稳定蠕变应变率本构方程是作用在盐岩上的应力偏量的幂次函数和能量与温度的指数函数。
The steady-state creep strain rate is a power function of deviatoric stress and exponential function of temperature and energy.
ETS个人潜力指数评估的6项个人素质分别包括:“知识与创造力”、“沟通技巧”、“团队合作能力”、“应变能力”、“策划和组织能力”与“道德与诚信度 ”。
The six personal attributes captured by ETS PPI are Knowledge and Creativity; Communication Skills; Teamwork; Resilience; Planning and Organisation; and Ethics and Integrity.
松散岩块的切线模量和割线模量均与轴向应变呈指数相关性。
Both the tangential modulus and secant modulus are exponential with axial strain.
稳定蠕变应变率本构方程是作用在盐岩上的应力偏量的幂次函数和能量与温度的指数函数。
The steady state creep strain rate is a power function of deviatoric stress and exponential function of temperature and energy.
将具有一定应变硬地指数的二维裂纹体在单一载荷作用处的位移分成线弹性部分和塑性部分。
The load point displacement caused by single load for two dimentional cracked body with certain strain hardening exponent is divided into its linear-elastic and plastic components.
这就从试验上判明,即使在相同的应力状态下,应变速率敏感性指数也与变形路径密切相关。
These prove that the strain-rate sensitivity index depends tightly on the deformation route from experiment, even on the condition that those stress-state are similar.
利用本文建立的指数衰减模型能够较好地描述材料的非线性塑性应变幅与寿命之间的关系。
A new exponential dissipation model is presented to describe this bilinear material's plastic strain amplitude-fatigue life relation.
如何选模由加工硬化指数和平均应变比例所决定。
How sell the metal forms will be governed by the strain-hardening exponent and average strain ratio.
用修定的RMR岩体量化指数从给定公式中确定岩体强度和应变参数。
The formulas for obtaining strength and strain parameters of rock mass are described using modified index RMR of rock mass quality.
通过量级分析,给出了尖端场的应力应变奇异性指数。
The stress and strain singularity exponent of crack-tip field is given by means of the asymptotic analysis.
材料的应变速率敏感性指数与孔洞长大速率通过不同的变形机理图控制着这种过程。
It is controlled by the sensitive index of the strain rate and the cavity growth rate of material.
随着应变时效温度升高,强度和硬度增加,塑性和韧性下降,屈强比呈升高的趋势,形变强化指数降低。
With the strain aging temperature increasing, strength and hardness increases, plasticity and toughness decreases, yield ratio has the ascending trend, hardening index decreases.
文章对含i型裂纹的正交各向异性功能梯度材料板沿其板厚的弹性常数表达式呈指数函数变化时的应力-应变场进行分析。
In this article, the fracture analysis on mode I crack of orthotropic functionally gradient materials is studied, under which the elastic constants changed exponentially along thickness of the plate.
结果表明,复合材料在高温下的流变应力较低,峰值应力与变形温度、应变速率之间的关系在低应力区符合指数关系。
The results show that, the flow stress of SiCP/AZ61 composite is low, the relationship between peak stress and temperature or strain rate is exponential relationship.
基于压痕做功概念定义了压痕蠕变硬度和蠕变应变速率,从而给出钎料的蠕变速率敏感指数。
The creep strain rate sensitivity can be determined from the relationship between the creep hardness and creep strain rate by the definition of "work of indentation".
塑性应变比与应变硬化指数是评价板料成形性能的两个重要参数。
Thirdly, plastic strain ratio and strain hardening index are the two key parameters of material's formability.
随着变形温度的提高,该合金的应变速率敏感指数值变化很小。
The strain rate sensitivity exponent increases little with increasing deformation temperature.
采用指数模型拟合城市固体垃圾的应力-应变等时曲线,并取得了很好的拟合效果,模型参数简单易求,可反映城市固体垃圾压缩性的大小及其压缩机制。
An exponential model is proposed to fit the stress-strain-time curve and obtaining good fitting effect. Parameters of this model are easy to get and can reflect the compressibility and its mechanism.
屈服强度、抗拉强度、加工硬化指数和塑性应变比厚向各向异性降低,塑性应变比平面各向异性增大;
Yield strength and ultimate tensile strength, work hardening exponent and normal anisotropy of plastic strain ratio decrease but planner anisotropy of plastic strain ratio increases.
相对于常规奥氏体轧制,铁素体轧制薄板的屈服强度下降了20%左右,伸长率及应变硬化指数与之相当。
Compared with the strip produced by conventional austenite rolling, the yield strength of the ferrite rolled strip was lower by about 20%, with same elongation and strain hardening exponent.
在循环加、卸载孔隙水压力作用下,残余应变与循环次数的关系符合乘幂负指数关系。
The relationship between the residual strain and cyclic Numbers accords with the power of negative index under the cyclic loading and unloading pore water pressures.
相同轴压下,冲击强度会随着应变率的增加而增加,呈现指数函数关系。
When the axial static pre-stress is a constant, the impact compressive strength increases with an exponential function as the strain rate increases.
进行三种ST钢的应变硬化指数n值试验,分析试验结果,研究n值在整个应变区间的变化趋势。
This paper has studied the changes about tensile strain hardening exponent (n-value) in three kinds of st steels by testing n-values and found changing tendency of them.
进行三种ST钢的应变硬化指数n值试验,分析试验结果,研究n值在整个应变区间的变化趋势。
This paper has studied the changes about tensile strain hardening exponent (n-value) in three kinds of st steels by testing n-values and found changing tendency of them.
应用推荐