modulus approximately equal to the compressive modulus of elasticity within the proportional limit.
砌体结构中的一个重要力学参数是弹性模量。
An important mechanic parameter in masonry structure is the modulus of elasticity.
热处理后试样的弹性模量与增强定律十分吻合。
The modulus of CFRPET after heat-treatment agrees perfectly with reinforcement law.
弹性模量是塑性混凝土的一项重要力学性能指标。
The elastic modulus is one important mechanical performance index of plastic concrete.
对于同样外形的材料，刚度与弹性模量是成比例的。
For identical shapes, the stiffness is proportional to the modulus of elasticity.
一个结构的刚度将受到弹性模量和面板厚度的影响。
The stiffness of a structure will be subject to elastic modulus and panel thickness.
当它是适当的使用一个简单的弹性模量为散列函数？
When is it appropriate to use a simple modulus as a hashing function?
一个结构的刚度将受到弹性模量和面板厚度的影响。
The stiffness of a structure will be the elastic modulus and the effects of panel thickness.
作为应用，进而得到弹性模量和损耗模量的标度指数。
As an application, the scaling exponents of elastic modulus and loss modulus are also obtained.
封装结构的模态频率随着灌封胶弹性模量的增大而增大。
The modal frequency of the packaging structure increases with the elastic modulus of potting material.
温度升高，原子热运动加强，屈服强度和弹性模量降低。
The yield strength and elastic modulus will decrease with the temperature increased.
从唯象观点分析了循环变形期间相变应力和弹性模量的变化。
The change of transformation stress and the modulus of elasticity during cyclic deformation was analyzed from the continuum mechanical point of view.
内部大孔也可能饱和而引起内部开裂，导致相对动弹性模量下降。
The larger pores in the interior of specimens may be saturated and lead to cracking, which result in the decrease of relative dynamic elasticity modulus.
研究发现涂层弹性模量与喷涂方向有关，呈现了各向异性的特性。
If was found that the spraying orientation has effect on Young's modulus of coating which takes on the anisotropic property.
之间的关系，应力和应变是线性的，由有关的弹性模量对束材料。
The relationship between stress and strain is linear, related by the Elastic Modulus of the beam material.
艉轴承弹性模量、径向间隙、厚度对接触压力分布有明显的影响。
The contacting pressure of the stern bearing is influenced with its elastic modulus, radial clearance and thickness.
材料的强度是受气孔率、弹性模量、断裂能和临界缺陷尺寸控制的。
The strength of materials are controlled by porosity, modulus of elasticity, fracture energy and critical flaw sizes.
结果表明光纤的编入对材料的拉伸弹性模量和压缩弹性模量影响也较小。
Results show that co-braided optical fibers have just a small quantity of effect on the elastic modulus of the braided composites.
水平方向不均匀土的剪切弹性模量的影响较大而其材料阻尼的影响较小。
It is also found that the effects of thickness and shear modulus of the inhomogeneous soil are significant but the effects of the material damping are not significant.
根据测井资料确定的各种弹性模量值同样适用于解决各种岩石力学问题。
All the elastic modules received from the logging information can be used to solve the problems of rock mechanics.
钛金属弹性模量较低，接近宿主骨的弹性模量，生物相容性较钴镍合金更好。
Titanium has a lower modulus of elasticity-closer to that of host bone-and is more biocompatible than cobalt chrome.
由于CFR P板的弹性模量比钢筋的弹性模量小，加固梁破坏时的挠度仍较大。
Because elastic modulus of CFRP plate are weaker than elastic modulus of steel bar, while strengthening beam is destroyed, the deflection is still strong.
在同一冷冻贮藏时期内空白面团弹性模量最小，添加葡萄糖氧化酶面团弹性模量最大；
However, the storage modulus (G′) was the lowest for control dough and the highest for dough with glucose oxidase for each storage period.
随着应变率的增加，材料的强度及弹性模量有较大程度的提高，但破坏应变有所降低。
The tensile strength of the composites increases with increasing the strain rate, and the failure strain decreases when the strain rate increases.
分析了应变率对混凝土弹性模量、峰值应力时的应变、泊松比和混凝土吸能能力的影响。
The relationships between strain rate and the elastic modulus, critical strain, Poisson's ratio and energy absorption capacity of concrete are still studied.
弹性模量随应力和驱动电压的增大而逐渐增大，但电压升至一定程度时将基本趋于稳定。
Stiffness increase with the increased of compress stress and driven voltage, and became stable when the driven voltage up to some degree.
文中采用的锤击力振动梁测量系统测试动弹性模量快速、简便，并有较高的精度和可信度。
The method for determing the dynamic modulus adopted in the present experiment was found not only simple and convenient, but also highly precise.
由于生物陶瓷材料的弹性模量较小，很难采用添加氧化锆引起的相变增韧来解决上述缺点。
These disadvantages cannot be overcome by addition of tetragonal zirconia resulting in phase transition toughening, because of the low elastic module of the ceramic artificial bone materials.
应用推荐