每种颜色的全职场应力模式对应一个狭义界定应力范围。
Each color of the full-field stress pattern corresponds to a narrowly defined stress range.
结果表明：在同一温度下，应变速率不同，材料的流变应力模式不同；
The results show that the model of deformation resisitance is different at the same deformation temperature and the different stain rate.
在利用能量协调条件构造应力模式时，最后的应力模式中含有矩阵的逆。
When the stress mode is constructed by energy compatibility condition, the last stress mode involves the inverse matrix.
本文讨论温度及湿度对不同应力模式下低密度聚乙烯(LDPE)薄膜电强度的影响。
The present paper discusses the effect of temperature and humidity on the electric strength of low-density polyethylene (LDPE) film for various stressing modes.
抛弃任何有关位移或应力模式的人为假设，在轴对称情况下导出正交异性体的状态方程。
Discarding any assumptions about displacement models and stress distribution, the state equation is established for the axially symmetric problem of orthotropy.
利用组合杂交有限元法得到了一个四节点轴对称元，并采用协调等参双线性位移来逼近及分片常数应力模式。
A 4-node axisymmetric solid element is derived by combined hybrid methods. Compatible isoparametric bilinear displacement approximations and the constant stress mode are employed.
本文论及针对这种试板，调用ADINA程序进行弹塑性有限元分析，平面应力模式下的计算结果与实际测试结果十分接近。
This paper deals with computation of elastic Plastic F. e. m. for this centre cracked plate by ADINA Program. The computing result for this plate of plane stress model and test result were very close.
本文论及针对这种试板，调用ADINA程序进行弹塑性有限元分析，平面应力模式下的计算结果与实际测试结果十分接近。
This paper deals with computation of elastic Plastic F. E. m. for this centre cracked plate by ADINA Program. The computing result for this plate of plane stress model and test result were...
用该方法代替FDS软件中的亚格子应力模式构造的DES求解器被用来对湍流强迫对流问题和单室火灾问题进行数值模拟。
The FDS software package was used as the numerical framework for the DES solver, which was then used to simulate a typical forced convection problem.
我们讨论了工程中应用广泛的杂交应力有限元方法的应力模式优化问题，设计出了最佳应力模式和迄今最优的高性能的杂交元。
We have discussed optimization of stress modes of hybrid stress finite element methods and proposed an optimal stress mode and a hybrid element of excellent performance.
本文在位移元本征应力模式基础上引进调节参数，同时，利用矩阵H对角化方法计算杂交元应力子空间的本征应力模式，然后由此方便有效地计算特征值，从而大大提高了计算效率。
The parameters are introduced based on the natural stress modes of the displacement element, and the method of matrix H diagonalization was introduced to improve the calculation of the natural.
有人认为这一系列相对来说规模较小的地震是潜没地带为适应04年地震之后形成的应力分布模式自身调节的结果。但是一些研究人员却对此持怀疑态度。
Some researchers say they suspect that the series of somewhat weaker quakes represents the subduction zone readjusting itself to changes in stress patterns established by the '04 quake.
建立了粘结应力沿锚固长度的分布模式。
The distribution model of bond stress over the splice length is developed.
明确加固梁具有两种不同破坏模式，其破坏是由钢板端部的主应力大小决定的。
Two different kinds of failure patterns have been observed and the failure of strengthened beam is attributed to the principal stress at the end of steel plate.
莫尔-库仑模式基于莫尔圆来判断最大和最小主应力平面上的破坏应力状态。
The Mohr-Coulomb model is based on plotting Mohr's circle for states of stress at failure in the plane of the maximum and minimum principal stresses.
其次，采用上述计算的海面风应力作为POM模式的驱动，研究了南海流场和温度对于台风的响应。
Then, the response of the SCS to Typhoon Imbudo is examined using POM model, which is driven by the wind stress calculated above by the wave model.
根据界面处位移与应力的连续条件，确定了未知弹性波模式系数。
The unknown mode coefficients of elastic waves are determined by means of the continuous conditions of displacement and stress on the boundary of the interfaces.
研究结果表明小尺度参数和屈曲模式对碳纳米管屈曲应力的影响是相互关联的。
Results denote that effect of the buckling modes and the small scalar size on the buckling stress is interrelation.
对于加筋板中筋的侧倾失稳，则通过能量法推导加强筋侧倾失稳时的总势能泛函，利用最小势能原理求解出此失稳模式下的临界应力。
In the analysis of the elastic tripping of the stiffener, the critical stress under this mode of failure is derived by using the energy method and the principle of least potential energy.
本文着重介绍板件的相关屈曲和计算截面畸变屈曲应力的方法并阐述了三种屈曲模式之间的相关关系。
This paper emphasizes the interaction of plate local buckling, the calculation of section distortional buckling stresses and the interaction of three buckling modes.
抛弃任何有关应力或位移模式的人为假设，在轴对称情况下，对强厚度叠层闭口柱壳建立其状态方程。
Giving up any assumptions about displacement models and stress distribution, the state equation for the axisymmetric problems of thick closed laminated cylindrical shells is established.
本文还给出了由应力导致相位各向异性对模式偏振性影响的实验结果。
The effects of the phase anisotropy on mode polarization by stress is investigated.
温度循环是环境应力筛选中最常用、最有效的筛选模式。
Thermal cycle is the most usual and the most efficient screening mode of ESS.
利用有限元法计算内外壳体的应力，按照串联模式进行旋转密封总成整体可靠度计算。
Finally, after computing the maximum stresses of the inner housing and outer housing with FEM, the total reliability of rotary sealing assembly is calculated according to serial pattern.
从而进一步确定我国某一地区的温度场梯度模式，以及这一温度模式对结构的应力和挠度的影响。
Then I can further make sure the temperature mode and its effect on the stress and line deformation in one region of our country.
研究内容包括：粘结破坏模式、破坏机理、粘结性能影响因素、粘结剪应力—滑移关系等。
This paper focuses on bond failure modes, failure mechanics, factors influencing bond behavior, bond shear stress-slip relationship.
节点局部构造尤其是焊接孔形状尺寸对于节点应力集中情况和节点破坏模式有很大影响。
Weld access hole geometry and size have significant effect on ductility and failure mode of the connection.
本文从平面应力场理论分析入手，介绍了简单褶皱的力学模式、复合构造模式，并进行了构造裂缝的理论分析。
Starting from analyzing the theory of plane stress field, the paper introduced mechanical mode for simple fold and composite structural mode and analyzed the theory of structural fracture.
该模型综合了变形、能量累积以及荷载历程对预应力混凝土构件损伤-破坏的影响，对不同的地震模式有更好的适用性。
This model synthesizes the effect of distortion, energy accumulation, and loading history to damage-failure of prestressed concrete member, thus may be applied to different earthquake patterns.
该模型综合了变形、能量累积以及荷载历程对预应力混凝土构件损伤-破坏的影响，对不同的地震模式有更好的适用性。
This model synthesizes the effect of distortion, energy accumulation, and loading history to damage-failure of prestressed concrete member, thus may be applied to different earthquake patterns.
应用推荐