与漏极开路输出的六反相器。
开路的信号线可能会受到干扰而产生不正确的输出。
Open-circuit signal line may be subject to interference arising from the incorrect output.
如图所示,通过将同轴电缆连接之所有的4个输出端口,则可进行开路校准。
By connecting coax cables to all four output ports as shown, an open-circuit calibration can be performed.
分析得到开路故障不会影响系统输出电压,但会明显影响单逆变器模块电感电流和输出电流。
The result is that open circuit fault does not affect output voltage of the system, but it apparently affects inductance current and output current of single module inverter.
分别采用白炽灯和日光灯作为光源,测量了太阳能电池的伏安特性、开路电压、短路电流、最大输出功率、填充因子、光照特性等基本特性。
Using fluorescent and incandescent as light source, basic features of solar cells such as short circuit current, open voltage, maximum output filling factor and so on were measured.
接收器输入具有失效保护特性,当输入开路时,可确保逻辑高电平输出。
The receiver input has a fail-safe feature that guarantees a logic-high output if the input is open circuit.
发电机的谐波组开路或短路,无三次谐波电压输出,检查绕组接头或拆换绕组。
If no triple overtone voltage, check the winding lug or replace with another winding.
该接收器还支持开路、短路和终止(100)输入故障安全,在所有故障安全条件下,接收器输出为高电平。它采用易于进行PCB布局的直通式设计。
The receiver also supports open, shorted and terminated (100) input fail-safe and receiver output will be HIGH for all fail-safe conditions and it has a flow-through design for easy PCB layout.
集电极开路(晶体管)输出负载可容纳高达100毫安的电流。
An open collector (transistor) output accommodates loads up to 100 mA.
集电极开路(晶体管)输出负载可容纳高达100毫安的电流。
An open collector (transistor) output accommodates loads up to 100 mA.
应用推荐