目前通用的是基于并联模型的归一化处理方法。
The conventional normalisation approach is based on parallel sensor model.
提出了地球大气太阳能—风能转换的双热机并联模型。
The twin engine model for the wind system of the earths atmosphere is presented.
建立适合两布一膜的蠕变模型：六元件并联模型和六元件串联模型。
Second, establishing two models which can simulate creep characteristic of composite geomembranes: model of six elements paralleling connection and model of six elements in series.
用串并联模型框架对军用航空综合体进行效能评估，具有简单实用的特点。
It has simple and practical characteristics to evaluate the effectiveness of the air force aero-complex generally based on the series-parallel connection models frame.
并联模型为常用的归一化模型，其归一化电容值与测量电容值为线性关系。
Parallel normalization model is commonly used during normalization process, which assumes the distribution of materials in parallel.
在此基础上分析了操作臂的运动学和静力学关系，建立了并联柔性系统的动力学模型。
Then, the kinematics and statics of the manipulator are studied, and a dynamic model of this parallel flexible system is established.
理想PV电池的模型可以表示为一个感光电流源并联一个二极管。
An ideal PV cell can be modeled as a light-induced current source in parallel with a diode.
建立标定模型，用逆向运动学标定方式模拟了一新型五轴并联机床的标定过程，结果表明这种标定方法的算法收敛快、鲁棒性好。
After establishing the model for the calibration of a novel five-axis parallel machine tool, the process of calibration is simulated by minimizing inverse kinematic residuals.
推导出了刀位轨迹算法和切削行距算法，建立了面向新型并联机床的CAM系统框架模型。
Algorithms for tool path calculation and cutter path interval calculation are derived. Frame model for CAM system of PMTs is established.
研究了ZIP负荷模型与感应电动机相并联的综合负荷模型参数的简化辨识策略。
The simplified identification strategy for parameters of composite load model constituted by ZIP load model in parallel with asynchronous motor is researched.
通过APDL语言实现有限元模型的参数化设计，计算出并联机床在工作空间内的刚度分布。
The FEA model was parameterized by APDL language and the stiffness distribution was computed over the workspace.
在分析工艺机理的基础上，用PLS- RBFN并联方法建立延迟焦化粗汽油干点软测量模型。
On the basis of analysis of the process mechanism, the model for soft measurement of the dry-point of crude gasoline delayed coking is established by using PLS-RBFN parallel method.
本文在分析有源滤波器基本原理的基础上建立了并联型有源滤波器的数学模型。
This paper proposes the mathematical model of shunt active power filter (APF) on the basis of the principle of APF.
实验结果表明，采用并联电阻模型计算混合液电阻率有时会带来较大的误差。
The experiments show that sometimes serious errors could be caused by using parallel resistor model during calculating resistivity of mixing solution.
针对给定条件的并联系统建立了系统可靠度与系统费用的模糊综合优化模型。
The comprehensive optimization model for system reliability and system cost was set up for a parallel system under given conditions.
对模型求解中涉及到的并联输水管管径的选定和流量分配问题作了探讨，推导了连接管设置间距计算式。
It also discussed the diameter selection and flow distribution of the parallel conduits concerned in solving the model, and derived a formula for the distance between link pipes.
对此，作者从机构学的角度出发，对实验用并联机床模型的主机构模块进行了较详细的初步研究与分析。
For this purpose, the author has given more detailed and thorough study of main mechanism module of experimental parallel machine tool model for the viewpoint of mechanism.
此外，还分别建立了串—并联和并—串联两种余度设计系统的最少研制费用模型。
Moreover, the least development cost models for the series-parallel and the parallel-series redundancy design are established.
文章介绍了大系统分解协调理论，建立了串联、并联库群水库防洪优化调度模型。
The paper introduces the large system decomposition coordination theory, establishes the reservoir flood control optimization operation model of series and parallel connection reservoirs group.
根据这两个子系统间存在的双边耦合关系，建立6自由度并联机器人操作空间整体动力学模型。
According to a bilateral coupling between the two subsystems, the integrated dynamic model of 6-dof parallel robot is set up in operating-space.
本文建立了求解并联机构动力学方程的模糊神经网络模型。
The fuzzy neural network model for dynamic equation of the PMT is established.
建立了可重复使用运载器金属热防护系统瞬态热分析的并联一维模型。
A parallel one-dimensional model for transient thermal analysis of the metallic thermal protection system (MTPS) for reusable launch vehicle (RLV) is established.
传统铁道客车模型一般是弹簧、阻尼器并联的形式。
In traditional vehicle model, spring and damper are usually parallelly arranged.
本文还特别研究了多自由度绳牵引并联机构的静力学模型的求解，提出了两种计算方法。
Specially, the statics model of the wire-driven parallel mechanism of more than two DOFs is studied and two methods for the solution are presented.
针对光伏电池研究了基于物理机制的数学模型，分析了串联电阻和并联电阻对光伏电池特性的影响。
In this paper, math model is studied based on physics theory of PV cell, and the influence of series resistor Rs and parallel resistor Rsh on PV cell characteristic is analyzed.
用牛顿—欧拉方法建立了6PUS并联机构的动力学模型。
The rigid body dynamics model of the 6-PUS parallel mechanism is presented based on Newton-Euler method.
用牛顿—欧拉方法建立了6PUS并联机构的动力学模型。
The rigid body dynamics model of the 6-PUS parallel mechanism is presented based on Newton-Euler method.
应用推荐