提出了一个基于开关磁阻电机电感模型的滑动模型观测器来估计电机的位置和速度。
A sliding mode observer is developed to estimate the rotor position and speed of switched reluctance motors (SRM) based on inductance model of SRM in this paper.
这是驱动的155毫米曲柄举行特别米称为开关磁阻电机功率计用于测量电量瓦特，我申请兜售。
It is driven with 155 mm cranks that hold a special meter called an SRM power meter used to measure the amount of power in watts that I am applying to the peddles.
为了实现开关磁阻电机(SRM)绕组电流或磁链的精确控制，必须提高SR M功率变换器的工作频率以提高系统的动态响应速度。
To achieve the precision control of phase current or phase flux linkage in switched reluctance motor (SRM), the higher switching frequency of converter is required to increase dynamic response speed.
主要论述了基于四电平功率变换电路的开关磁阻电机直接瞬时转矩控制。
In this paper, a direct instantaneous torque control (DITC) of switched reluctance motor (SRM) with a four-level converter is presented.
第二，用运动边界法处理相对运动，应用面向对象的程序设计方法，开发了可视化开关磁阻电机电磁场分析软件。
Second, a visual software for SRM electromagnetic field computation is developed by using object oriented programming, in which rotor movement problem is dealt with moving boundary method.
基于开关磁阻电机(SRM)的电感模型，提出了一种新的无位置传感技术。
A sensorless control scheme for switched reluctance motor (SRM) drives based on inductance model was presented in this paper.
由于开关磁阻电机s RM结构及运行原理的特殊性，使得分析和设计较其它电机更为困难。
The analysis and design of switched reluctance motor (SRM) are more difficult than those of other kinds of motors because of its special structure and operation mechanism.
实验结果表明，该控制器及其控制策略是有效的，基于开关磁阻电机的车用IS -AD系统在工程实践上是可行的。
The experimental results indicate that the controller and control strategies are valid, the ISAD system used in vehicle based on SRM is feasible in project practice.
针对开关磁阻电动机运行的振动和噪声问题，在对开关磁阻电机非线性模型进行分析的基础上，将直接转矩控制方法应用到SRM的控制当中。
As to the problems of operating noises and vibrations, this paper applied the Direct Torque control (DTC) technique to SRM's controlling, based on the analysis of the nonlinear model of SRM.
简单介绍应用开关型磁阻电机的固态物料料位探测系统的原理，重点介绍系统的硬件和软件。
The principle of the solid material level measuring system with SRM is briefly introduced and the emphasis is placed on its hardware and software.
仿真结果表明，本文提出的方法很大程度上降低了开关磁阻电机的转矩脉动，低速时的控制效果较高速时更为明显。
The simulation results show that this method can reduce the torque ripple of SRM largely, and the control effect of lower speed is more obvious than higher speed situation.
控制参数对开关磁阻电机振动影响的研究。
最后，介绍了以DSPTMS320F 2812为控制核心的开关磁阻电机实验系统，并利用DSP TMS320F 2812控制板对本文所提方法进行了实验验证。
Finally, the SRM experiment system based on DSP TMS320F2812 as the core of controller is introduced, and the presented method of this paper is also verified in the DSP TMS320F2812 control board.
本文围绕开关磁阻电机的转矩脉动抑制，进行了深入研究。
The torque ripple reduction methods of SRM are further discussed in this paper.
针对有位置传感器的开关磁阻电机驱动系统的启动可能失败的问题，分析了其原因，并给出了解决方法。
It happens that the switch reluctance motor (SRM) driving system with position sensors might fail to start up. In this article, the reasons for such failures are analyzed, followed with a solution.
首先，根据开关磁阻电机的结构和工作原理，建立了SR电动机的数学模型，分析并确定了SR电动机的位置信号检测方法。
Firstly, according to the structure and working principle of SRM, establish its mathematical model, analyze and confirm the position signal detective method of SRM.
开关磁阻电机稳态及动态运行性能的分析研究。
开关磁阻电机稳态及动态运行性能的分析研究。
应用推荐